污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能研究

亚甲基蓝和环丙沙星是水体中2种污染物, 对生态环境有潜在危害. 本文以市政剩余活性污泥为原料, 氯化锌为活化剂热解制备污泥基吸附剂, 研究盐酸酸洗浓度、氯化锌浓度、热解温度、热解时间等对污泥基吸附剂吸附水中亚甲基蓝和环丙沙星性能的影响. 结果表明 (1)污泥基吸附剂对亚甲基蓝的吸附性能随盐酸酸洗浓度的增大而增加, 对环丙沙星的吸附性能则随盐酸酸洗浓度的增大呈先降后增趋势, 两者均在1.500mol·L-1盐酸浓度下取得最优值. (2)污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能随氯化锌浓度和热解温度的增加呈先升后降趋势, 在氯化锌浓度为4.0mol·L-1、热解温度为500℃时有最优值; 随着热解时间的延长, 污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能分别在500℃热解70min和80min时有最优值. (3)污泥基吸附剂的最佳制备条件为 氯化锌4.0mol·L-1活化2h、500℃热解70min和80min、1.500mol·L-1盐酸酸洗; 以此制得的污泥基吸附剂对亚甲基蓝和环丙沙星的去除率分别为97.7%和96.4%, 平衡吸附量分别为97.9mg·g-1和3.9mg·g-1, 且污泥基吸附剂对亚甲基蓝和环丙沙星的吸附过程均符合准二级动力学方程.     

Photoinduced dynamics of a cyanine dye: parallel pathways of non-radiative deactivation involving multiple excited-state twisted transients

Cyanine dyes are broadly used for fluorescence imaging and other photonic applications. 3,3′-Diethylthiacyanine (THIA) is a cyanine dye composed of two identical aromatic heterocyclic moieties linked with a single methine, –CH. The torsional degrees of freedom around the methine bonds provide routes for non-radiative decay, responsible for the inherently low fluorescence quantum yields. Using transient absorption spectroscopy, we determined that upon photoexcitation, the excited state relaxes along two parallel pathways producing three excited-state transients that undergo internal conversion to the ground state. The media viscosity impedes the molecular modes of ring rotation and preferentially affects one of the pathways of non-radiative decay, exerting a dominant effect on the emission properties of THIA. Concurrently, the polarity affects the energy of the transients involved in the decay pathways and further modulates the kinetics of non-radiative deactivation.     

Chemical equilibrium controlled synthesis of polyoxymethylene dimethyl ethers over sulfated titania

The chemical equilibrium and reaction kinetic behavior in the synthesis of polyoxymethylene dimethyl ethers(DMMn) were investigated over sulfated titania in order to reveal the decisive factor controlling the reaction. The results showed that the molar ratio of adjacent DMMn products in equilibrium solution had the same value, which depended absolutely on the reaction temperature. Meanwhile, the reactions had the same DMMn products distributions under varied reaction conditions. The equilibrium constants of the related step-wise reactions for DMMn formation were equal, which were calculated based on the bulk compositions of the reaction solution. And thus, the selectivity to DMMn was mainly controlled by the chemical equilibrium, i.e., thermodynamic control. In brief, the present results provide some guidance for future synthesis of DMMn.     

Xe对NO(X)微分截面和非弹性散射中的碰撞诱导旋转准直

本文对NO(X)-Xe碰撞系统在碰撞能量为519 cm^-1，测量了完全?-双峰分解的微分截面和碰撞引起的旋转准直力矩. 同时结合初始量子态选择，使用六极杆的非均质电场，借助量子态分辨的测量，利用(1+1'')共振增强的多光子电离和速度离子成像. 结果显示，微分截面以及偏振相关的微分截面均显示与从头算势能面上进行的量子力学散射计算[J. K?os etal. J. Chem. Phys. 137, 014312 (2012)]一致. 通过与准经典轨迹、硬壳势能的量子力学散射以及运动近端模型的比较，评估了势能对所测微分截面和碰撞引起的旋转准直力矩的影响.     

Synthesis of Honeycomb-Structured Beryllium Oxide via Graphene Liquid Cells

Using high-resolution transmission electron microscopy and electron energy-loss spectroscopy, we show that beryllium oxide crystallizes in the planar hexagonal structure in a graphene liquid cell by a wet-chemistry approach. These liquid cells can feature van-der-Waals pressures up to 1 GPa, producing a miniaturized high-pressure container for the crystallization in solution. The thickness of as-received crystals is beyond the thermodynamic ultra-thin limit above which the wurtzite phase is energetically more favorable according to the theoretical prediction. The crystallization of the planar phase is ascribed to the near-free-standing condition afforded by the graphene surface. Our calculations show that the energy barrier of the phase transition is responsible for the observed thickness beyond the previously predicted limit. These findings open a new door for exploring aqueous-solution approaches of more metal-oxide semiconductors with exotic phase structures and properties in graphene-encapsulated confined cells.     

Influence of acid treatment on structure of clinoptilolite tuff and its adsorption of methane

This study presents the results of the methane adsorption properties of clinoptilolite tuff from Bigadic, Turkey and that of acid treated forms at 273 and 293 K up to 100 kPa using volumetric apparatus. In order to assess changes in structural and gas adsorption properties of clinoptilolite, zeolite sample was treated with acid solutions of varying concentrations (0.1, 0.5, 1.0 and 2.0 M) at 70 °C during 3 h. Structural and thermal characterization of natural and acid treated clinoptilolite samples were carried out using a combination of techniques such as X-ray diffraction, X-ray fluorescence, thermogravimetric, differential thermal analysis and nitrogen adsorption methods. At both temperatures, uptake of methane (CH₄) increased in the following order: CLN < CLN-H2 < CLN-H1 < CLN-H05 < CLN-H01. CH₄ adsorption capacities of the original and acid treated clinoptilolites were found in the range of 0.476–0.910 mmol/g and 0.398–0.691 mmol/g at 273 and 293 K, respectively.     

Paper conservation methods: a literature review

The main paper conservation methods are presented, classified in the following categories: preparation of the intervention, disinfestation and disinfection/sterilization, surface/dry cleaning, wet cleaning, chemical stabilization, paper repairs, consolidation and strengthening. Treatment documentation is also discussed. The targets, the historical aspects, the general principles, the materials and equipment, the acceptance and criticism pertaining to each method are briefly reviewed, and the most important research for their evaluation is presented. Several paper stabilization strategies, such as deacidification and iron gall ink stabilization, applicable to paper are elucidated. Specific consolidation and strengthening methods for paper, such as lamination and paper splitting are also discussed. The review mainly focuses on the established methods, but experimental, abandoned or insufficiently documented methods are also included. Shortcomings and limitations of several methods were found in the literature, concerning health issues, limited effectiveness, adverse side-effects on the treated artefacts and restricted applicability.     

Ambazone salt with p-aminobenzoic acid

In this study, we obtained a novel salt of ambazone (AMB) with p-aminobenzoic acid (PABA) that exhibits improved solubility and antibacterial activity. The salt was produced by solvent-drop grinding and characterized by powder X-ray diffraction, thermal analysis and Fourier transform infrared spectroscopy. The salt nature of the new form was confirmed by infrared spectroscopy based on the characteristic vibrational band of the protonated amino group. Based on the X-ray powder diffraction data, the compound crystallizes in the triclinic P_-1 space group with the following unit cell parameters: a = 14.294 Å, b = 9.162 Å, c = 8.777 Å, α = 95.90°, β = 100.63°, γ = 91.73°. Thermal analysis reveals the thermal events and different decomposition steps of this solid form as compared to the starting compounds. Powder dissolution measurements showed solubility improvement compared with pure ambazone of 2 and 3.3 times in water and phosphate buffer, respectively. Antibacterial tests showed higher activity of the salt to Gram-negative Escherichia coli and Salmonella bacteria as compared to AMB and PABA. The study demonstrates that the pharmaceutical salt of ambazone with p-aminobenzoic acid (AMB–PABA) can be a possible alternative to ambazone in the treatment of infections with Gram-negative bacteria.     

Spectroscopic and structural characterization of pure and FeCl<Subscript>3</Subscript>-containing tri-<Emphasis Type="Italic">n</Emphasis>-butyl phosphate

The spectroscopic properties and liquid structure of pure tri-n-butyl phosphate (TBP) and FeCl₃/TBP solutions have been investigated by Uv–Vis and Raman spectroscopies, X-ray diffraction and conductometry. Uv–Vis and Raman spectra, supported by conductometric measurements, consistently indicate that the solubilized salt is present mostly as TBP _n [FeCl_3???n ] ⁿ⁺ and FeCl₄ ^? complex ions due to specific interaction with the TBP phosphate group. Thanks to this interaction, a high amount of salt (up to 13 % w/w) can be dissolved despite the relatively low dielectric constant of TBP. The X-ray diffractogram of pure TBP has been interpreted in terms of three main contributions which can be attributed to spatial pair correlations between atoms of interacting TBP molecules. In the presence of increasing FeCl₃ amounts, it has been observed a progressive structuring effect, exerted by the dissolved salt, on the layers of opportunely oriented TBP molecules due to the formation of the complex ionic species. By simple treatment with NaBH₄, the synthesis of Fe nanoparticles has been achieved. The absence of water, the easiness of preparation, the high amount of salt which can be suspended and the peculiar physico-chemical properties of such systems are all elements worth of note for the fields of nanoparticle synthesis and for specialized technological applications.