Polymer electrolyte membranes for the direct methanol fuel cell: A review

The direct methanol fuel cell (DMFC) has the potential to replace lithium‐ion rechargeable batteries in portable electronic devices, but currently experiences significant power density and efficiency losses due to high methanol crossover through polymer electrolyte membranes (PEMs). Numerous publications document the synthesis and characterization of new PEMs for the DMFC. This article reviews this research, transport phenomena in PEMs, and experimental techniques used to evaluate new PEMs for the DMFC. Although many PEMs do not show significant improvements over Nafion®, the benchmark PEM in DMFCs, experimental results show that several new PEMs exhibit lower methanol crossover at similar proton conductivities and/or higher DMFC power densities. These results and recommendations for future research are discussed. © 2006 Wiley Periodicals, Inc. J Polym Sci Parts B: Polym Phys 44: 2201–2225, 2006     

Studies on solution cast perfluorocarbonsulfonic acid ionomers

The thermal properties of perfluorocarbonsulfonic acid ionomer films cast from solution and their temperature-dependent far infrared spectra have been investigated. In addition to the endotherms and spectral changes associated with the loss of solvent as the films were heated, a significant exotherm has been observed and assigned to the relaxation associated with rearrangements resulting in partially crystallized phases in insoluble thermally treated membranes. © 1993 John Wiley & Sons, Inc.     

网间交联型增韧环氧树脂/蓖麻油聚氨酯互穿网络聚合物的动态力学性能和形态结构

以增韧环氧树脂(TEP)和蓖麻油聚氨酯[PU(CO)]形成的互穿网络聚合物(IPN),两网络间具有一定数量的交联点,在一定组成下,该IPN的tanδ-T曲线半峰宽达100℃,tanδ最大值接近1,阻尼性能良好。形态研究表明,该IPN既有增韧环氧树脂本身的两相结构,又有IPN的两相结构。     

形状记忆聚氨酯研究进展

对形状记忆聚合物(主要以聚氨酯为例)的总体研究概况、合成方法、表征手段、数学模型等方面进行了综述。     

离聚体的结构表征——Ⅴ.含氟离聚体中离子微区稳定性的研究

本文用DSC方法研究了羟酸型含氟离聚体中不同金属离子种类、可离子化基团含量、配位结构单元构型及离子微区大小对离聚体中离子微区稳定性的影响。实验表明:离聚体中金属离子配位能力愈强,羟酸含量愈高,离子微区尺寸愈大,则相应离聚体中离子微区稳定性愈大。铅高聚体>锌离聚体>钙离聚体>钠离聚体。     

Bestimmung wasserlöslicher Polyelektrolyte in Polyurethan-Dispersionen

Zusammenfassung Die Bestimmung wasserlöslicher Polyelektrolyte, die bei der Synthese segmentierter Polyurethanionomerer entstehen, erfolgte durch konduktometrische und potentiometrische Titrationsverfahren nach Abtrennung des Serums durch Ultrazentrifugieren oder Ausfrieren des Polymeren bzw. Abtrennung der wasserlöslichen Elektrolyte mit einem gemischten Ionenaustauscher. Diese Elektrolyte enthielten abhängig von der Rezeptur zwischen 25 und 72% der vorgegebenen Ionenkonzentration. Unterstellt man glatte, kugelförmige Latexpartikeln, so beträgt die Fläche pro festhaftende ionische Gruppe nur 60–170 Ų, wodurch eine erhebliche gegenseitige Beeinflussung der Ionen resultiert.Herrn Prof. Dr. Ing. Dr. h.c. mult. H. Zahn zum 65. Geburtstag gewidtmet (O. L.).     

SYNTHESIS, CROSSLINKING MECHANISM AND PROPERTIES OF A POLYACRYLATE/POLYURETHANE COMPOSITE COATING

A polyacrylate/polyurethane (P(A) / P(U)) composite coating has been prepared bycrosslinking an acetoacetylated polyacrylate with a vinylic group terminated polyurethaneat room temperature. A model Michael reaction between ethyl acetoacetate (EAA) andmethyl acrylate (MA) was designed to study the crosslinking mechanism. It was foundthat the two active hydrogen atoms in acetoacetyl group can both add to vinylic groupsand the yield of mono- and bis-adducts are much affected by the molar ratio of acetoacetylto vinylic groups. Higher crosslinking degree and better properties could be obtained withdecreasing the molar ratio of the two active groups from 1/1 to 0.6/1 in the compositecoatings.     

聚醚聚氨酯双离子型离聚物的介电性能研究

以4,4＇-二苯基甲烷二异氰酸酯(MDI)、N-甲基二乙醇胺(MDEA)和聚四氢呋喃(PTMD)以2:1:1(mol比)合成聚醚型聚氨酯,MDEA的叔胺基与γ-丙磺内酯反应,制备了不同磺化程度的双离子型离聚物.在不同温度与频率(-150-30℃,20Hz—100KHz)下,测定了其介电性能.结果表明,随离子化程度的提高,ε＇增大,α弛豫介电损耗峰移向低温,说明相分离越趋完善;β弛豫单元的活化能(△Hβ)基本不变;α弛豫单元的活化能(△Hα)依次变小.介电测量结果与动态力学方法研究结果相吻合.     

聚环氧氯丙烷氨酯阻尼材料的阻尼性能研究

<正> 一般来讲,聚合物材料的阻尼性能来源于分子链运动带来的内摩擦力以及分子间物理键的破坏与再生,分子链运动所产生的阻尼在聚合物的玻璃化转变温度范围内最为有效。因此具有极性较强、体积较大的一CH_2Cl侧基的环氧氯丙烷聚合物应具有优异的阻尼性能,专利文献[1—2]报道过由多羟基(官能度≥2)聚环氧氯丙烷预聚物为原料制得的聚氨酯泡沫具有良好的阻燃性能,作者在聚环氧氯丙烷氨酯阻尼材料方面进行了尝试。