光电延迟反馈系统几种混沌路径的仿真分析

对非线性光电延迟反馈系统的响应时间序列进行数值分析.模型反馈循环中加入带通滤波器,建立非线性光电延迟反馈系统的数学模型.用龙格-库塔数值分析方法,通过调节参数,发现两种产生混沌信号的路径.设置特定φ时,在低反馈增益情况下,系统输出快速方波信号或慢速周期震荡信号,随着反馈增益的增加,系统输出出现复杂周期信号或混沌breather现象;在高反馈增益时,系统输出从不同的动力特性变成混沌状态.     

Active feedback stabilization of toroidal external modes in tokamaks

Active feedback stabilization of pressure-driven modes in tokamaks is investigated by toroidal computations. Typically, the feedback does not strongly modify the plasma-generated magnetic field perturbation. Feedback with modest gain and a single coil array poloidally stabilizes substantially for a range of coil shapes. Optimum design uses narrow sensor coils not too far from the plasma and rather wide feedback coils, which may be outside the resistive wall. Complex gain, which makes the mode rotate, can decrease the gain required for stabilization, but real gain is more robust.     

Gain Characterization of All-Optical Gain-Clamped PDFFA for WDM Networks Using the Feedback Theory

Using feedback theory, we analyze the gain of an all-optical gain-clamped praseodymium-doped fluoride fiber amplifier (AOGC PDFFA) for eight-channel multiwavelength operation. We demonstrate by numerical simulation that gain stabilization is achieved when the open-loop gain is higher than the feedback path attenuation. If this condition is fulfilled, the gain stabilizes to a value equal to the feedback path attenuation and is not influenced by the pump power, input signal power, number of channels, doped fiber length, or any other doped fiber parameter. In our setup the AOGC PDFFA noise figure is 0.12 dB lower than the open-loop PDFFA noise figure.     

Identification and suppression of the time delay signature of wavelength chaos

Time delay is one of the most important physical parameters in a nonlinear time-delay feedback system. In this paper, we numerically investigate the identification and suppression of the time-delay signature (TDS) of the wavelength chaos by numerical simulations. The autocorrelation function (ACF) and average mutual information (AMI) act as the TDS measures. Especially, the effect of the feedback gain and the initial phase on the TDS is analyzed in detail. The wavelength chaotic nonlinear system undergoes a period-doubling route-to-chaos as the feedback gain is increased. The ACF and/or AMI peaks located at the time delay decrease gradually with increasing the feedback gain. Of interest is that these peaks are kept at a low value when the feedback gain is greater than 15, which indicates the suppression of TDS. The initial phase, however, shows a little effect on the time-delay signature. These results pave the way for optimizing the wavelength chaos by appropriately choosing the control parameters of the nonlinear system.     

Coherence and stochastic resonance in a delayed bistable system

Both coherence resonance (CR) and stochastic resonance (SR) in a delayed bistable system driven by additive and multiplicative white noises and a weak harmonic excitation are studied by using the theory of two-state model. For the weak noise intensity and delayed feedback, the analytic expressions of power-spectrum and linear-spectrum amplification are derived to quantify the CR and the SR, respectively. The study shows that the peak in the power spectrum at the frequency corresponding to the time delay attains the maximum for an appropriate amount of additive noise intensity and the CR manifests. The feedback gain plays an important role in the SR. For example, the positive feedback gain enhances the SR, but the negative feedback gain suppresses the system output and makes the SR disappear. Moreover, the system also exhibits the frequency SR.     

Adaptive tuning of feedback gain in time-delayed feedback control

We demonstrate that time-delayed feedback control can be improved by adaptively tuning the feedback gain. This adaptive controller is applied to the stabilization of an unstable fixed point and an unstable periodic orbit embedded in a chaotic attractor. The adaptation algorithm is constructed using the speed-gradient method of control theory. Our computer simulations show that the adaptation algorithm can find an appropriate value of the feedback gain for single and multiple delays. Furthermore, we show that our method is robust to noise and different initial conditions.     

Performance characteristics of positive and negative delayed feedback on chaotic dynamics of directly modulated InGaAsP semiconductor lasers

The chaotic dynamics of directly modulated semiconductor lasers with delayed optoelectronic feedback is studied numerically. The effects of positive and negative delayed optoelectronic feedback in producing chaotic outputs from such lasers with nonlinear gain reduction in its optimum value range is investigated using bifurcation diagrams. The results are confirmed by calculating the Lyapunov exponents. A negative delayed optoelectronic feedback configuration is found to be more effective in inducing chaotic dynamics to such systems with nonlinear gain reduction factor in the practical value range.      

Adaptive feedback cancellation in hearing aids with clipping in the feedback path

Adaptive linear filtering algorithms are commonly used to cancel feedback in hearing aids. The use of these algorithms is based on the assumption that the feedback path is linear, so nonlinearities in the feedback path may affect performance. This study investigated the effect on feedback canceller performance of clipping of the feedback signal arriving at the microphone, as well as the benefit of applying identical clipping to the cancellation signal so that the cancellation path modeled the nonlinearity of the feedback path. Feedback signal clipping limited the amount of added stable gain that the feedback canceller could provide, and caused misadjustment in response to high-level inputs, by biasing adaptive filter coefficients toward lower magnitudes. Cancellation signal clipping mitigated these negative effects, permitting higher amounts of added stable gain and less misadjustment in response to high-level inputs, but the benefit was reduced in the presence of the highest-level inputs.     

用静电探针反馈控制KT—5C托卡马克边缘湍流

在ＫＴ－５Ｃ托卡马克上，利用两组边缘静电探针分析作为控制探针和探测探针进行了反馈控制边缘湍流的实验，在适当的回路增益下的，当系统相移为９０°时，反馈使湍动幅度明显地抑制，电子密度和电子温度扰劝均降低了约２５％，横向粒子输运通量也相应地降低了２５％，而相移为０°，１８０°和－９０°的反馈却使湍动幅度增强，这显示反馈是基于一种非线性机制而作用于湍动的，在一定意义上，这正体现了湍流本身的非线性特征。     

光纤喇曼放大泵浦光与信号光的关联研究

分析了信号光入射后可能发生的效应基于电磁场理论,综合光纤受激喇曼散射(SRS)效应、建立了光纤喇曼放大泵浦光与斯托克斯光、信号光的关联方程,给出了系统增益形成正反馈条件的表达式,结果表明:在光纤参量满足增益正反馈的条件下,当SRS增益对应于非饱和增益工作状态时入射信号光得到放大,SRS增益愈高则放大倍数愈高,并有区段上SRS增益相对低时其关联程度相对高.     

Optimizing the performance of single-mode laser diode system using genetic algorithm

In this correspondence, micro-genetic algorithm (MGA) application results for optimizing the performance of electronic feedback of a laser diode are presented. The goal of optimization is to find the maximum bandwidth of the laser diode with electronic feedback used in fiber optic digital communication. A numerical analysis of the system theory of the single-mode laser diode to obtain numerical results of the gain, the pulse response, and the harmonic distortion for electronic feedback is also presented. The dependence of the system gain on the feedback gain and delay is examined. The pulse response is studied and it is shown that a transmission rate over 1 Gbyte/s can be achieved.     

循环平稳声场的声源定位研究

旋转机械产生的辐射声场具有循环平稳特性,传统的平面近场声全息技术无法准确反映其调制特性,往往在边频带上出现虚假的能量的分布. 采用循环谱密度取代功率谱密度作为重建物理量,则可准确提取循环平稳声场的调制和载波信息. 考虑到循环谱密度的计算量以及特征提取的准确性,提出了循环谱密度组合切片分析法,并分析了加性白噪声对重建的影响. 仿真分析及实验结果表明,此方法有较强的噪声抑制能力,全息重建的结果可准确反映声源的位置. 关键词： 循环平稳声场 近场声全息 噪声源定位     

Optical feedback characteristics in a helium neon laser with a birefringent internal cavity

The output characteristics of optical feedback in a helium neon laser with a birefringent internal cavity are studied systematically in five different regions of the gain curve for the two orthogonally polarized modes. When the laser operates in the two end regions of the laser gain curve, one of the two orthogonally polarized modes will be a leading one in optical feedback. Strong mode competition can be observed. However, when the laser operates in the middle region of the laser gain curve, the two modes can oscillate equally with optical feedback. Besides the intensity of the two polarized lights, the total light intensity is also studied at the same time. M-shaped optical feedback curves are found. Particularly, when the average intensities of the two lights are comparable, the intensity modulation curve of the total light is doubled, which can be used to improve the resolution of an optical feedback system.[第一段]     

增益半导体光放大器的特性

为满足半导体光放大器（SOA）在光纤到户FTTH系统接入网中的广泛应用,提出了基于光纤光栅外腔反馈型GC-SOA结构的全光增益机制,窄线宽激光光源经可变衰减器、隔离器和光纤光栅注入到SOA中,SOA的输出光经隔离器和光纤光栅送至光谱分析仪,通过光纤光栅反馈输入SOA形成钳制激光。对GC-SOA的阈值特性、增益特性及开关特性进行分析,结果表明:当注入电流小于GC-SOA的阈值电流时,增益随注入电流的增加而增加;当注入电流大于GC-SOA的阈值电流后,其增益不再随注入电流的变化而变化,实现了SOA的增益稳定,使SOA的饱和输出功率得到了提高。     

Experimental implementation of a self-tuning control system for decentralised velocity feedback

Simulations have previously shown that, for broadband excitation, adjusting the gain of a local velocity feedback loop to maximise their absorbed power also tends to minimise the kinetic energy of the structure under control. This paper describes an experimental implementation of multiple velocity feedback loops on a flat panel, whose gains can be controlled automatically by an algorithm that maximises their local absorbed power. Taking care to remove excessive phase shift in the control loop allows a stable feedback gain that is high enough to experimentally demonstrate the transition in control action between optimum damping and pinning of the structure. A simple search algorithm is then used to adapt the feedback gains of two control loops to maximise their local absorbed powers, thus demonstrating self-tuning. By measuring the power absorbed by each of these loops and also estimation of the kinetic energy of the plate from velocity measurements for a wide range of the two feedback gains, it is shown that not only does the adaptive algorithm converge to a set of feedback gains that maximise total power absorbed by the two feedback loops, but also that this set of feedback gains is very close to those that minimise the measured kinetic energy of the panel.     

Synchronization between two different chaotic systems with nonlinear feedback control

This paper presents chaos synchronization between two different chaotic systems by using a nonlinear controller, in which the nonlinear functions of the system are used as a nonlinear feedback term. The feedback controller is designed on the basis of stability theory, and the area of feedback gain is determined. The artificial simulation results show that this control method is commendably effective and feasible.     

Multiwavelength picosecond frequency-shifted feedback laser with pulse control by a shaped-gain fiber amplifier

Stable generation of multiwavelength picosecond pulses by a frequency-shifted laser is demonstrated. Pulses are reliably trapped by gain variations provided by a low-extinction transmission filter. Pulses with close parameters are obtained despite considerable difference in amplifier gain at the pulse train wavelengths owing to a strong gain-equalization mechanism provided by the frequency-shifted feedback.     

Gain narrowing in few-atom systems

Using a density matrix approach, we study the simplest systems that display both gain and feedback: clusters of 2 to 5 atoms, one of which is pumped. The other atoms supply feedback through multiple scattering of light. We show that, if the atoms are in each other's near field, the system exhibits large gain narrowing and spectral mode redistribution. The observed phenomena are more pronounced if the feedback is enhanced. Our system is to our knowledge the simplest exactly solvable microscopic system which shows the approach to laser oscillation.     

基于状态反馈参数激励系统的超谐共振分岔控制

设计了非线性参数控制器，改变了参数激励系统2 倍超谐共振时的稳态响应，减小了系统的响应幅值和消除了超谐共振时的鞍结分岔，从而消 除了跳跃和滞后现象.首先由多尺度法得到参数系统的近似频响方程，再进行分岔分析，从 而实现非线性控制的目标.通过数值模拟，说明状态反馈控制是可行的和有效的. 关键词： 参数激励 鞍结分岔 分岔控制 2倍超谐共振     

Design of output feedback controller for a unified chaotic system

In this paper, the synchronization of a unified chaotic system is investigated by the use of output feedback controllers; a two-input single-output feedback controller and single-input single-output feedback controller are presented to synchronize the unified chaotic system when the states are not all measurable. Compared with the existing results, the controllers designed in this paper have some advantages such as small feedback gain, simple structure and less conservation. Finally, numerical simulations results are provided to demonstrate the validity and effectiveness of the proposed method.