Crosslinking network of bio‐based bis‐functional epoxides derived from trans‐limonene oxide

The thiol‐ene reaction between trans‐limonene oxide (trans‐LO) and ethane‐1,2‐dithiol in the presence of triethylborane affords a bio‐based bis‐functional epoxide (bis‐trans‐LO). The crosslinking reaction of bis‐trans‐LO with branched polyethyleneimine (BPEI; M_n = 600; BPEI₆₀₀) at a feed ratio of bis‐trans‐LO/BPEI₆₀₀ = 57/43 (wt/wt) yields the corresponding network polymer with T_d10 (10% thermal decomposition temperature) of 304.7 °C in 98% yield. In contrast, negligible amounts of network polymer are obtained by the reaction of bis‐LO (bis‐functional epoxide derived from cis and trans‐LO) and BPEI₆₀₀ regardless of the feed ratio. The mechanical strengths as measured by direct tensile tests of the network polymers derived from bis‐trans‐LO and BPEI_600,1800 (M_n = 600 and 1800) were approximately 16 and 11 times higher than that of bis‐LO and BPEI₁₈₀₀, respectively. The tensile shear strengths of the metal‐to‐metal adhesive bonds induced by bis‐trans‐LO and BPEI_600,1800 were 9.5 and 14.1 MPa, respectively. DMA revealed that the storage modulus of the network polymer derived from bis‐trans‐LO and BPEI₁₈₀₀ in the rubber region was higher than that of the material prepared from bis‐LO and BPEI₁₈₀₀, indicating higher crosslink density of the bis‐trans‐LO/BPEI₁₈₀₀ system. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019 , 57, 2466–2473     

Simulation of a High Harmonic Gyrotron with Axis-Encircling Electron Beam and Permanent Magnet

A computer code for simulation of beam-field interaction in a resonant cavity of a gyrotron has been developed. It is based on a self-consistent, time-independent, single-mode physical model. The code has been applied to the analysis of the electrodynamical system of a novel high-harmonic gyrotron with axis-encircling beam and a permanent magnet. In this paper both the physical model and numerical techniques used are outlined. Some results of the numerical experiments are presented and discussed.     

Polymerization of 1,3‐dienes with functional groups. III. Free‐radical polymerization of N,N‐diethyl‐2‐methylene‐3‐butenamide

Free‐radical homo‐ and copolymerization behavior of N,N‐diethyl‐2‐methylene‐3‐butenamide (DEA) was investigated. When the monomer was heated in bulk at 60 °C for 25 h without initiator, rubbery, solid gel was formed by the thermal polymerization. No such reaction was observed when the polymerization was carried out in 2 mol/L of benzene solution with with 1 mol % of azobisisobutyronitrile (AIBN) as an initiator. The polymerization rate (R_p) equation was R_p ∝ [DEA]^1.1[AIBN]^0.51, and the overall activation energy of polymerization was calculated 84.1 kJ/mol. The microstructure of the resulting polymer was exclusively a 1,4‐structure where both 1,4‐E and 1,4‐Z structures were included. From the product analysis of the telomerization with tert‐butylmercaptan as a telogen, the modes of monomer addition were estimated to be both 1,4‐ and 4,1‐addition. The copolymerizations of this monomer with styrene and/or chloroprene as comonomers were also carried out in benzene solution at 60 °C. In the copolymerization with styrene, the monomer reactivity ratios obtained were r₁ = 5.83 and r₂ = 0.05, and the Q and e values were Q = 8.4 and e = 0.33, respectively. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 999–1007, 2004     

Distributions of major-to-ultratrace elements among the particulate and dissolved fractions in natural water as studied by ICP-AES and ICP-MS after sequential fractionation.

In order to elucidate the distributions of the elements among the particulate and dissolved fractions in pond water, major-to-ultratrace elements in different sizes of particles as well as in the filtrate passed through the 0.05 microm filter were determined by inductively coupled plasma atomic emission spectrometry (ICP-AES) and inductively coupled plasma mass spectrometry (ICP-MS). The different sizes of particle samples (ca. 100-300 microg each) were collected on the membrane filters with pore sizes of 10, 3.0, 1.2, 0.4, 0.2 and 0.05 microm, respectively, by sequential fractionation. As a result, about 40 elements in different sizes of particles could be determined by ICP-AES and ICP-MS, after acid digestion using HNO3/HF/HClO4. Then, the fractional distribution factors of major-to-ultratrace elements among the particulate and dissolved fractions were estimated from the analytical results. The total contents of Al, Fe, Ti, REEs (rare earth elements), Bi, Pb and Ag in the particulate fractions (larger than 0.05 microm) were more than 80-90%, while those of Ca, Sr, Cs, W, Ba, Mn and Co in the dissolved fraction, which corresponded to the filtrate passed through the 0.05 microm membrane filter, were more than 80%. It was further found that the fractional distributions of Cu and Zn in the dissolved fraction were ca. 50%. In addition, the enrichment factors (EFs) of the elements in the particulate fractions with particle sizes of 3.0-10 microm and 0.05-0.2 microm were estimated to elucidate their geochemical characteristics in natural water.     

Interfacial adsorption state of protonated lipophilic porphyrins in a liquid-liquid system by using reflection spectrometry.

Analysis by reflection spectrometry was performed to clarify the interfacial adsorption of protonated lipophilic tetraphenylporphyrin derivatives in a dodecane-aqueous sulfuric acid system, and to confirm the utility of partial reflection spectroscopy. Interfacial adsorption was not observed for porphyrins substituted at the 2,6 positions of meso-phenyl groups, suggesting that the substituents prevent porphyrins from forming aggregates by steric hindrance. Polymorphous J-aggregates of acid dications were produced by tetra-p-tolylporphyrin with a saturated interfacial molecular density of 1.0 x 10(-10) mol cm(-2), which could yield 48 degrees as a mean tilting angle of the pyrrole ring plane from the interface normal. Partial-reflection spectrometry can provide sensitive detection and molecular orientation analysis of interfacial adsorbates.     

A simple and sensitive method for the determination of hydroxylamine in fresh-water samples using hypochlorite followed by gas chromatography.

A new and simple method for the determination of hydroxylamine in environmental water, such as fresh rivers and lakes using hypochlorite, followed by its gas choromatographic detection, has been developed. A glass vial filled with sample water was sealed by a butyl-rubber stopper and aluminum cap without head-space, and then sodium hypochlorite solution was injected into the vial through a syringe to convert hydroxylamine to nitrous oxide. The head-space in the glass vial was prepared with 99.9% grade N2 using a gas-tight syringe. After the glass vial was shaken for a few minutes, nitrous oxide in the gas-phase was measured by a gas chromatograph with an electron-capture detector. The dissolved nitrous oxide in the liquid-phase was calculated according to the solubility formula. The proposed method was applied to the analysis of fresh-water samples taken from Iu river and Hii river, flowing into brackish Lakes Nakaumi and Shinji, respectively.     

Gamma-ray spectroscopy of the neutron-rich Ni region through heavy-ion deep-inelastic collisions

Nuclei in the neutron-rich Ni region have been studied by γ-ray spectroscopy. Gamma-rays emitted from isomers, with T _1/2 > 1 ns, produced in heavy-ion deep-inelastic collisions were measured with an isomer-scope. The nuclear structure of the doubly magic ⁶⁸Ni and its neighbor ^69,71Cu is discussed on the basis of the shell model. Future experiments for more neutron-rich Ni nuclei are also viewed. Received: 1 May 2001 / Accepted: 4 December 2001     

Application of Novel Focusing Mirrors in Gyrotron Transmission Lines

A novel focusing mirror based on the shifting of the beam phase according to the Gaussian beam optics enabled us to realize a focusing elements with different focal lengths in different directions and to convert the gyrotron output into a Gaussian-like beam. In this paper, we compare the quality of beams produced by the new system (which includes novel mirrors) and a conventional system consisting of a quasi-optical antenna, an ellipsoidal mirror and two parabolic cylinder mirrors.     

High-quality InAlN/GaN heterostructures grown by metal–organic vapor phase epitaxy

We fabricated high-quality InAlN/GaN heterostructures by metal–organic vapor phase epitaxy (MOVPE). X-ray diffraction measurements revealed that InAlN/GaN heterostructures grown under optimal conditions have flat surfaces and abrupt heterointerfaces. Electron mobility from 1200 to 2000 cm²/V s was obtained at room temperature. To our knowledge, this mobility is the highest ever reported for InAlN/GaN heterostructures. We also investigated the relationship between the Al composition and sheet electron density (N_s) for the first time. N_s increased from 1.0×10¹² to 2.7×10¹³ cm⁻² when the Al composition increased from 0.78 to 0.89.