复合型变耦合系数定向耦合器开关特性的研究

研究了高斯—常数—高斯平滑连接的复合型变耦合系数定向耦合器的开关特性曲线。研究了耦合器各分段长度对开关曲线的影响。数值模拟发现,耦合器各组成部分的参量对耦合器开关曲线尾部的振荡及开关功率的大小均有影响,且呈现出一定的规律性。高斯型波导部分的相对长度以及直波导部分所占份额共同决定了耦合器开关曲线尾部的振荡大小,且开关曲线的振荡与耦合函数的傅里叶变换的振荡密切相关。     

一种新型全光开关

提出了一种用指数型变耦合系数定向耦合器同高斯型变耦合系数定向耦合器级联所构成的新型全光开关。理论分析及数值模拟均表明,它同用常系数定向耦合器级联所得的器件相比,具有一个很大的优点,即可以消除开关曲线在过开关区中的振荡,因而具有更好的开关特性;同时,它同用高斯型变耦合系数定向耦合器级联所得的器件相比,具有陡峭的动态开关区(即功率透过率从0逐渐升至1的区域)。综上所述,该级联耦合器更加适合于做全光开关,且在满足一定的开关曲线的要求下,可以通过改变各级联耦合器的参量以改变单元耦合器的数目。     

星形光波导耦合器的耦合特性分析

根据TE0模光波导的本征场分布、瑞利索末菲标量衍射积分公式和激励源与光波导耦合的匹配效率公式,给出光波导端面衍射和耦合的归一化发射系数和接收系数计算公式,推导出光波导端面非接触耦合的耦合效率计算公式。光波导模场分布采用高斯函数近似表达,给出简洁的计算光波导端面非接触耦合的耦合效率函数表达式。最后,基于星形光波导耦合器结构参量的特点,将累加运算采用积分运算近似表达,给出星形光波导耦合器接收光波导总的接收效率与耦合器基本参量的关系,阐明了星形光波导耦合器的耦合特性。     

具有高阶耦合色散系数三芯光纤耦合器非线性光开关特性的研究

利用两种方法研究了高速光脉冲在具有交叉相位调制的等边三角形排列结构的非线性三芯光纤耦合器中传输和开关特性.首先利用变分原理得到三纤芯中传输转移系数随距离变化的方程,然后利用分裂步长傅里叶方法求得了光脉冲的数值解.变分法和数值模拟的结果表明：当一阶模间色散系数较小时,光脉冲仍能在三芯之间周期性耦合传输,并且表现出良好的开关特性,但是随着一阶模间色散系数的增大,脉冲耦合传输的周期性和陡峭的开关特性都遭到破坏,光脉冲在传输中发生分裂;二阶耦合色散系数和初始啁啾都能使光脉冲传输时的耦合长度变短、光脉冲在三纤芯之间 关键词： 三芯光纤耦合器 模间色散系数 耦合长度 开关阈值功率     

宽频带熔锥型耦合器的变化分析

利用变分法对腐蚀熔锥型非对称单模光纤耦合器的耦合特性进行了分析.文中根据耦合器的光纤参数及截面尺寸,用有效平行波导模型,对自制的弱融型熔锥耦合器的转换功率随波长变化曲线进行了计算.结果表明,不仅宽频带特性的理论曲线与实验符合得较好,而且耦合器的耦合特性对二光纤的芯径比及熔锥长度的变化十分灵敏,这也与实验相符.     

平板波导的非线性耦合

给出了两个平板波导耦合成的定向耦合器,当两波导的间隙为克尔型非线性人质时耦合系数与导波功率的关系的计算公式与计算步骤,给出了耦合区为自聚焦介质及自散焦介质两情况的计算实例,并对计算结果进行了讨论     

���Ӳ���Შ��������������Ե���ֵ����

通过数值模拟研究了低杂波多结波导阵天线的耦合特性。采用线型耦合理论,用艾黎函数计算了等离子体阻抗,推导出常规波导阵对等离子体的散射矩阵,并利用它和天线自身的散射矩阵研究了HT-7装置低杂波多结波导阵天线的耦合特性;计算了其平均功率反射系数、方向性系数和功率谱与等离子体边缘密度和主波导相位差等参数的关系。结果表明,与常规波导阵相比,由于多结波导阵天线存在自匹配特性,其天线功率反射系数小,且对相位不敏感。但由于存在多余副瓣,驱动效率较低。     

低杂波多结波导阵天线耦合特性的数值分析

通过数值模拟研究了低杂波多结波导阵天线的耦合特性。采用线型耦合理论,用艾黎函数计算了等离子体阻抗,推导出常规波导阵对等离子体的散射矩阵,并利用它和天线自身的散射矩阵研究了HT-7装置低杂波多结波导阵天线的耦合特性;计算了其平均功率反射系数、方向性系数和功率谱与等离子体边缘密度和主波导相位差等参数的关系。结果表明,与常规波导阵相比,由于多结波导阵天线存在自匹配特性,其天线功率反射系数小,且对相位不敏感。但由于存在多余副瓣,驱动效率较低。     

THz波段渐变波导中的多模传输特性

 根据耦合波理论,推导出轴对称渐变波导中, 考虑波导壁损耗时的多模传输时域耦合波方程组,并给出该方程组中各模式间耦合系数的具体表达式。据此编写了渐变波导中多模传输特性数值模拟程序。利用该程序计算了在THz波段圆波导中的模式衰减,在THz波段研究波导中的多模传输特性时,必须考虑波导壁的阻抗损耗影响。数值分析了直波导中的模式耦合问题,从而证实了波导壁有限电导率能产生模式耦合这一耦合机制。介绍了利用该程序数值分析波导耦合器和过渡器中多模传输特性的两个例子,利用该程序可对波导耦合器和过渡器中的多模传输特性进行数值模拟分析,进而对结构进行设计和优化。     

全光数字光开关和光限幅器

分析了级联单端输入非线性光波导耦合器的输出特性。理论分析表明这类器件具有极好的开关、限幅以及稳定光功率的特性。调整耦合器的耦合长度,可改变开关的阈值功率和限幅器的门限,且随着级联耦合器数目的增加,开关的动态开关区、消光比以及输出功率的起伏下降。数值分析表明,级联耦合器作为全光开关,消光比可小于－９０ｄＢ,动态开关区可小于３×１０－４Ｐｃ;作为光功率稳定器和光学限幅器,其输出光功率起伏可小于１０－７Ｐｃ。     

Gain-induced soliton switching in fiber nonlinear directional coupler

With study for switching characteristics and output coupling ratio of fiber nonlinear directional couplers (NLDC), we found that the influence elements on the switching characteristics and output coupling ratio had gain of core 1 and 2, nonlinear coefficient of those, the input power and width of input soliton. We also found numerically that switching efficiencies were improved by controlling gain of core 1, different output coupling ratio would be obtained by controlling gain of core 1 or 2. And we can change the gain by changing pump power of the optical fiber amplifiers. From this, we also made fiber coupler which output coupling ratio was changeable.     

Femtosecond pulse switching in a fiber coupler with third order dispersion and self-steepening effects

A numerical study of femtosecond pulse propagation and switching in a dual-core nonlinear directional coupler with the consideration of third order dispersion and self-steepening effects is reported. The Split Step Fourier Method (SSFM) is used to investigate the switching characteristics of nonlinear directional couplers. It is observed that the energy transfer from core to core is not affected by changing the input pulse shapes except super-Gaussian. While the normalized coupling co-efficient and the input peak power dominate the coupling characteristics, the effects of third order dispersion (TOD) and self-steepening (SS) are also reported.     

Nonlinear optical switching matrix

We show that nonlinear directional couplers with variable coupling coefficients can be used to compose a special kind of switching matrix. The switching matrix can be controlled by the signal itself or by a strong pump. Light routing is realized by adjustment of the power of the signal or the pump. Because light routing is based on the optical Kerr effect, ultrafast routing is possible.     

圆波导定向耦合器在高功率微波测量中的应用

介绍了大功率容量定向耦合器的设计、标定、测试与应用情况。以X波段圆波导定向耦合器为例,在9.2~10.2 GHz的频带范围内,基于小孔耦合理论优化设计的结构,其耦合度可以稳定在(55±2)dB以内,隔离度大于80 dB。在此基础上,设计加工了X波段圆波导定向耦合器并进行了标定测试,测试与仿真结果吻合较好,高功率微波实验证实了其具有较高功率容量,能够满足实验需求。该类圆波导定向耦合器已广泛应用于实验室高功率微波源的在线测量装置中。     

Effects of third-order dispersion on soliton switching in fiber nonlinear directional couplers

The split-step Fourier method is used to study the energy switching characteristics of fiber nonlinear directional couplers with the third-order dispersion. The effects of the third-order dispersion increases with the third-order dispersion coefficient and input power and result in pulse shift and energy decreases. Adding high-order nonlinear can partly overcomes these effects.     

三芯非线性光纤耦合器中的短脉冲光开关

利用变分法研究三芯非线性光纤耦合器中的短脉冲光开关,解析分析线性三耦合非线性Schr?dinger方程的结果与数值模拟符合得很好.并且得到在非线性光纤耦合器中孤子的耦合长度和开关阈值,与连续波情况和两芯光纤耦合器的结果不同. 关键词： 光纤耦合器 光开关 耦合长度 开关阈值     

Novel effects in non-linear coupling

Non-linear couplers should be important in optical circuitry, especially in switching applications. In a non-linear coupler the oscillation in energy between the two cores depends on the initial light intensity. New effects which can occur in non-linear coupling are presented, using an analysis which includes an interaction coefficient. For a coupler formed from identical guides, the complete forms for the two invariants are given. Energy components are considered, and it is shown that, for a certain input energy, there is no coupling. In this case there is no oscillation in energy levels, so energy launched in one guide will remain in that guide. The energy required for switching to occur depends on the interaction coefficient as well as the non-linearity.     

Semi-Analytical Simulation of Titanium-Indiffused Lithium Niobate-Integrated Optic Directional Couplers Consisting of Curved Waveguides

Integrated optic directional couplers consisting of curved waveguides are simulated analytically by solving the Riccati equation. The coupling coefficient between the curved waveguides with a parabolically varying gap and the condition of total power transfer between the waveguides are derived. In order to compute the overall coupling coefficient and hence the power distribution along the waveguides for Ti:LiNbO₃ curved waveguide directional couplers, the coupling coefficient for straight waveguide couplers is computed for different gaps using the effective-index-based matrix method (EIMM). Finally, the power distribution in the curved waveguides along the length is computed. The method is mostly analytical except the effective-index method and is computationally simple.