Coupling characteristics of laterally coupled gratings with slots

Laterally-coupled ridge-waveguide distributed feedback lasers fabricated without epitaxial regrowth steps have the advantages of process simplification and low cost. We present a laterally coupled grating with slots. The slots etched between the ridge and grating area are designed to suppress the lateral diffusion of carriers and to reduce the influence of the aspect-ratio-dependent-etching effect on the grating morphology in the etching process. Moreover, the grating height in this structure can be decreased to lower the aspect ratio significantly, which is advantageous over the conventional laterally coupled ridge waveguide gratings. The effects of five main structural parameters on the coupling characteristics of gratings are studied by MODE Solutions. It is found that varying the lateral width of the grating can be used as an effective way to tune the coupling strength; narrow slots (100 nm and 300 nm) and wide ridge (2 μm-4 μm) promote the stability of grating coupling coefficient and device performance. It is important to note that the grating bottom should be fabricated precisely. The comparative study of carrier distribution and mode field distribution shows that the introduction of narrow slots can strengthen the competitive advantage and stability of the fundamental mode.     

The study of wave motion in the Talbot interferometer with a lens

We present the study of the wave motion in the Talbot interferometer with an additional element such as a lens for all related audiences. Our solutions are in the analytic form. A general principle of the Talbot effect, which is the optical near-field effect, is the Fresnel diffraction. The Fresnel integral is rather complicated. We therefore introduce an alternative method which is based on the wave propagation through the transmission functions of the grating and the lens. Our method has been proved by a simple experimental setup.     

Electrochemical Deposition of Azobenzene‐Containing Network Films with High‐Contrast and Stable Photoresponse

To fabricate stable photoresponsive films and devices, a cross‐linked network that firmly fixes the position of the chromophores is an ideal structure, because aggregation and/or phase separation effects of chromophores in matrix can be effectively restrained in such robust films. Herein, the in situ electrochemical deposition (ED) of azo‐based precursors containing multielectroactive carbazole units is utilized to construct highly cross‐linked photoresponsive films. 2‐(4‐(9,9‐bis(6‐(9H‐carbazol‐9‐yl)hexyl)‐9H‐fluoren‐2‐yl)phenyl)‐1‐(4‐(9,9‐bis(6‐(9H‐carbazol‐9‐yl)hexyl)‐9H‐fluoren‐7‐yl)phenyl)diazene (BFCzAzo) with high solvability in electrolyte solution, high electroactivity, and highly efficient photoresponsive ability is synthesized by Suzuki coupling reaction as a kind of ED precursor. A highly cross‐linked photoresponsive film is fabricated by ED method using BFCzAzo as ED precursor. The film can be patterned in large area by irradiation with interfering laser beam (355 nm), and the pattern possesses excellent thermal stability and insoluble ability in both organic and inorganic solvents. Excellent reversibility of the nanostructures is demonstrated by irradiation with 550 nm laser beam.

     

金属Al背电极二维AZO光栅的制备和陷光特性

研究了背电极金属Al膜上二维ZnO:Al光栅的制备及其反射光谱特性.在厚度为300 nm的Al膜上溅射80 nm ZnO:Al薄膜,旋涂AZ5206光刻胶,用波长为325 nm的激光进行光刻制作光栅掩模.采用溶脱-剥离法在Al衬底上制备周期(624~1250 nm)和槽深(100~300 nm)可独立调控的ZnO:Al二维光栅.表面形貌采用原子力显微镜和扫描电镜观察,反射光谱用带积分球的分光光度计测试,双向反射分布函数用散射仪测量.结果表明,300 nm Al膜上织构二维ZnO:Al光栅背电极结构,当光栅槽深为228 nm,周期从624 nm增加到986 nm时,背电极总反射率、漫反射率以及雾度均随光栅周期增大而显著增加,而当周期从986 nm增加到1250 nm时,总反射率、漫反射率以及雾度略有增加.双向反射分布函数测试结果进一步证实了上述实验结果,即随着周期增大,漫反射峰值越大,衍射峰个数也增多.提示背反电极上槽深为228 nm、周期为986 nm的二维ZnO:Al光栅具有较好的散射效果,其中漫反射占总反射的百分比为45%.     

Dynamics of phase transitions in a liquid crystal probed by Raman spectroscopy

Raman spectra of the Schiff 's base liquid crystalline compound 5O5, N-(4- n-pentyloxybenzylidene)-4'-n-pentylaniline, have been recorded as a function of temperature from 22 to 80°C in the 1140-1220 cm^-1 and 1550-1640 cm^-1 spectral regions. From careful deconvolution of the spectral features using Lorentzian profiles, precise values of peak positions, integrated intensities and linewidths of some selected Raman bands were obtained. The variations of the Raman spectral parameters with temperature are discussed in terms of changes in the molecular alignment and its effect on intra-/inter-molecular interactions at the Cr-G, G-SmF, SmF-SmC and SmA-N phase transitions. From a detailed study, it is inferred that the increased orientational/vibrational freedom of the alkyl chains, as well as the delocalization of the electron clouds, is responsible for the spectral anomalies at the Cr-G transition. Loss of positional ordering and twist around the -C₆H₄-N= bond takes place at the SmF-SmC transition. In the SmA-N transition, some evidence for the formation of cybotactic clusters was obtained.     

一维金属光栅的光学反射吸收

利用RCWA(rigid coupled-wave analysis)方法研究了一维金属光栅的反射特性,考察了 瑞利反常、表面等离激元驻波共振和几何共振三种共振吸收机理,分析了这三种机理的相互作用,如表面等离激元驻波共振和几何共振可以形成混合模式. 在反射式复合金属光栅中,确认了第四种共振形式,即相位共振. 数值计算表明相位共振对光学吸收的影响有两种形式: 当光栅周期大于一个波长时,相位共振导致尖锐的吸收峰,峰位在几何共振吸收峰一侧;当光栅周期小于一个波长时,相位共振导致混合模式的共振吸收峰发生劈裂. 对一维金属光栅反射特性的研究增加了对金属光栅共振吸收模式及其相互作用的认识. 关键词： 一维金属光栅 瑞利反常 表面等离激元 相位共振     

Detection of water in jet fuel using layer-by-layer thin film coated long period grating sensor

The quantitative measurement of jet fuel additives in the field is of interest to the Air Force. The “smart nozzle” project was designed as a state-of-the-art diagnostics package attached to a single-point refueling nozzle for assessing key fuel properties as the fuel is dispensed. The objective of the work was to show proof of concept that a layer-by-layer thin film and long period grating fibers could be used to detect the presence of water in jet fuel. The data for the nafion/PDMA film and a long period grating fiber is a combination capable of quantitative measurement of water in kerosene. The average response (spectral loss wavelength shift) to the kerosene sample ranged from −6.0 for 15 ppm to −126.5 for 60 ppm water. The average calculated value for the check standard was 21.71 and ranged from 21.25 to 22.00 with a true value of 22.5 ppm water. Potential interferences were observed and are judged to be insignificant in real samples.     

High Sensitive Long Period Fiber Grating Sensor for Detection of Nitrite

A high sensitive long period fiber grating(LPFG) sensor for the detection of nitrite is proposed, which is realized by coating multiple poly(sodium 4-styrensulfonate)(PSS) and poly(diallyldimethylammonium) chloride (PDDA) layers on the fiber grating surface. The sensitivity of this LPFG sensor is maximum when the number of assembled layers is 70. Under this condition, a nitrite concentration of 3×10-3 mol/L, which is lower than the National Food Additive Standard, 4.2×10-3 mol/L, can be distinguished. The s...     

Photosensitive Materials for Integrated Optic Applications

Abstract

This article presents results of device fabrication using UV processing of materials and integrated optic components produced by flame hydrolysis deposition and hybrid sol-gel technology. Photosensitive materials were employed in the fabrication of channel waveguides and channel photo-imprinted waveguides incorporating Bragg gratings through single and double-step exposure.     

BIOLOGICALLY DERIVED PHOTOACTIVE MACROMOLECULAR AZODYES

Azophenols with various substituents at the para position of the phenyl ring were enzymatically polymerized in the presence of H₂O₂. Structural characterization of the synthesized polymers by FTIR, FT-Raman, and NMR (¹H and ¹³C) spectroscopy confirms our previous observation that this enzymatically catalyzed coupling reaction occurs primarily at the ortho positions, with some substitution at the meta position of the phenol ring. The strong constraint and poor packing of the azobenzene chromophores in the polymer leads to a significant blue shift of the π-π^* transition absorption and slow photoisomerization and thermal relaxation in comparison to the monomers. Surface relief gratings (SRG) with large surface modulation have been fabricated on these enzymatically synthesized polymer films.