密封容器中后处理制备Tl2Ba2CaCu2Oy高温超导薄膜及其性能研究

以铝酸镧（001）单晶为基片，采用两步法制备Tl2Ba2CaCu2Oy（Tl 2212）高 温超导薄膜.首先，利用脉冲激光沉积（PLD）工艺沉积Ba2CaCu2Ox非晶前驱体薄膜；然后，前驱体薄膜在高温（720—850℃）下密封钢容器里铊化结晶形成Tl 2212薄膜.XRD结果表明Tl2212 薄膜是沿c轴方向生长的，其相组成为Tl 2212，摇摆曲线（0012）的半高宽为0.72° ，SEM图像显示其表面光滑平整，其零电阻温度为106.2K. 关键词： Tl 2212超导薄膜 脉冲激光沉积     

Chalcogenide based all-solid-state thin electroplated ion-selective membrane for Hg(II) flow-injection determinations

The response to Hg(II) of a thin all-solid-state Te-doped silver chalcogenide membrane, described by the general formula Ag₂ + δSe_{1 − x}Te_x, which has been electrochemically prepared following a previously proposed approach, has been investigated. The kinetics of formation of the membrane's secondary dynamic response to Hg(II) has been successfully combined with the precise timing and transient signal, typical for flow-injection (FI) measurements, in developing a sensitive and reliable mercury FI detector. Under optimized stream conditions it exhibits a linear Nernstian response, with a double slope of the calibration graph of 59 mV dec⁻¹, over the mercury(II) concentration range 10⁻⁶ − 10⁻³ M, the typical sample throughput amounting to about 70 samples per hour. The observed chemical amplification of the signal is due to the specificity of the processes dominating the initial step in formation of the steady-state signal of the membrane to mercury. The analytical performance of the Hg(II) FI detector, as regards sensitivity, reproducibility, selectivity and long-term stability has been thoroughly investigated. The exact procedure for membrane electrodeposition is given and the potential of the proposed approach as a cost-effective way for preparing chalcogenides of unique structure and properties has been outlined in the above context.     

Discrete duality finite volume schemes for Leray−Lions−type elliptic problems on general 2D meshes

Discrete duality finite volume schemes on general meshes, introduced by Hermeline and Domelevo and Omnès for the Laplace equation, are proposed for nonlinear diffusion problems in 2D with nonhomogeneous Dirichlet boundary condition. This approach allows the discretization of non linear fluxes in such a way that the discrete operator inherits the key properties of the continuous one. Furthermore, it is well adapted to very general meshes including the case of nonconformal locally refined meshes. We show that the approximate solution exists and is unique, which is not obvious since the scheme is nonlinear. We prove that, for general W^?1,p′(Ω) source term and W^1‐(1/p),p(?Ω) boundary data, the approximate solution and its discrete gradient converge strongly towards the exact solution and its gradient, respectively, in appropriate Lebesgue spaces. Finally, error estimates are given in the case where the solution is assumed to be in W^2,p(Ω). Numerical examples are given, including those on locally refined meshes. © 2006 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq, 2007     

In‐situ synthesis of transparent and conductive carbon nanotube networks

A method for the production of transparent carbon nanotube networks (CNTNs) over transparent substrates was developed. In this method, CNTNs were grown directly in the target surface by applying the catalyst in specific zones of the substrate through lithographic techniques. The networks can be also transferred from the original substrate to other surfaces. The newly grown carbon nanotubes have a very high aspect ratio (>50000). Thus far, networks with an optical transmittance of 94% at 550 nm and a surface resistivity of 3.6 kΩ/sq have been produced. (© 2007 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Structural and lithium intercalation studies of Mn(0.5−x)CaxTi2(PO4)3 phases (0≤x≤0.50)

Materials from the Mn_(0.5−x)Ca_xTi₂(PO₄)₃ (0≤x≤0.50) solid solution were obtained by solid-state reaction in air at 1000 °C. Selected compositions were investigated by powder X-ray diffraction analysis, ³¹P nuclear magnetic resonance (NMR) spectroscopy and electrochemical lithium intercalation. The structure of all samples determined by Rietveld analysis is of the Nasicon type with the R space group. Mn²⁺/Ca²⁺ ions occupy only the M1 sites in the Ti₂(PO₄)₃ framework. The divalent cations are ordered in one of two M1 sites, except for the Mn_0.50Ti₂(PO₄)₃ phase, where a small departure from the ideal order is observed by XRD and ³¹P MAS NMR. The electrochemical behaviour of Mn_0.50Ti₂(PO₄)₃ and Mn_(0.5−x)Ca_xTi₂(PO₄)₃ phases was characterised in Li cells. Two Li ions can be inserted without altering the Ti₂(PO₄)₃ framework. In the 0≤y≤2 range, the OCV curves of Li//Li_yMn_0.50Ti₂(PO₄)₃ cells show two main potential plateaus at 2.90 and 2.50–2.30 V. Comparison between the OCV curves of Li//Li_(1+y)Ti₂(PO₄)₃ and Li//Li_yMn_0.50Ti₂(PO₄)₃ shows that the intercalation occurs first in the unoccupied M1 site of Mn_0.50Ti₂(PO₄)₃ at 2.90 V and then, for compositions y>0.50, at the M2 site (2.50–2.30 V voltage range). The effect of calcium substitution in Mn_0.50Ti₂(PO₄)₃ on the lithium intercalation is also discussed from a structural and kinetic viewpoint. In all systems, the lithium intercalation is associated with a redistribution of the divalent cation over all M1 sites. In the case of Mn_0.50Ti₂(PO₄)₃, the stability of Mn²⁺ either in an octahedral or tetrahedral environment facilitates cationic migration.     

High temperature superconducting thin films for microwave filters

YBa₂Cu₃O_7-δ and Tl₂Ba₂CaCu₂O₈ thin films for microwave filters were synthesized by pulsed laser deposition and the two-step thalliation process. Substrate quality requirements and the relation of thin film morphology, microstructure with microwave surface resistance were discussed.     

Short-range order and F ion diffusion inside the Pb1 − xAlxF2 + x solid solution Part II: Al NMR investigation and proposal of clustering process

A ²⁷Al nuclear magnetic resonance (NMR) investigation at room temperature of the Pb_{1 − x}Al_xF_{2 + x} (0 ≤ x ≤ 0.12) solid solution and of the ordered Pb₉Al₂F₂₄ phase is carried out. Two different types of aluminium ions are identified and their ratio is determined as a function of x. A clustering process based on the formation of column clusters, more and more extended when x increases, is proposed on the basis of results issued from the ¹⁹F (Part I) and ²⁷Al NMR investigations.     

Theoretical prediction of the contact distance dependence of the electron transfer reactivity of the ClO/ClO− coupling system

On the basis of the structures and properties of the ClO/ClO^? system obtained at the density functional theory (DFT) (UB3LYP) level, employing the 6‐311+G(3df) standard basis set, the electron transfer reactivity of this system is investigated. The results indicate that there are five possible stable coupling complexes that correspond to the generous minima on the global potential energy surfaces (PES). The most stable coupling complex is planar EC4, in which there is a O? O linkage with two trans‐Cl atoms. Their stabilization energies are calculated to be 20.57 (EC1: C₁), 20.54 (EC2: C₂, ²B), 20.69 (EC3: C₁), 20.70 (EC4: C_s, ²A′), and 20.69 (EC.5: C_2h, ²B_u) kcal/mol at the B3LYP/6‐311+G(3df) level; with the correction of the basis set superposition error (BSSE), the stability order of these encounter complexes is EC4 > EC.5 > EC3 > EC1 > EC2. Based on the five encounter complexes, five coupling modes are designed for the study of the electron transfer reactivity of this system. The dissociation energy curves at the activated states and the corresponding activation energies of these five coupling modes are obtained and are compared at the B3LYP/6‐311+G(3df) and MP2/6‐311+G* levels. The inapplicability of DFT methods has also been discussed in this article in predicting the energy curves, especially with a long contact distance, in which DFT methods give the abnormal behavior for the dissociations of the complexes caused by the “inverse symmetry breaking” problem. On the basis of the golden rule of the time‐dependent perturbation theory, the electron transfer reactivity and the contact distance dependence of the various electron transfer kinetics parameters (e.g., activation energy, coupling matrix element) have been analyzed at the UMP2(full)/6‐311+G* level. The electron transfer can take place over a range of contact distances, but the most effective coupling distance corresponds to only a small range. The coupling orientation analyses also indicate that the most favorable coupling mode to the electron transfer does not always correspond to the most stable encounter complex mechanism. Some highly energetic coupling modes are more favorable for the electron transfer. © 2004 Wiley Periodicals, Inc. Int J Quantum Chem, 2005