共查询到20条相似文献,搜索用时 125 毫秒
1.
设计了一种用于直线变压器驱动源的三电极场畸变气体火花开关。开关采用SF6气体绝缘,开关尺寸和电感较小,实测开关电感约为67 nH。在工作电压80 kV、工作系数为70%时,开关触发时延为40.0 ns,抖动约2.8 ns。对比研究了钨铜合金和黄铜两种电极材料对开关静态和触发击穿特性的影响,研究结果表明:铜钨合金电极开关的自击穿电压分散性、触发时延及抖动、自放电概率和电极表面烧蚀均小于黄铜电极,更适宜作为三电极场畸变开关的电极材料。 相似文献
2.
3.
脉冲变压器与陡化开关结合的方式是产生纳秒脉冲较为成熟的方式,采用这种方式,研制了一种基于空芯Tesla变压器和陡化开关的紧凑高压重复频率纳秒脉冲源。该脉冲源主要由重复频率充电模块、Tesla变压器和陡化开关三部分组成,重复频率充电模块主要通过晶闸管的时序配合实现,Tesla变压器为脉冲源装置系统的核心及主升压模块,陡化开关是一个三电极自击穿型气体开关,用于将变压器次级输出的电压陡化成纳秒快脉冲波形,对该重复频率脉冲源以上各部分进行了详细的设计和测试。实验结果表明,该脉冲源可以在6kΩ的负载电阻上输出幅值100kV、上升沿约为30ns、最高频率可达500Hz的高压纳秒脉冲。 相似文献
4.
针对快放电直线脉冲变压器驱动源初级储能开关,调节开关气压,进行相同自击穿电压下不同间隙长度的开关自击穿实验。通过监测自击穿电压分布规律变化,研究开关间隙长度对开关自击穿特性的影响。结果表明,当开关间隙长度较大时,电极表面粗糙度较小,表明电极烧蚀程度较低。开关间隙长度为6 mm时,开关自击穿电压分散性达到最小,自击穿电压分布符合高斯函数,间隙长度大于6 mm时自击穿电压分布符合极限函数。适当增加开关间隙长度使自击穿电压分布失去对称性,有利于开关在低欠压比下获得更好的静态性能。针对电极结构,选择开关间隙长度为6~9 mm时能够获得最佳的静态性能。初步分析,引起开关自击穿电压分布发生改变的原因是电场强度的改变对阴极电子发射产生了影响。 相似文献
5.
气体开关是脉冲功率技术中广泛应用的关键部件之一,高功率、高性能气体开关的技术研究及设计具有重要意义,陡化前沿是开关技术研究的重要内容。分析了气体开关的击穿机理和击穿通道的分布规律。对气体开关充分"老练",开关击穿点和击穿通道将相对稳定,实验研究了开关间距和电场对脉冲前沿的影响。击穿电场较低时,减小开关间距有利于陡化脉冲前沿;击穿电场较大时(大于180kV/cm),开关间隙(电感)对输出脉冲前沿的影响减弱,气体开关的击穿电场成为影响输出脉冲前沿的关键因素。研究结果表明,增大开关的击穿场强,是陡化开关脉冲前沿的有效途径。 相似文献
6.
以“CHP01”加速器为实验平台,对自行研制的重复频率三电极气体开关的自击穿特性开展了实验研究。研究了开关自击穿特性与气压、气流流速、电极形状等因素的关系,并对实验结果进行了分析。结果表明:随着气压的升高,开关自击穿电压分散性变大;适当流速的气流有助于减小开关的自击穿分散性,但气流流速过大将加大自击穿分散性;当通过改变电极形状增大极间场增强因子时,开关电极间场增强因子变大,开关分散性减小,但平均自击穿电压有所降低。 相似文献
7.
在工作气压和火花间隙固定的条件下,针对稍不均匀场的圆饼形电极开关开展了不同电极材料下开关自击穿实验,开关间隙距离为5mm,工作气压为0.25 MPa,击穿电压平均值为40kV。分别选取了不锈钢、黄铜、钨铜合金和石墨材料作为实验对象,对比了不同电极材料下电极质量损失、电极表面形貌和开关静态特性的差异。实验结果表明,石墨电极质量损失速率略高于金属电极,但是由于石墨电极烧蚀产物多为气体,因此石墨电极绝缘子污染程度远小于金属电极。石墨电极开关在低欠压比下自击穿概率也远小于金属电极开关。三种金属电极开关,其静态特性差异不大,但钨铜电极烧蚀程度显著低于不锈钢和黄铜电极开关。 相似文献
8.
为减小脉冲功率源装置的体积,对场畸变三电极轨道气体开关和两电极轨道气体开关结构进行了小型化低电感设计,采用电磁场仿真软件对局部结构进行优化,对初步设计的触发开关和自击穿开关在不同气压(0~0.3MPa)和不同气体介质(N2,SF6,以及二者混合)条件下的击穿电压及导通电感等进行了研究。研究表明:小型触发开关和自击穿开关在0~0.3MPa气压范围内自击穿电压随气压具有较好的线性关系;相同气压下SF6气体的自击穿电压约为N2气体的两倍;N2与SF6压力按3∶2混合的自击穿电压约为纯SF6气体的0.8~0.9倍;内部充入0.25MPa气压的SF6气体时,触发开关和自击穿开关均可在190kV左右正常工作。根据实验中出现的开关沿面击穿现象,对开关的沿面绝缘能力进行了优化设计,并得到了实验验证。另外通过短路放电测试,得到触发开关电感约22nH,自击穿开关电感约20nH,开关导通电流大于20kA,多次放电后电极烧蚀痕迹分布均匀。 相似文献
9.
为了减小脉冲功率源装置的体积, 对三电极气体开关和两电极气体开关的结构进行了小型化设计。采用电磁场仿真软件对局部结构进行优化, 对初步设计的触发开关和自击穿开关在不同SF6气压(0~0.2 MPa)、不同开关间隙条件下的击穿电压及触发工作电压等进行了实验研究。结果表明:设计的触发开关和自击穿开关在0~0.2 MPa气压范围内, 自击穿电压随气压具有很好的线性关系; 自击穿开关间隙为8 mm, 改变气压(0.1~0.2 MPa)可实现自击穿电压90~125 kV可调; 触发开关主间隙为7 mm, 改变气压(0.1~0.2 MPa)可实现触发工作电压40~95 kV 可调; 初步估算, 触发开关和自击穿开关的工作电感均约20 nH。利用重频脉冲电源, 测试了开关的重频工作能力, 在工作电压80 kV、导通电流约20 kA的条件下, 重复工作频率在20 Hz以上。此外, 利用研制的开关构建了八级紧凑型Marx发生器, 实现了5和10 Hz重频多脉冲输出。 相似文献
10.
11.
利用脉冲火花预电离方式,设计了一种脉冲火花预电离触发的触发管气体开关。开关工作电压等级为100 kV,工作介质采用干燥空气,开关主间隙10 mm,电极材料采用304不锈钢,触发结构设计成盘环嵌套结构。实验结果表明:预电离能够显著减小低工作系数下触发管气体开关的触发时延和抖动。对于ns级快脉冲触发,预电离时刻越早,开关击穿时延和抖动越低。在30 kV/8 ns触发脉冲作用下,脉冲预电离触发的触发管开关在80%工作系数时,平均时延约为40 ns,抖动小于1 ns。 相似文献
12.
Amarendra K. Sarma 《Optics & Laser Technology》2009,41(3):247-217
Dark soliton switching in a nonlinear directional coupler in the presence of intermodal dispersion, cross-phase modulation (CPM), third-order dispersion, Raman effect, and self-steepening effect is reported for the first time. It is shown that, with the exception of CPM, all of the other perturbative effects have almost no effect on the switching characteristics of the dark soliton switch, which is an improvement over the corresponding bright soliton switch. Although the CPM increases the critical power of dark soliton switching, the soliton pulse remains stable inside the coupler during its propagation. 相似文献
13.
14.
Tou T.Y. Seow W.S. Siew W.O. Beak K.W. Chen Y.H. Low K.S. 《IEEE transactions on plasma science. IEEE Nuclear and Plasma Sciences Society》1993,21(6):696-700
The air breakdown times of second spark formation, geometrically in series with trigatron switching, are studied and compared to that of a triggered spark gap. Despite a large breakdown jitter of ⩾1 μs in the trigatron, the latter is not observed to affect the electrical closure times of the series-connected second spark gap, which is triggered largely as a result of their direct electrical and optical coupling. While most of the multistage spark gaps are designed for fast and precision switching of high voltages, the air breakdown times of the second spark formation find a number of useful applications, particularly in achieving uniform glow discharge in pulsed gas lasers 相似文献
15.
16.
A numerical study of femtosecond pulse propagation and switching in a dual-core nonlinear directional coupler with the consideration of third order dispersion and self-steepening effects is reported. The Split Step Fourier Method (SSFM) is used to investigate the switching characteristics of nonlinear directional couplers. It is observed that the energy transfer from core to core is not affected by changing the input pulse shapes except super-Gaussian. While the normalized coupling co-efficient and the input peak power dominate the coupling characteristics, the effects of third order dispersion (TOD) and self-steepening (SS) are also reported. 相似文献
17.
18.
A numerical study of ultra-short self-soliton switching along with the corresponding analysis of coupler parameters is carried
out for a Kerr coupler with intermodal dispersion. The influence of perturbations like third-order dispersion, self-steepening
and intrapulse Raman scattering, on switching characteristics is also studied.
相似文献
19.
MacGregor S.J. Tuema F.A. Turnbull S.M. Farish O. 《IEEE transactions on plasma science. IEEE Nuclear and Plasma Sciences Society》1997,25(2):118-123
This paper reports on a study into the effect of trigger voltage polarity and main gap voltage polarity on the switching performance of a pulse charged trigatron. The four polarity combinations possible, two homopolarity (trigger voltage and main gap voltage of the same polarity) and two heteropolarity (trigger voltage and main gap voltage of opposite polarity), were studied and compared in terms of their effect upon the switching range, delay time to breakdown, jitter, and voltage collapse time. It was found that the two heteropolarity configurations were superior to the homopolarity configurations in terms of the above switching characteristics, with the positive trigger/negative main gap heteropolarity configuration performing the best. The results are discussed, and an explanation of the influence of the polarity configuration on switching is suggested in terms of the discharge initiation mechanisms and subsequent development 相似文献