A simple,rapid and sensitive method based on modified multiwalled carbon nanotube for preconcentration and determination of lead ions in aqueous media in natural pHs

In this study, multiwalled carbon nanotube (MWCNT) was modified by the pyridine group using a silane agent and characterized by infrared spectroscopy (IR), thermal analysis (TG/DTA), and elemental analysis (CHN) and scanning electron microscopy (SEM). The application of this sorbent was investigated in determination of lead ions in aqueous samples, using flame atomic absorption spectrometry (FAAS). Through this study, different parameters such as pH and sample flow rate on adsorption process and eluent concentration, volume and flow rate were optimized. The limit of detection (LOD), the relative standard deviation and the recovery of the method were 2 ng mL^?1, 1.3% and 99.7%, respectively. Two standard reference materials (NIST 1571 and NIST 1572) were used to verify accuracy of this method. Finally, the sorbent was successfully applied for extraction and determination of low levels of Pb(II) ions in aqueous samples.     

原子吸收光谱法测定铝锂合金中锂

本文研究了用原子吸收光谱法在笑气－乙炔火焰中测定铝锂合金中锂的最佳条件。其电离干扰可通过加进钾进盐来控制。应用本法测定合金中 锂的含量，获得了满意结果。     

离子交换富集-导数火焰原子吸收法测定自来水中Cu,Fe和Zn

本文研究了用 2 0 1× 7阳离子交换树脂对自来水中的微量元素进行交换富集 ,采用微量脉冲进样 导数火焰原子吸收法测定富集后溶液中的Cu ,Fe和Zn ,该方法灵敏度分别为 0 2 9,0 5 9和 0 0 6 μg·L- 1 ,精密度分别为 4 2 8% ,1 95 %和 2 2 8% ,检测限分别为 1 2 8,5 85和 0 6 8μg·L- 1 ,回收率分别为 91 13% ,10 1 34%和99 84 % ,本方法大大减少了需样量 ,简便快速 ,灵敏度高。     

Atomic distributions in acetylene-air flame using hydraulic high-pressure nebulization with direct (100%) introduction of solutions Applications to speciation analysis

One of the fundamental factors of the performance of atomic spectrometric methods is the efficiency of sample introduction into flame or plasma. By utilization of the formerly developed hydraulic high-pressure nebulizer, a nebulizer/burner system with solution uptake efficiency of 100% have been worked out. Optimizing operation parameters of nebulizer/burner system, an improvement of 2-12 times was achieved for the signal-to-noise ratio in the flame emission and flame atomic absorption spectrometry, depending on sample flow rate. This nebulizer is especially suitable for development of liquid chromatography-AAS/FES coupled technique for speciation analytical tasks.     

火焰原子吸收光谱法测定钴-镍合金镀层中的钴和镍

利用原子吸收光谱法研究了在氨基磺酸钴-镍镀液中，赫尔槽试片上不同电流密度区合金镀层中钴、镍的含量。实验表明，该方法简便，快捷，结果准确，精密度高。相对标准偏差（RSD）为0.30%-0.62%，加标回收率为97.0%-104.0%。     

火焰原子吸收法测定霞石中的氧化钾和氧化钠

本方法用于测定霞石中的钾、钠，主要通过在溶样时加入氢氟酸除去二氧化硅，调整溶液中钾、钠的含量，消除互相之间的干扰，加入氯化铯消除电离因素的干扰，提高了分析结果的准确性和重现性，使测定结果更接近化学分析值。回收率为99．2％-101．6％。     

Simulation of a turbulent premixed open V-shaped flame using contour advection with surgery

Despite its capability of high spatial resolution, simulation of turbulent flows with traditional Lagrangian (front tracking) scheme is often discouraged by numerical instability caused by clustering of marker nodes and topological changes of fronts. Contour advection surgery (CAS), being a robust front tracking scheme, can limit the growth of front complexity during simulation without jeopardizing accuracy or efficiency. This allows it to open up an advantage over traditional front-tracking schemes. It has already been demonstrated that CAS, with incorporation of the reaction sheet model, can accurately simulate the propagation and advection of a turbulent premixed V-shaped flame. In this study, it is further tested with 10 values of vortex circulation. A range of upstream turbulence levels of 1.8–19.8% was obtained. Results indicate that upstream turbulence increase the average flame length, flame zone area and the overall burning rate. Flame surface density Σ was also estimated. Maximum values of Σ obtained lie in the range 0.1–1.4 mm⁻¹. Skewness towards the burnt region was observed in all profiles of Σ. Similar to results from laboratory experiments, it was found that Σ values decreases with upstream turbulence. From this study, the ability of CAS to cope with intense turbulence is demonstrated and a better quantitative understanding on the scheme has also been acquired.     

The thermolysis of dicarbonylcyclopentadienyliron dimer: The formation of biferrocene

The thermolysis of dicarbonylcyclopentadienyliron dimer in a sealed tube at 300°C has been reported to produce ferrocene, carbon monoxide, carbon dioxide, cyclopentadiene and elemental iron. We observe in addition to these products the production of biferrocene and elemental carbon. Thermolysis of carbonylcyclopentadienyliron tetramer (produced from the dimer by thermolysis in refluxing xylene) produces ferrocene, iron and carbon monoxidre; no biferrocene, carbon dioxide or elemental carbon are produced. A scheme is proposed to account for these products.     

Determination of the boiling point distribution of sulfur compounds in light cycle oil using GC with a flame photometric detector and pyrolyzer

A method has been developed to determine the boiling point distribution of sulfur compounds in light cycle oils (LCO'S). The method chosen for this analysis was GC with a flame photometric detector (FPD) and pyrolyzer. Tests were carried out to evaluate the recovery efficiency, repeatability, and accuracy of the method. Repeatabilities within 2% were obtained. The recovery of benzothiophenes and dibenzothiophenes was close to 100%; this was important because these are the major sulfur components in LCO's. No hydrocarbon or solvent interferences were observed with the use of the pyrolyzer, even for a 95% solvent level. Comparison with results from other techniques showed that the method accurately determined the levels of sulfur compounds in the LCO boiling point range.     

The preparation and structure of 1,4,5,6,7,7-hexachloro-2-endo-ferrocenylhydroxymethyl-3-endo-hydroxymethyl-5-norbornene

The crystal structure of a novel ferrocene derivative with potential flame-retardant/smoke-suppressant activity, 1,4,5,6,7,7-hexachloro-2-endo-ferrocenyl-hydroxymethyl-3-endo-hydroxymethyl-5-norbornene, has been determined. Some of the carbon–carbon bonds within the chlorendic residue are unusually long, and there is no interaction between the hydroxyl groups and the iron atom. There is evidence of intramolecular hydrogen bonding between the two hydroxyl groups.