基于Rietveld精修方法解析Bi2O3的原子热振动

三氧化二铋(Bi₂O₃)是氧离子导电体,为了获得它的原子热振动各向同性温度因子,对该粉末晶体进行X射线衍射实验,建立了晶体结构模型,利用Rietveld 精修方法的RIETAN-2000 程序对所得实验结果进行了晶体结构精修,通过最大熵方法(MEM)解析得到了粉末晶体的等高电子密度分布三维(3D) 和二维(2D)可视化图谱。结果表明,各原子Bi₍₁₎、Bi₍₂₎、O₍₁₎、O₍₂₎和O₍₃₎的原子热振动各向同性温度因子分别为0.004 938 nm²、0.004 174 nm²、0.007 344 nm²、0.007 462 nm²、和0.007 857 nm²,等高电子密度分布的可视化,进一步验证了晶体结构模型和原子位置的准确性,这些参数对研究晶体材料的热性质具有一定参考意义。     

基于XPS对硫铁矿去除SeO2-3的机理研究

硒是动植物及人体生长必需的十五种微量元素之一，具有清除体内自由基、抗氧化、增强免疫力等功能，但其安全剂量的范围却很窄。利用扫描电子显微镜（SEM）和X射线衍射仪（XRD）对湿法球磨制备的硫铁矿形貌进行了表征。SEM观测发现加乙醇助磨后的硫铁矿为粒径大小较均匀的球形颗粒团聚体，粒径范围在17～200 nm之间，平均粒径138 nm。XRD衍射图谱中的特征峰与FeS₂衍射图谱中各峰位置基本一致，因此判定硫铁矿中主要化学组分为FeS₂，且图谱中基本没有杂峰，表明制备过程中并未混入杂质，样品纯度较高。实验结果表明，该法制备的硫铁矿具有颗粒粒径小、比表面积大、反应活性高等优点。研究中利用X射线光电子能谱仪（XPS）对硫铁矿去除水体中SeO2-₃的机理进行了研究。研究结果表明, （1）在较为广泛的实验pH范围（pH 2.2～11.5），硫铁矿均能有效去除水体中SeO2-₃，去除效率（除pH值7.8以外）均达到90%以上；（2）硫铁矿与SeO2-₃发生反应后，其主要组成元素的XPS特征峰结合能有所减小，表明硫铁矿表面发生了一定化学变化；（3）酸碱环境下硫铁矿去除SeO2-₃的机理不完全相同，酸性环境下，硫铁矿对SeO2-₃的去除是单纯的氧化还原过程，即硫铁矿中被酸活化的S2-₂将SeO2-₃还原为单质Se(0)，并且酸性越强，SeO2-₃去除效果越好；碱性环境下，SeO2-₃的去除过程中氧化还原与络合反应并存，硫铁矿表面有络合态Fe(OH)SeO₃和单质Se(0)两种存在形态，且碱性越强，络合态Fe(OH)SeO₃含量越高。以上研究结果为硫铁矿去除固定水体和土壤中以SeO2-₃为代表的可变价金属阴离子提供重要理论依据和应用基础。     

Synthesis of trialkyl semithioglycolurils from alkylthiourea-glyoxal cyclic adducts and dialkylureas

Condensation of 1-alkyl-4,5-dihydroxyimidazolidine-2-thiones (monoalkylthiourea-glyoxal cyclic adducts) with 1,3-dialkylureas affords novel 1,4,6-trialkylsemithio- glycolurils having non-substituted NH group linked to C=S function. Such compounds can be accessed in two-stage one-pot reaction sequence from alkylthioureas and glyoxal followed by treatment of the resulting adduct with 1,3-dialkylureas     

射频等离子制备石墨烯负载Co3O4催化剂及其析氧性能研究

氢能的引入能有效提升配电网的供电可靠性,而电解水制氢是实现低碳转型的关键技术,开发高效的电解水催化剂势在必行。过渡金属氧化物储量大、催化活性高,是具有广阔应用前景的析氧反应催化剂。本文通过射频等离子体处理制备石墨烯上负载Co₃O₄析氧催化剂,XRD、Raman和XPS测试结果显示,二维结构石墨烯的引入加速表面电子迁移,增大了反应面积。等离子体处理促进了纳米粒子在石墨烯上的负载,利用等离子体刻蚀作用在催化剂表面制造出大量碳结构缺陷和氧空位结构,改善了活性位点分布,有效调控Co₃O₄电子结构,提高析氧催化活性。电化学测试表明,本文中合成的Co₃O₄@rGO在电流密度为50 mA·cm^-2时的过电位为410 mV,动力学反应速率较快,表现出优于商业IrO₂的析氧催化活性。     

A gadolinium-based magnetic ionic liquid for supramolecular dispersive liquid–liquid microextraction followed by HPLC/UV for the determination of favipiravir in human plasma

Favipiravir is a potential antiviral medication that has been recently licensed for Covid-19 treatment. In this work, a gadolinium-based magnetic ionic liquid was prepared and used as an extractant in dispersive liquid–liquid microextraction (DLLME) of favipiravir in human plasma. The high enriching ability of DLLME allowed the determination of favipiravir in real samples using HPLC/UV with sufficient sensitivity. The effects of several variables on extraction efficiency were investigated, including type of extractant, amount of extractant, type of disperser and disperser volume. The maximum enrichment was attained using 50 mg of the Gd-magnetic ionic liquid (MIL) and 150 μl of tetrahydrofuran. The Gd-based MIL could form a supramolecular assembly in the presence of tetrahydrofuran, which enhanced the extraction efficiency of favipiravir. The developed method was validated according to US Food and Drug Administration bioanalytical method validation guidelines. The coefficient of determination was 0.9999, for a linear concentration range of 25 to 1.0 × 10⁵ ng/ml. The percentage recovery (accuracy) varied from 99.83 to 104.2%, with RSD values (precision) ranging from 4.07 to 11.84%. The total extraction time was about 12 min and the HPLC analysis time was 5 min. The method was simple, selective and sensitive for the determination of favipiravir in real human plasma.     

汽配件颜色喷涂顺序问题的TSP转化与建模

汽配件颜色喷涂顺序问题通常以生产线上相邻汽配件颜色切换次数少为最优目标,以进一步降低生产成本.该类问题具有所有汽配件都必须喷涂一次且只喷涂一次的特点,为此提出了TSP转化与建模的方法.将待喷涂汽配件定义为TSP顶点,任意两个待喷涂汽配件的颜色切换定义为顶点的距离,仿照TSP问题构建0-1规划模型;类似于顶点距离,将某些汽配件的颜色或类别不相邻要求定义为0-1矩阵,巧妙地构造了喷涂生产的约束条件.该建模方法简单快速,通用性高,适用于具有类似特点的各类生产实践问题.     

室温铁磁性Sr3YCo4O10.5+δ多晶有序化的烧结工艺及电磁性能

采用固相反应法制备了不同烧结温度(950~1 180 ℃)、烧结时间、烧结次数共7种工艺的Sr₃YCo₄O_10.5+δ多晶块材,通过热分析、XRD、SEM确定了有序化相变和最佳烧结工艺(1 180 ℃/24 h+1 180 ℃/24 h),并研究了多晶的电磁性能。结果表明,964 ℃完全晶化的四方相Sr₃YCo₄O_10.5在1 042 ℃吸氧(δ)完成有序化,生成Sr₃YCo₄O_10.5+δ,而1 100 ℃和1 180 ℃烧结的样品均出现(103)、(215)超结构峰,验证了其结构的有序性。块材均呈半导体电输运行为,二次烧结晶格完整性提高,晶粒长大,300 K时电阻率仅为0.06 Ω·cm,居里温度(T_c)~335 K,零场冷曲线(ZFC)上的Hopkinson峰源于低温时被冻结的磁矩随温度升高转向磁场方向,磁化强度在298 K达到最大,随后受热扰动的影响减小。室温铁磁性源于有序结构导致的中自旋或高自旋态Co³⁺的e_g轨道有序。     

Construction and application of an electrochemical sensor based on graphene-MXene nanocomposites for baicalin detectionEI北大核心CSCD

Redox graphene-MXene(rGO-MXene) nanocomposites were prepared by ion polymerization and used to construct a highly sensitive electrochemical sensor for baicalin(BA) detection. The synergistic effect of rGO and MXene increased the specific surface area and electron transport capacity of the electrode, and significantly enhanced the electrochemical response of BA. The cyclic voltammetry and differential pulse voltammetry were used to investigate the electrochemical behavior of BA on the sensor. Under the optimal conditions, the peak current exhibited a good linear relationship with BA concentration in the range of 0. 05-10 μmol / L, and the limit of detection was as low as 28 nmol / L. The method was applied to analyze traditional Chinese medicine preparations containing baicalin, such as Qingkailing Capsule and Sanhuang Tablets with good accuracy and spiked recovery. The results were highly consistent with those of high performance liquid chromatography, providing a technical means for the rapid and sensitive detection of traditional Chinese medicine preparations. © 2022, Youke Publishing Co.,Ltd. All rights reserved.     

Mg,N掺杂β-Ga2O3光电性质的第一性原理计算

通过基于密度泛函理论的第一性原理计算,研究了Mg单掺杂、N单掺杂和不同浓度的Mg-N共掺杂β-Ga₂O₃的结构性质、电子性质和光学性质,以期获得性能比较优异的p型β-Ga₂O₃材料。建立了五种模型:Mg单掺杂、N单掺杂、1个Mg-N共掺杂、2个Mg-N共掺杂和3个Mg-N共掺杂β-Ga₂O₃。经过计算,3个Mg-N共掺杂β-Ga₂O₃体系的结构最稳定。此外,在5种模型中,3个Mg-N共掺杂β-Ga₂O₃体系的禁带宽度是最小的,并且N 2p和Mg 3s贡献的占据态抑制了氧空位的形成,从而增加了空穴浓度。因此,3个Mg-N共掺杂β-Ga₂O₃体系表现出优异的p型性质。3个Mg-N共掺杂体系的吸收峰出现明显红移,在太阳盲区的光吸收系数较大,这归因于导带Ga 4s、Ga 4p、Mg 3s向价带O 2p、N 2p的带间电子跃迁。本工作将为p型β-Ga₂O₃日盲光电材料的研究和应用提供理论指导。