Experimental investigation and numerical simulation of the influence of resonator-length detuning on the output power,pulse duration and spectral width of a cw mode-locked picosecond optical parametric oscillator

We report on a cw mode-locked non-critically phase matched KTP optical parametric oscillator synchronously pumped by a picosecond Ti:Sapphire laser. High average signal output power of up to 950 mW over a large tuning range has been achieved. For this OPO the influence of resonator-length detuning on the output power, pulse duration and spectral bandwidth has been investigated. The measured data are in good agreement with the results of a numerical simulation using a split-step Fourier method which considers the group-velocity mismatch, the group-velocity dispersion and the self-phase modulation. The numerical simulation also describes the measured strong pump depletion and its influence on the OPO output and efficiency.     

Synchronized picosecond pulse generation with a synchronously pumped dye laser and a compressed Nd: YAG laser for non-degenerate transient grating experiments

We have set up a laser system which simultaneously provides synchronized picosecond pulses in the visible and at a wavelength of 1.06 m with a repetition rate of 76 MHz. The set-up consists of a dye laser synchronously pumped by the second harmonic of a cw mode-locked Nd:YAG laser and a fiber-grating compressor for the fundamental wavelength of the Nd;YAG laser. Crosscorrelation measurments reveal the time jitter between the two pulse trains to be less than 10 ps. As a first application we have performed non-degenerate transient grating experiments in semiconductors. The non-degenerate technique allows to use excitation energies well above the bandgap energy and to separate non-linear refractive index effects from photoinduced absorption or transmission changes.     

Biotinylation: A nonradioactive method for the identification of cell surface antigens in immunoprecipitates

A nonradioactive method was employed to detect different cell membrane antigens on human polymorphonuclear granulocytes, monocytes and platelets. We compared the reactivity of one monoclonal antibody, N1III10, assumed to be FcγRII-specific by functional assays, with other well-characterized monoclonal antibodies and human sera. Intact cells were incubated with biotin N-hydroxysulfosuccinimide ester which preferentially reacts with lysine residues in polypeptides. Biotin-labeled cells were lysed and the antigen was isolated from the cell lysate by immunoprecipitation with the antibody bound to Protein A-Sepharose. The precipitates were separated by sodium dodecyl sulfate-polyacrylamide gel electrophoresis, transferred onto nitrocellulose membrane, and visualized by a streptavidin-alkaline phosphatase system with a suitable substrate. Using this biotin-labeling system we could show that N1III10 detects a 40 kDa antigen on monocytes and platelets, comparable to that expected of FcγRII monoclonal antibodies.     

Additive pulse mode-locked Nd: YAG laser

Additive pulse mode locking applied to lamppumped Nd: YAG lasers results in an attractive source of picosecond pulses at 1.06 m or 1.32 m with average powers at the Watt level. We provide detailed information on construction and operation and give data on performance. A modified active stabilization scheme allows not only improved stability of operation but also insight into the dynamics of pulse formation.     

Multiwavelength Q-switched CO2 laser with continuous discharge

A low-pressure (20 mbar) CO₂ laser allows to extract pulses at several selected wavelengths simultaneously from the same active medium. We demonstrated this, using an industrial laser modified by a Q-switch and a resonator with two branches. In one branch the wavelengths are spatially separated, whereas in the other they oscillate in one common transverse mode. We designed a multi-wavelength resonator which requires a single additional reflector compared to usual laser cavities. It provided tunable oscillation at six wavelength simultaneously.     

A Bidirectional, Diode-Pumped, Passively Mode-Locked Nd：YVO4 Ring Laser with a Low-Temperature-Grown Semiconductor Saturable Absorber Mirror

We report the operation of a bidirectional picosecond pulsed ring Nd：YVO4 laser based on a low-temperaturegrown semiconductor saturable absorber mirror. Except for the laser crystal, the six-mirror ring laser cavity has no intra-cavity elements such as focusing lens or mirror. The bidirectional mode locked pluses are obtained at the repetition rate of 117.5 MHz, pulse duration of 81 ps, power of 2 × 200 mW.     

A 2.048μm Tm,Ho:GdVO4 Laser Pumped Doubly Resonant Optical Parametric Oscillator Based on Periodically Poled Lithium LiNbO3

A multi-grating periodically poled LiNb03 （PPLN） doubly resonant optical parametric oscillator （DROPO） pumped by a 2-ttm laser is demonstrated experimentally. Employing acousto-optically Q-switched Tm,Ho：GdV04 laser with pump pulse of 25ns and repetition rate of lOkHz as pump sources firstly, the noncritically quasi- phase-matched （QPM） tunable mid-IR output in 3.87-4.43 μm is produced. Wavelength tuning is achieved with crystal temperature tuning from 50-180^o C. When the incident average pump power is 3 W at 2.048μm, the total OPO output power of 195mW at wavelength 3.88μm is obtained, corresponding to optical-to-optical conversion efficiency up to 6.5%.     

Near-Field Fluorescence and Topography Characterization of a Single Nanometre Fluorophore by Apertureless Tip-Enhanced Scanning Near-Field Microscopy

Tip-enhanced near-field fluorescence and topography characterization of a single nanometre fluorophore is conducted by using an apertureless scanning near-field microscopy system. A fluorophore with size 80hm is mapped with a spatial resolution of 10hm. The corresponding near-field fluorescence data shows significant signal enhancement due to the apertureless tip-enhanced effect. With the nanometre spatial resolution capability and nanometre local tip-enhanced effect, the apertureless tip-enhanced scanning near-field microscopy may be further used to characterize a single molecule by realizing the local near-field spectrum assignment corresponding to topography at nanometre scale.     

Two-dimensional self-assembly of esters with different configurations at the liquid-solid interface

Self-assembled monolayers of hexadecyl palmitate (HP) and 3,3′-thiodipropionic acid di-n-octadecyl ester (TADE) physisorbed on highly oriented pyrolytic graphite (HOPG) are investigated using scanning tunneling microscope (STM) and computer simulation. Both molecules form alkane-like linear shapes to maximize the interactions with substrate when they adsorb on HOPG surface. The HP molecules self-assemble into lamellae with the chain-trough angle of 48°, which is the result of a shifting 3/2 units from the adjacent molecule in a lamella. Based on the simulation insights combined with STM images, we confirm that a perpendicular orientation appears in which the HP molecular backbone is rotated 90° with respect to the substrate such that the carbonyl points away from the HOPG surface. TADE molecules form three kinds of configurations with chain-trough angles of 90°, 72° and 60° by shifting 0, 1/2 and 1 units from their adjacent molecules, respectively. The bright stripes in STM images reveal the electron density distribution of the part between two ester groups. The energy differences of three TADE adsorption configurations by molecular mechanics (MM) simulation are used to explain the structural coexistence phenomenon. It is also shown that lattice match between alkyl chain of molecules and HOPG substrate could change molecular conformation upon self-assembly.     

Interrelation of intrinsic and extrinsic defects – congruent, stoichiometric, and regularly ordered lithium niobate

A new approach to the intrinsic and extrinsic defect subsystems, considering them as one integrated functional system, is developed for complex oxides. The strong interrelation of these subsystems becomes especially apparent when concentrations of both defect classes are comparable. A new parameter, reflecting the total intrinsic defect concentration, is introduced to determine the degree of crystal imperfection. The necessity of at least two calibrated samples – congruent and regularly ordered crystals – is substantiated. The accuracy by which the parameter can be determined can serve as a criterion in comparison of different methods of crystal characterisation. A procedure for crystal calibration by several physical characteristics is illustrated. Such a heuristic generalisation of the concept of mutual correlation of the whole defect system and the material only became possible on the basis of experimental and theoretical study of large numbers of LiNbO₃ crystals. The spectra of EPR, NMR, ENDOR, and other properties of crystals with different compositions, diverse modifiers (K, Mg,...), and various probe impurities have been analysed. It is found that crystals with vanishingly small concentration of intrinsic defects offer extraordinary informative opportunities. Their micro- and macroscopic properties are discussed. The developed ideas have a general character; therefore they should also be valid for other non-stoichiometric complex oxides. Received: 3 December 1998 / Revised version: 15 February 1999 / Published online: 12 April 1999