MCNOs/CdS双效光催化剂的制备及其性能研究

水热合成法制备了不同磁性纳米洋葱碳(MCNOs)负载量(0%、1%、3%、5%)的MCNOs/CdS光催化剂。并通过X射线衍射分析(XRD)、扫描电子显微镜(SEM)、傅里叶红外光谱(FT-IR)、X射线光电子能谱(XPS)、紫外可见光光谱(UV-Vis)、磁滞回线测定仪(VSM)对其进行表征,探究了MCNOs负载比例对催化剂在可见光下降解RhB性能及机理的影响。结果表明,MCNOs能有效提高CdS的光催化效果,复合3%MCNOs后降解率为96%,与纯CdS相比降解率提高了30%,磁性分析表明,其具有良好的顺磁性并能实现催化剂的有效回收。MCNOs/CdS在可见光下催化降解RhB的一级反应动力学直线有较好的拟合度,表明制备的催化剂有较好的催化活性。     

单面柱局域共振声子晶体低频带隙特性分析及结构改进研究

基于有限元法对单面柱局域共振声子晶体进行带隙特性分析,研究了结构参数对该类型声子晶体的影响。结果表明:随着散射体高度的增加,单面柱声子晶体的第一完全带隙的起始频率逐渐降低,带宽逐渐增大;随着基板厚度的增大,单面柱声子晶体的起始频率逐渐升高,截止频率先增大后减小。并且在经典单面柱声子晶体的基础上,组合了两种新型的三组元单面柱声子晶体结构:嵌入式单面柱声子晶体(以下简称结构Ⅰ)和粘接式单面柱声子晶体(以下简称结构Ⅱ)。通过对其带隙特性的分析得出:这两种新结构与经典的单面柱声子晶体相比,都具有更低频的带隙,这对于低频减振降噪是非常有利的。本文的结果将对实际的工程应用提供一定的理论指导。     

Flow-induced shear stress and deformation of a core–shell-structured microcapsule in a microchannel

A numerical model was developed and validated to investigate the fluid–structure interactions between fully developed pipe flow and core–shell-structured microcapsule in a microchannel. Different flow rates and microcapsule shell thicknesses were considered. A sixth-order rotational symmetric distribution of von Mises stress over the microcapsule shell can be observed on the microcapsule with a thinner shell configuration, especially at higher flow rate conditions. It is also observed that when being carried along in a fully developed pipe flow, the microcapsule with a thinner shell tends to accumulate stress at a higher rate compared to that with a thicker shell. In general, for the same microcapsule configuration, higher flow velocity would induce a higher stress level over the microcapsule shell. The deformation gradient was used to capture the microcapsule's deformation in the present study. The effect of Young's modulus on the microcapsule shell on the microcapsule deformation was investigated as well. Our findings will shed light on the understanding of the stability of core–shell-structured microcapsule when subjected to flow-induced shear stress in a microfluidic system, enabling a more exquisite control over the breakup dynamics of drug-loaded microcapsule for biomedical applications.     

Characterization of diterpene metabolism in rats with ingestion of seed products from Euphorbia lathyris L. (Semen Euphorbiae and Semen Euphorbiae Pulveratum) using UHPLC-Q-Exactive MS

Previous pharmacological studies have indicated that diterpenoids are the primary effective chemical cluster in the seeds of Euphorbia lathyris L. The seed products are used in traditional Chinese medicine in the forms of Semen Euphorbiae (SE) and Semen Euphorbiae Pulveratum (SEP). However, the metabolism of the plant's diterpenoids has not been well elucidated, which means that the in vivo metabolite products have not been identified. The current study screened the physiological metabolites of six diterpenes [Euphorbia factor L₁ (L1), L₂ (L2), L₃ (L3), L_7a (L7a), L_7b (L7b), and L₈ (L8)] in feces and urine of rats after oral administration of SE and SEP using UHPLC-Q-Exactive MS. A total of 22 metabolites were detected in feces and 8 in urine, indicating that the major elimination route of diterpenoids is via the colon. Hydrolysis, methylation, and glucuronidation served as the primary metabolic pathways of these diterpenoids. In sum, this study contributed to the elucidation of new metabolites and metabolic pathways of SE and SEP, and the new chemical identities can be used to guide further pharmacokinetic studies.     

In vitro and in vivo evaluation of a novel anti-EGFR antibody labeled with 89Zr and 177Lu

Journal of Radioanalytical and Nuclear Chemistry - There is an urgent need to develop more specific targeted therapies for lung cancer treatment due to the its low survival rate. EGFR is a...     

TFSI钝化晶体硅表面性质的第一性原理研究

晶体硅表面钝化是高效率晶体硅太阳能电池的核心技术,直接影响晶体硅器件的性能。本文采用第一性原理方法研究了一种超强酸-双三氟甲基磺酰亚胺(TFSI)钝化晶体硅(001)表面。研究发现,TFSI的四氧原子结构能够与Si(001)表面Si原子有效成键,吸附能达到-5.124 eV。电子局域函数研究表明,TFSI的O原子与晶体硅表面的Si的成键类型为金属键。由态密度和电荷差分密度分析可知,Si表面原子的电子向TFSI转移,从而有效降低了Si表面的电子复合中心,有利于提高晶体硅的少子寿命。Bader电荷显示,伴随着TFSI钝化晶体硅表面的Si原子,表面Si原子电荷电量减少,而TFSI中的O原子和S原子电荷电量相应增加,进一步证明了TFSI钝化Si表面后的电子转移。该工作为第一性原理方法预测有机强酸钝化晶体硅表面的钝化效果提供了数据支撑。     

全局优化问题的一个新的无参数填充函数

求全局最优化问题的填充函数算法被提出以来，参数的选取和调整一直是制约算法有效性的因素。如何在实际的计算过程中选取合适的参数，直接影响和决定了运算速度和效率。因此，构造不含参数的填充函数就显得极为重要。提出一个新的无参数的填充函数，对其理论性质进行了分析，并给出相应的填充函数算法，数值计算验证了算法的有效性。     

n型IBC太阳电池选择性发射极工艺研究

为提升n型叉指背接触(IBC)太阳电池的光电转换效率,采用丝网印刷硼浆和高温扩散的方式形成选择性发射极结构,研究了硼扩散和硼浆印刷工艺对电池发射极钝化性能和接触性能的影响。实验结果表明,在硼扩散沉积时间和退火时间一定的条件下,硼扩散通源(BBr₃)流量为100 mL/min,沉积温度为830 ℃,退火温度为920 ℃时,发射极轻掺杂(p⁺)区域的隐开路电压达到710 mV,暗饱和电流密度为12.2 fA/cm²。发射极局部印刷硼浆湿重为220 mg时,经过高温硼扩散退火,重掺杂(p⁺⁺)区域的隐开路电压保持在683 mV左右,该区域方块电阻仅46 Ω/□,金属接触电阻为2.3 mΩ·cm². 采用该工艺方案制备的IBC电池最高光电转换效率达到24.40%,平均光电转换效率达到24.32%,相比现有IBC电池转换效率提升了0.28个百分点。