共查询到20条相似文献,搜索用时 109 毫秒
1.
2.
3.
内窥镜图像测量中为了保证测量精度,理论上要求成像系统的光轴与物平面保持垂直,而实际测量过程中光轴与物平面一般存在一定程度的垂直倾斜。针对垂直倾斜对内窥镜图像测量的影响,提出了一种基于内窥镜发射的线定标光的垂直倾斜校正方法。该方法从线定标光的位置信息中提取光轴倾斜信息,并对图像进行校正。实验结果表明,所提出的图像垂直倾斜校正方法能对内窥镜图像进行准确校正。 相似文献
4.
5.
探索了一种新型低成本的基于激光光束反射原理的全光纤速度传感器,并组成了弹丸速度测量系统。AFOBR测速系统的工作原理如图l所示。半导体激光器发出的激光通过光纤引导照射在被测物体的表面并经物体表面反射,部分反射光反射回同一根光纤并传送到光电探测器上产生光电流,光电流的大小与反射光的强度基本成正比,而反射光强是光纤端面到物体表面距离和物体表面反射率的函数。当子弹到达测量区域时,子弹外径尺寸和弹体材料反射率变化引起光电探测器输出信号的变化,在不同的位置布置同样的光纤传感器,即可进行速度测量。 相似文献
6.
介绍了利用价格便宜的普通视频CCD来获取紫外激光和软X射线图像的方法和应用结果,以代替价格昂贵的紫外CCD、使用不方便的X光胶片或者昂贵的X光CCD,其关键点是:(1)去除CCD相机的自动增益校正;(2)将相机的校正系数γ值设置为1;(3)去除CCD相机前面的保护窗。作为一种简易的装置,可以用于紫外激光测量及激光与等离子体相互作用研究。结果表明,采用改造后的普通视频CCD测量紫外激光光斑,准确可靠,其灵敏度比科学级紫外CCD的低一个量级,它还可以测量软X射线的二维分布,作为X光针孔相机使用非常方便。 相似文献
7.
8.
光动力治疗中热效应的理论分析与计算 总被引:4,自引:3,他引:1
基于Pennes传热方程,从理论上分析了光动力治疗中激光作用所引起的组织温升的变化.结果表明,激光照射在生物组织内形成热源,该热源在一维生物组织空间引起组织的温升一般随时间呈指数形式增大,随激光照射处的距离呈指数减少.激光照射生物组织产生热效应,存在一个最小阈值光剂量,仅当照射的激光剂量大于阈值光剂量时,才能产生热效应.阈值光剂量大小由生物组织的光学参量和热物性参量决定,并随激光照射处的距离呈指数增加 相似文献
9.
为研究探测器在单色光照射下大动态范围的辐射响应度是否不变,建立了基于激光的线性测量装置,并对该装置的测量不确定度进行评价。实验根据双光路叠加法,分别采用功率和照度两种模式研究了光电探测器的线性。对于功率模式,实验测量了6个数量级光功率变化下探测器的大动态范围非线性系数;对于照度模式,将激光导入积分球输出光辐射,测量了探测器在3个量级变化下的非线性系数。实验结果表明:当激光功率模式下探测器的输出电流从0.2 mA变至0.2 nA,探测器的非线性系数全部小于±0.02%;当激光照度模式下探测器光电流从200 nA变为0.2 nA,探测器非线性系数小于±0.02%。由此可知,激光线性装置可以实现功率和照度两种模式测量,满足至少6个量级以上的测量。 相似文献
10.
(一)引言激光是一种时间相干性与空间相干性都很好的光.因此,用此种光照射物体可以获得清晰的衍射图样.若在物体后放置一透镜,则在透镜焦面上得到的便是夫琅和费衍射图样即付里叶频谱,如图1所示.每一频谱与物体的某一空间频率相应,即相应于物体的某一信息.这些频谱在像面上重新组合,便复现原物的像.这就是相干成像的机制.但如果照射的光不是相干光,而 相似文献
11.
An original non-contact measurement method using multiple line-structured laser sensors is introduced for seamless steel pipe straightness error is in this paper. An arc appears on the surface of the measured seamless steel pipe against a line-structured laser source. After the image of the arc is accepted by a CCD camera, the coordinates of the center of the pipe cross-section circle containing the arc can be worked out through a certain algorithm. Similarly, multiple line-structured laser sensors are equipped parallel to the pipe. The straightness error of the seamless steel pipe, therefore, can be inferred from the coordinates of multiple cross-section centers obtained from every line-structured laser sernsor . 相似文献
12.
设计并开发了光纤扫描式激光光斑测量仪。光纤探头采用逐行扫描的方式对激光光斑进行扫描,采集的光信号经能量转换、数据采集,最终传输到电脑,再由软件绘制出光斑图像。针对于大口径、脉冲激光光斑的测量提出了一种快速扫描的方案,并在此基础上计算分析了仪器的测量精度和测量时间这两个重要参数。与CCD摄像法进行了对比实验研究,结果表明:相对于CCD摄像法会受到接收屏的散射及成像系统误差带来的影响;此设备采用直接测量的手段,能够更加准确地获得光斑的实际尺寸以及光斑能量的空间分布。应用该仪器成功地进行了聚焦光束传输质量的测量。 相似文献
13.
轨道板的外形尺寸精度对于保证高速铁路轨道质量起着至关重要的作用,针对现有轨道板检测方法存在的问题,本文建立了一种基于线结构光传感器的轨道板测量系统并提出了基于轨道板点云数据的几何参数测量方法。线结构光传感器按照固定间隔扫描CRTS III型轨道板,获得点云数据;利用轨道板中特殊位置点云数据对整个点云数据进行位置和姿态的校正;最后根据特征参数定义,实现轨道板四项关键几何参数的快速非接触测量。实验结果表明,本文提出的测量方法测量精度可达0.2 mm,满足轨道板的在线检测要求 相似文献
14.
Qing-bin Tong Bao-zhu Han De-li Wang Jian-qiang Wang Zhen-liang Ding Feng Yuan 《Journal of Russian Laser Research》2014,35(3):307-316
Based on the theory of laser measurements, we propose a novel laser-based automatic inspection system for measuring the internal thread parameters, which integrates the laser-based measuring unit to detect the longitudinal section of the thread profile and the dual-axis moving stage for the movement of an undetected object. We design a special laser probe based on the bidirectional inclination scanning method for obtaining the thread-profile data. This method and structural design enables the laser probe to overcome the shortcomings of traditional methods for measuring large inclined surfaces and eliminate the impact of the lead angle. We compare our results of internal thread-parameter measurements with the coordinate measuring machine (CMM) system and investigate the repeatability with one internal screw ring gage by the system proposed. The experimental results show that the measurement accuracy of the thread angle is 2′ and the other parameters are less than 4 μm. 相似文献
15.
16.
17.
In this paper, a successful application of line-structured laser sensor, involved in SMIC chip lead coplanarity measurement, is presented. With the experimental measurement system and its corresponding mathematics model, a contact-datum-plane assessment of SMIC chip lead coplanarity is developed to provide method for on-line measurement. 相似文献
18.
19.
全光纤光子多普勒速度测量(PDV)系统是一种新型的激光测速系统,可广泛用于冲击波、爆轰波以及其他短时高速运动物体的速度测量。多点测量可以获得靶面不同位置的速度,以测量靶面的形变。为提高测量的空间分辨率,提出使用裸光纤束为PDV系统的探头,并在实验上实现了空间分辨率为375μm的双点速度测量。裸光纤探头的间距较小,一个探头的测量结果可能受到另一个探头反射光的干扰。理论和实验的研究结果表明,当靶面各点速度相同时,测量结果不受干扰光的影响;当各点速度不同时,其测速误差不但与两被测点的速度差有关,还与传感光和干扰光的光强和相位有关。 相似文献
20.
A method is described for measuring the light pressure and energy of a laser pulse. The method is based on a transformation of the kinetic energy acquired by a suspended object from the laser pulse into the potential energy of a twisted elastic filament. Comparative measurements are made of the energy radiated by a pulsed ruby laser ( = 6943 Å) by a calorimetric method and by a method based on measurement of the light pressure. This latter method essentially eliminates the influence of the radiometric effect on the measured results. It permits a quite accurate measurement of the light pressure and energy of a laser pulse at pressures of the order of 10–5 torr and below.Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, Vol.12, No. 6, pp. 48–54, June, 1969. 相似文献