Novel alternating copolyoxamides with high crystallinity and heat resistance

Two series of novel alternating copolyoxamides (PAnT-alt-n2 and PAn2-alt-62) are synthesized via solution/solid-state polycondensation (SSP). The alternating structures are analyzed carefully with ¹H NMR and ¹³C NMR spectra. The melting behaviors, thermal stabilities, crystal structures and crystallinities are systematically evaluated by DSC, TGA and WAXD. The results reveal that these alternating copolyoxamides possess almost perfect alternating chain structures and have high melting temperature (T_m > 270 °C), high crystallinity (X_c > 32%) and high decomposition temperature (T₅ > 405 °C) as well as low saturated water absorption (<3.5 wt%), which suggests that they have high potential as engineering plastic of high heat resistant.     

(Ni0.81Fe0.19)1-xCrx作为种子层对NiFe/FeMn交换偏置的影响

采用一种新的种子层材料:(Ni081Fe019)1-xCrx,通过改变种子层中Cr原子的含量,使得在其上生长的NiFeFeMn双层膜的织构和晶粒尺寸产生极大的差异,系统研究了NiFeFeMn双层膜中FeMn晶粒尺寸和织构对交换偏置的影响.实验结果表明,在FeMn的γ相(111)织构较好的前提下,交换偏置场的大小与织构的差异没有关系;FeMn的晶粒尺寸对交换偏置场有很大影响,较小的反铁磁层晶粒对交换偏置场有利,过大的反铁磁层晶粒不利于交换偏置场.将(Ni081Fe019)05Cr05与传统的种子层材料Ta进 关键词： 交换偏置 晶粒尺寸 织构 种子层     

Physical properties and phase separation structure of Antheraea pernyi/Bombyx mori silk fibroin blend films

The physical structure and compatibility of solution-cast Antheraea pernyi/Bombyx mori silk fibroin blend films were stuided by differential scanning calorimetry (DSC), thermomechanical (TMA) and thermogravimetric (TGA) analysis, dynamic viscoelastic measurement, infrared spectroscopy, and x-ray diffractometry. The DSC curves of the blend films showed independent endotherms at 280 and 358°C, corresponding to the thermal decomposition of B. mori and A. pernyi silk fibroins with random coil conformation. The intensity was roughly proportionate to the amount of each component in the blend. The thermal behavior corresponding to the conformational transitions induced by heating on A. pernyi and B. mori silk fibroins overlapped in the temperature range 190–230°C. Thermal expansion and contraction properties, as well as weight retention behavior of the blend films were intermediate between the pure components, as shown by the TMA and TGA curves. The onset temperature of the storage modulus curve decreased markedly, approaching that of B. mori silk fibroin film when the amount of this component in the blend increased. The loss modulus curve of the blend films showed two peaks at ca. 190 and 210°C, the former corresponding to B. mori, and the latter to A. pernyi silk fibroin. Infrared spectra of the blends exhibited absorption bands characteristic of the pure components overlapping in the spectral region 2000–400 cm^?1. The x-ray diffraction peaks at 23 and 21.5°, attributed to the crystalline spacings of A. pernyi and B. mori fibroins, respectively, overlapped in the diffraction curves of the blends, while the peak at 11.4°, of A. pernyi, increased as the content of this fibroin in the blend increased. The degree of crystallinity, calculated from the x-ray diffraction curves, diminished as the amount of B. mori silk fibroin decreased. A low degree of compatibility exists between the two fibroins when they are cast from aqueous solution in the experimental conditions adopted in this work. © 1994 John Wiley & Sons, Inc.     

Crystalline structure of polyamide 12 as revealed by solid‐state 13C NMR and synchrotron WAXS and SAXS

The crystalline structure of polyamide‐12 (PA12) was studied by solid‐state ¹³C nuclear magnetic resonance (NMR) as well as by synchrotron wide‐ and small‐angle X‐ray scattering (WAXS and SAXS). Isotropic and oriented PA12 showed different NMR spectra ascribed to γ‐ and γ′‐crystalline modifications, respectively. On the basis of the position of the first diffraction peak, the isotropic γ‐form and the oriented γ′‐form were shown to be with hexagonal crystalline lattice at room temperature. When heated, the two PA12 polymorphs demonstrated different behaviors. Above 140 °C, the isotropic γ‐PA12 partially transformed into α‐modification. No such transition was observed with the oriented γ′‐PA12 phase even after annealing at temperatures close to melting. A γ′–γ transition was observed here only after isotropization by melting point. Various structural parameters were extracted from the WAXS and SAXS patterns and analyzed as a function of temperature and orientation: the degree of crystallinity, the d‐spacings, the Bragg's long spacings, the average thicknesses of the crystalline (l_c) and amorphous (l_a) phases, and the linear crystallinity x_cl within the lamellar stacks. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 3720–3733, 2005     

Effects of Calcination on the Physical and Photocatalytic Properties of TiO<Subscript>2</Subscript> Powders Prepared by Sol–Gel Template Method

TiO₂ powders were prepared by sol–gel template method and calcined under different conditions. XRD, BET and TEM were used to characterize the TiO₂ powders obtained. The photocatalytic activity of TiO₂ was investigated by the degradation of methyl orange. It was found that TiO₂ powder has the highest photocatalytic activity at a calcination temperature of 673 K. The effects of physical properties such as surface area, crystallinity and crystal phase on the photocatalytic activity of TiO₂ were discussed.     

A simulation of thermal characteristic parameters with an inverse “S” type curve

A synthetical equation is proposed to characterize the essential features of the inverse “S” type curve on the basis of summing-up simulation approach of “S” type curve. The two physical variables in the model obtained are discussed and the detailed method used to determine the parameters is given. The model is then presented to describe the crystallization of poly(caryleher ether ketone) (PEEK) and thermal decomposition of poly(amide-imide) (PAI) respectively. It is found that some thermal characteristic parameters can be well estimated from the model simu-lated in computer.     

溶剂对固相反应法制备H7PW12O42掺杂聚苯胺的影响

利用固相反应法,分别以微量的水和乙腈作为溶剂,制备了磷钨酸(H7PW12O42)掺杂聚苯胺,并以红外光谱(FTIR),电子扫描显微镜(SEM),X射线衍射(XRD),循环伏安(cyclic voltamogram)等测试方法对聚苯胺进行了表征。结果表明,固相反应法合成的聚苯胺分子链排列有序,晶化率较好,并且表现出有较好的电化学稳定性。而以微量的乙腈作为溶剂通过固相反应法得到的磷钨酸掺杂聚苯胺在颗粒形貌、结晶性、导电率等方面均优于相同条件微量的水作为溶剂时的掺杂聚苯胺。     

FTIR and WAXS analysis of periodate oxycellulose: Evidence for a cluster mechanism of oxidation

Cellulose paper (Whatman no.1, chromatographic grade) was oxidised with 0.1 M sodium metaperiodate at different oxidation levels (0–11 days at room temperature), and analysed with FTIR before and after chemical treatments (reduction, further oxidation, alkaline hydrolysis). The deconvolution of infrared data allowed us to verify that periodate oxidises cellulose in isolated domains, leading to the decrease of crystallinity, in agreement with the results of wide angle X-ray scattering (WAXS). In particular, the alkaline hydrolysis (β-alkoxy fragmentation) followed by mild acid treatment removed the oxidised groups and recovered most of the crystallinity of cellulose, as determined by the FTIR crystallinity index.     

Ageing of Conductive Polyaniline/Poly(Ethylene-co-Vinylacetate) Composites Studied by Thermal Methods

The long-term environmental ageing of conductive composite films containing ethylene-co-vinyl-acetate (EVA) copolymer and a complex of polyaniline (PANI) and dodecylbenzenesulfonic acid (DBSA) was studied by using differential scanning calorimetry (DSC). We assume that both phase separation and crosslinking of PANI main chains occur in the systems. On the other hand, the competition between PANI–DBSA complex self-organization and crystallization of EVA matrix result in structural changes and formation of continuous conductive network, responsible for significantly increased (ca five orders of magnitude) electrical conductivity of the aged films. This revised version was published online in August 2006 with corrections to the Cover Date.     

ABA／PET液晶共聚酯酰胺的结构与性能

研究了对象基苯甲酸（ＡＢＡ）／聚对苯二甲酸乙二酯（ＰＥＴ）液晶共聚酯酰胺的晶体结构，以及热性能、流变学和力学性质。广角Ｘ射线衍射研究结果表明ＡＢＡ链节的引入使ＰＥＴ的晶态结构发生畸变，但大部分结晶衍射峰仍然存在。随着ＡＢＡ含量的增加，各晶面间距基本不变，微晶尺寸显著增大，结晶度急剧降低。差示扫描量热分析和热失重结果表明共聚酯胺具有优良的热稳定性，并且随着ＡＢＡ含量的增加，共聚物的热稳定性提高，共聚