SiOx纳米管的制备及其发光特性

以液态金属镓为媒介,利用热蒸发法合成大量非晶SiOx纳米管,这些纳米管管径均匀分布,平均约80 nm,长度大于10μm,且管内外径比例较小．分析发现,在实验过程中,熔入金属镓液滴中的硅元素和氧元素结合并从液滴的表面饱和析出,形成以镓为中心的非晶SiOx纳米管状结构．在室温中,利用260 nm的激发光源激发SiOx纳米管,发现在蓝光波段附近发出强而稳定的PL谱线,这可能与样品中的氧缺陷和空位有关．     

Volumetric and infrared measurements on amorphous ice structure

We have simultaneously used adsorption isotherm volumetry and Fourier transform infrared spectroscopy in order to take the investigations on amorphous ice structure a step further, especially concerning porosity and annealing-induced modifications. We have studied surface reorganization during annealing and found that the number of surface sites decreases before crystallization, their relative ratios being different for amorphous and crystalline ice. We also present results confirming that ice can have a large specific surface area and nevertheless be non-microporous.     

New insights on amorphous silicon-nitride microcavities

All amorphous silicon-nitride planar optical microcavities operating in the visible range have been grown by plasma enhanced chemical vapor deposition. The luminescence intensity of the N-rich silicon-nitride layer from a microcavity with 6 period distributed Bragg reflectors (DBRs) is two order of magnitude higher than that of the luminescent layer without the cavity. Moreover, a strong directionality of the microcavities emission can be observed. Such results can be ascribed to the anisotropic optical density of states induced in the Fabry–Perot structure. The quality factors of the resonators are strictly correlated to the number of periods of the DBRs.     

Magnetic and electrical transport properties of delta-doped amorphous Ge:Mn magnetic semiconductors

We report on the growth and characterization of delta-doped amorphous Ge:Mn diluted magnetic semiconductor thin films on GaAs (0 0 1) substrates. The fabricated samples exhibit different magnetic behaviors, depending on the Mn doping concentration. The Curie temperature was found to be dependent on both the Mn doping concentration and spacing between the doping layers. A sharp drop in magnetization and rise in resistivity are observed at low temperature in samples with high Mn doping concentrations, which is also accompanied by a negative thermal remanent magnetization (TRM) in the higher temperature range. The temperature at which the magnetization starts to drop and the negative TRM appears show a correlation with the Mn doping concentration. The experimental results are discussed based on the formation of ferromagnetic regions at high temperature and antiferromagnetic coupling between these regions at low temperature.     

Electron-stimulated desorption of D (H) from condensed D2O (H2O) films

The electron-stimulated desorption (ESD) of D⁻ and H⁻ ions from condensed D₂O and H₂O films is investigated. Three low-energy peaks are observed in the ESD anion yield, which are identified as arising from excitation of ²B₁, ²A₁ and ²B₂ dissociative electron attachment (DEA) resonances. Additional structure is observed between 18 and 32 eV, which may be due to ion pair formation or to DEA resonances involving the 2a₁ orbital. The ion yield resulting from excitation of the ²B₁ resonance increases as the film is heated. We attribute the increase in the ion yield to thermally induced hydrogen bond breaking near the surface, which enhances the lifetimes of the excited states that lead to desorption.     

STM/AFM studies of the evolution of morphology of electroplated Ni/W alloys

The surface morphology evolution of Ni/W alloys was studied, as a function of the alloy composition. Using the modified plating baths developed in our laboratory recently, electroplated Ni/W alloys with different W content, in the range of 7–67 atom percent (a/o), can be obtained. This was found to lead to different structures, ranging from polycrystalline fcc-Ni type structure to amorphous, followed by orthorhombic with increasing W content in the alloy. Powder XRD was studied to determine the crystal structures. Ex situ STM, AFM and SEM were used to study in detail the surface morphologies of the different alloys, and their evolution with increasing W content.

The important findings are that a mixture of two crystalline forms can give rise to an amorphous structure. Hillocks that are usually a characteristic of epitaxial growth can also exist in the amorphous alloys. Oriented scratches caused by stress can also be formed.

Up to 20 a/o of W is deposited in the alloys in crystalline form, with the fcc-Ni type structure. Between 20 and about 40 a/o an amorphous structure is observed, and above that an orthorhombic crystal structure is seen, which is characteristic of the NiW binary alloy. Careful choice of the composition of the plating bath allowed us to deposit an alloy containing 67 a/o W, which corresponds to the composition NiW₂.     

Glass-forming liquids,anomalous liquids,and polyamorphism in liquids and biopolymers

Summary Glass formation in nature and materials science is reviewed and the recent recognition of polymorphism within the glassy state, polyamorphism, is discussed. The process by which the glassy state originates during the continuous cooling or viscous slowdown process, is examined and the three canonical characteristics of relaxing liquids are correlated through the fragility. The conversion of strong liquids to fragile liquids by pressure-induced coordination number increases is discussed, and then it is shown that for the same type of system it is possible to have the same conversion accomplished via a first-order transition within the liquid state. The systems in which this can happen are of the same type which exhibit polyamorphism, and the whole phenomenology can be accounted for by a recent simple modification of the van der Waals model for tetrahedrally bonded liquids. The concept of complex amorphous systems which can lose a significant number of degrees of freedom through weak first-order transitions is then used to discuss the relation between native and denatured hydrated proteins, since the latter have much in common with plasticized chain polymer systems. Finally, we close the circle by taking a short-time-scale phenomenon given much attention by protein physicists,viz., the onset of an anomaly in the Debye-Waller factor with increasing temperature, and showing that for a wide variety of liquids, including computer-simulated strong and fragile ionic liquids, this phenomenon is closely correlated with the experimental glass transition temperature. This implies that the latter owes its origin to the onset of strong anharmonicity in certain components of the vibrational density of states (evidently related to the boson peak) which then permits the system to gain access to its configurational degrees of freedom. The more anharmonic these vibrational components, the closer to the Kauzmann temperature will commence the exploration of configuration space and, for a given configurational microstate degeneracy, the more fragile the liquid will be. Paper presented at the I International Conference on Scaling Concepts and Complex Fluids, Copanello, Italy, July 4–8, 1994.     

Growth process of TiC clusters from Ti nanoparticles with evaporated carbon layer

Titanium carbide formation by the solid–solid reaction on the surface of Ti nanoparticles was studied in situ using a high-resolution transmission electron microscope with a heating stage. The cross-sectional image of the Ti surface was clearly observed. Vacuum-deposited carbon covered the whole the surface of Ti nanoparticles in spite of the partly evaporation on the nanoparticle surface. The diffusion of the carbon atoms inside the Ti nanoparticles depended on the size of the nanoparticles. When the Ti nanoparticle diameter was less than 30 nm, carbon atoms diffused into the Ti nanoparticle and formed TiC. The superstructure of the Ti nanoparticles was observed, which revealed the growth process of TiC to be the diffusion of carbon atoms. For Ti nanoparticles with diameter larger than 30 nm it was observed that diffusion of Ti atoms into the carbon layer was dominant, which resulted in formation of TiC in the carbon layer at the surface of Ti nanoparticles.     

Self-organized amorphous material in silicon (0 0 1) by focused ion beam (FIB) system

A method using a focused ion beam (FIB) to prepare a silicon amorphous material is presented. The method involves the redeposition of sputtered material generated during the interaction of the Ga⁺ ion beam with a silicon substrate material. The shape and dimensions of this amorphous material are self-organized and reproducible. The stability of this amorphous material under electron irradiation was investigated in the transmission electron microscopy (TEM). Electron irradiation can induce recrystallization of the amorphous material, resulting in the lateral and vertical growth, starting at an amorphous-crystalline interface, of polysilicon containing defects.     

Annealing effects on the magnetization of Co–Ni–B amorphous nanoparticles

Chemically prepared (Co_xNi_1−x)_1−yB_y (x=0.5, 0.75, 1; y≈0.4) amorphous fine particles were characterized by X-ray diffraction, DTA and TGA, and in situ magnetic measurement as a function of annealing temperature in an inert atmosphere. Magnetic measurement performed in as-prepared and 150°C annealed samples shows an increase of the saturation magnetization and magnetic moment after thermal treatment. Room temperature magnetization increases by factors of 3.5, 1.8, and 1.5, for x=0.5, 0.75, and 1, respectively. These measurements may indicate a local re-ordering of the amorphous phase at temperatures much lower than the full crystallization temperature.