室温铁磁性Sr3YCo4O10.5+δ多晶有序化的烧结工艺及电磁性能

采用固相反应法制备了不同烧结温度(950~1 180 ℃)、烧结时间、烧结次数共7种工艺的Sr₃YCo₄O_10.5+δ多晶块材,通过热分析、XRD、SEM确定了有序化相变和最佳烧结工艺(1 180 ℃/24 h+1 180 ℃/24 h),并研究了多晶的电磁性能。结果表明,964 ℃完全晶化的四方相Sr₃YCo₄O_10.5在1 042 ℃吸氧(δ)完成有序化,生成Sr₃YCo₄O_10.5+δ,而1 100 ℃和1 180 ℃烧结的样品均出现(103)、(215)超结构峰,验证了其结构的有序性。块材均呈半导体电输运行为,二次烧结晶格完整性提高,晶粒长大,300 K时电阻率仅为0.06 Ω·cm,居里温度(T_c)~335 K,零场冷曲线(ZFC)上的Hopkinson峰源于低温时被冻结的磁矩随温度升高转向磁场方向,磁化强度在298 K达到最大,随后受热扰动的影响减小。室温铁磁性源于有序结构导致的中自旋或高自旋态Co³⁺的e_g轨道有序。     

离子束增强沉积VO2多晶薄膜的温度系数

用改进的离子束增强沉积方法和恰当的退火从V2O5粉末直接制备了VO2多晶薄膜.实验测试表明，薄膜的取向单一、相变特性显著、结构致密、界面结合牢固、工艺性能良好，薄膜的电阻温度系数（TCR）最高可达4.23%/K.从成膜机理出发，较详细地讨论了离子束增强沉积 VO2多晶薄膜的TCR高于VOx薄膜的TCR的原因.分析认为，单一取向的VO2结构使薄膜晶粒具有较高的电导激活能，致密的薄膜结构减少了氧空位和晶界宽度，使离子束增强沉积 VO2多晶薄膜结构比其他方法制备的VOx薄膜更接近于单晶VO2是其具有高TCR的原 关键词： VO2多晶薄膜 离子束增强沉积 热电阻温度系数     

Spin-Polarized Tunnelling Magnetoresistance Effects in La0.833K0.167MnO3／SrTiO3 Polycrystalline Perovskite Manganites

A sample of La0.833K0.167MnO3-SrTiO3 (LKMO/STO) is fabricated by the sol-gel method. The microstructure,magnetic and transportation properties have been studied. X-ray diffraction patterns indicate that the structure of LKMO/STO is a homogeneous solid solution phase. The resistivity of LKMO/STO shows the insulator behaviour, which is different from La0.833K0.167MnO3 (LKMO) whose resistivity shows metal-insulator transition with decreasing temperature. The low-field (moH = 0.02 T) magnetoresistance decreases from 11% to 0.2% with the increasing temperature from 4 K‘to 220K for the LKMO/STO sample. The magnitude of magnetoresistance in a strong field (μoH = 5.5 T) almost increases linearly with decreasing temperature and reaches the maximum of 65% at the low temperature of 4.2K, which is much higher than that oE LKMO (40%). The enhanced low-field magnetoresistance effects are quantitatively explained by the spin-polarized tunnelling at grain boundaries.     

Nd：YVO4晶体α向生长研究

采用固-液两相混合，使Nd2o3、Y2O3和V2O5在近常温条件下初步合成Nd：YVO4多晶原料，降低固相合成反应温度，减少V2O5在多晶原料制备过程中的挥发。讨论了α方向V单晶生长条件，采用提拉法，以(100)方向进行单晶生长，得到一系列掺杂浓度的Nd：YVO4单晶。     

微波吸收法研究Mn,Cu掺杂对ZnS:Mn,Cu光生载流子复合过程的影响

采用微波吸收法，测量了ZnS:Mn,Cu粉末材料受到超短脉冲激光激发后，其光生电子和浅束缚态电子的衰减过程.发现Mn,Cu的浓度对导带电子的寿命有明显的影响，提高掺杂浓度会使光生电子的寿命大大缩短，还研究了掺杂浓度对光致发光强度的影响. 关键词： 发光材料 硫化锌 光电子 微波吸收技术     

Structural Phase Transformations of ZnS Nanocrystalline Under High Pressure

In-situ energy dispersive x-ray diffraction on ZnS nanocrystalline was carried out under high pressure by using a diamond anvil cell. Phase transition of wurtzite of 10nm ZnS to rocksalt occurred at 16.0GPa, which was higher than that of the bulk materials. The structures of ZnS nanocrystalline at different pressures were built by using materials studio and the bulk modulus, and the pressure derivative of ZnS nanocrystalline were derived by fitting the equation of Birch-Murnaghan. The resulting modulus was higher than that of the corresponding bulk material, which indicates that the nanomaterial has higher hardness than its bulk materials.     

单晶和多晶纯铝蠕变过程中的内耗

研究了单晶和多晶纯铝蠕变过程中的低频内耗. 在单晶纯铝中观察到: 内耗在蠕变初期单调下降, 在蠕变第一阶段后期出现了一个显著的时间内耗峰, 在蠕变第二阶段内耗趋于稳定值. 多晶纯铝在类似实验条件下则不出现时间内耗峰. 文中分析了出现时间内耗峰的条件和原因, 认为它是由于蠕变第一阶段中运动位错的阻尼系数逐渐增大所引起的. 文中还从蠕变过程中位错运动的微观机制出发, 推导出了蠕变过程中内耗的表达式, 满意地解释了实验结果. 关键词：     

原子吸收光谱间接测定色氨酸的研究

色氨酸(Tryptophan,Trp)在碱性条件下与新生成的ZnS悬浮液反应,生成可溶性碱式色氨酸锌配合物,再用塞曼原子吸收光谱测定溶液中的总锌浓度即可间接的得到色氨酸的含量.优化了测定的最佳条件,在pH 9.10的2%硼砂底液中于室温下,使色氨酸试液与新生成的ZnS悬浮液反应22min,离心分离后测定上层清液的FAAS响应.在所选定的条件下色氨酸测定的线性浓度范围为0-18.5mg·mL-1,特征浓度为0.219mg·mL-1,检出限为1.414mg·mL-1.该法用于样品中的色氨酸测定,其相对标准偏差RSD为4.12%,方法的回收率在70.1%-120.3%之间.并对测定机理进行了探讨.