Preparation of benzoylchitosans and their chiroptical properties in dilute solutions

Two benzoyl substituted chitosan derivatives, 3,6‐O‐dibenzoylchitosan (DBC) and 2‐N‐3,6‐O‐tribenzoylchitosan (TBC), were prepared, and their optical activities in organic solvent were investigated by circular dichroism (CD). For TBC, two splitting bands (a negative one at 288 nm and a positive one at 274 nm) corresponding to the ¹L_b transition of the benzoyl group were observed in chloroform and dichloromethane, while only a negative CD band was recorded in N, N‐dimethylformamide (DMF). These results indicated that the transition moments of benzoyl groups were orderly arranged along the helical polymer chain when TBC was dissolved in a solvent with low polarity, but the same ordered structure did not appear in a polar solvent of DMF. For DBC, only negative CD signals corresponding to the ¹L_b transition of the benzoyl group were observed, regardless of the solvent property, which indicated that the chromophores were not arranged in an ordered fashion with appropriate geometry to interact with one another to induce bi‐signate CD signals. Adding methanol or DMF to the solution of TBC/chloroform resulted in a progressive decrease of the intensity of the positive split band at 274 nm. The intensity of the positive band was weakened upon heating a solution of TBC/chloroform from 20 to 60 °C. The results suggested that the ordered arrangement of the chromophores in the TBC system was dependent on solvent and sensitive to temperature. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4107–4115, 2004     

Uptake and excretion of total inorganic arsenic by the freshwater alga Chlorella vulgaris

Arsenic-tolerant freshwater alga Chlorella vulgaris which had been collected from an arsenicpolluted environment were tested for uptake and excretion of inorganic arsenic. Approximately half the quantity of arsenic taken up by C. vulgaris was estimated to be adhered to the extraneous coat (10 wt %) of the cell. The remainder was bioaccumulated by the cell. Both adhered and accumulated arsenic concentrations increased with an increase in arsenic(V) concentration of the aqueous phase. Arsenic(V) accumulation was affected by the growth phse: arsenic was most actively accumulated when the cell was exposed to arsenic during the early exponential phase and then accumulation decreased with an increase in culture time exposed to arsenic. The alga grew well in the modified Detmer (MD) medium containing 1 mg As(III) dm^?3 and the growth curve was approximated by a ‘logistic equation’. Arsenic(III) was accumulated up to the second day of the culture time and arsenic(III) accumulation decreased with an increase in the culture time after that. Arsenic accumulation was also largely affected by various nutrients, especially by managanese, iron and phosphorus compounds. A modified MD medium with the three nutrients was proposed for the purpose of effective removal of arsenic from the aqueous phase. Using radioactive arsenate (Na₂H⁷⁴AsO₄), the arsenic accumulated was found to be readily excreted under conditions which were unfavourable for the multiplication of C. vulgaris.     

Analysis of tetracycline antibiotics using HPLC with pulsed amperometric detection.

The analysis of tetracycline, oxytetracyline, chlortetracycline and doxycycline by high-performance liquid chromatography with pulsed amperometric detection using an anodized boron-doped diamond thin film (BDD) electrode is originally reported. The analyses were carried out using the mobile phase, phosphate buffer (0.01 M, pH 2.5)-acetonitrile (80:20; v/v), on a C18 column (250 x 4.6 mm i.d., 5 microm) at a flow rate of 1.0 mL/min. The optimal PAD waveform parameters at the anodized BDD were 1.5 V (versus Ag/AgCl) detection potential (E(det)) for 290 ms (200 ms delay time and 90 ms integration time), 2.0 V (versus Ag/AgCl) oxidation potential (E(oxd)) for 200 ms oxidation time (t(oxd)) and 0.4 V (versus Ag/AgCI) reduction potential (E(red)) for 200 ms reduction time (t(red)). The proposed method showed the simultaneous determination of tetracycline, oxytetracyline, chlortetracycline and doxycycline with a linear range of 0.1 - 100 microg/mL, detection limits of 0.05 - 0.1 microg/mL and recoveries of 70.8 - 96.0%. The application of this method to real samples was demonstrated and validated using a shrimp sample.     

Synthesis of poly(vinylene-arsine)s: alternating radical copolymerization of arsenic atomic biradical equivalent and phenylacetylene

Novel organoarsenic polymers, poly(vinylene-arsine)s, were synthesized by a free-radical alternating copolymerization of phenylacetylene with cyclooligoarsines as an atomic biradical equivalent. The polymerization between pentamethylpentacycloarsine (1a) or hexaphenylhexacycloarsine (1b) with phenylacetylene (2) in the presence of a catalytic amount of AIBN (in benzene; refluxing; for 12 h) gave the corresponding poly(vinylene-arsine)s. The obtained polymers were soluble in common organic solvents such as THF, chloroform, and benzene. From gel permeation chromatographic analysis (chloroform, PSt standards), the number-average molecular weights of the polymers from 1a and 1b were found to be 11500 and 3900, respectively. The structures of the polymers were supported by 1H and 13C NMR spectroscopies. The corresponding polymer was also obtained by irradiation of a benzene solution of 1a and 2 with xenon lamp at room temperature. After the polymer from 1a was stirred vigorously with 30% H2O2, the 1H NMR spectrum of the polymer showed the methyl proton that was assigned to As(III)-Me, suggesting the insensitivity of the trivalent state arsenic in the main chain to the oxidation. The structures and the molecular weights of the polymers were insensitive to the feed ratio of the monomers. This result indicates that the addition of the arsenic radical to phenylacetylene was a rate-determining step in the copolymerization.     

Study of a high-dimensional chaotic attractor

The nature of a very high-dimensional chaotic attractor in an infinite-dimensional phase space is examined for the purpose of studying the relationships between the physical processes occurring in the real space and the characteristics of high-dimensional attractor in the phase space. We introduce two complementary bases from which the attractor is observed, one the Lyapunov basis composed of the Lyapunov vectors and the another the Fourier basis composed of the Fourier modes. We introduce the exterior subspaces on the basis of the Lyapunov vectors and observe the chaotic motion projected onto these exteriors. It is shown that a certain statistical property of the projected motion changes markedly as the exterior subspace goes out of the attractor. The origin of such a phenomenon is attributed to more fundamental features of our attractor, which become manifest when the attractor is observed from the Lyapunov basis. A counterpart of the phenomenon can be observed also on the Fourier basis because there is a statistical one-to-one correspondence between the Lyapunov vectors and the Fourier modes. In particular, a statistical property of the high-pass filtered time series reflects clearly the difference between the interior and the exterior of the attractor.     

Two-dimensional network formation of cardiac myocytes in agar microculture chip with 1480 nm infrared laser photo-thermal etching

We have developed a new method that enables agar microstructures to be used to cultivate cells and that allows cell network patterns to be controlled. The method makes use of non-contact three-dimensional photo-thermal etching with a 1480 nm infrared focused laser beam, which is strongly absorbed by water and agar gel, to form the shapes of agar microstructures. It allows microstructures to be easily formed in an agar layer within a few minutes, with cell-culture holes formed by the spot heating of a 100 mW laser and tunnels by the tracing of a 100 microm s(-1), 40 mW laser. We cultivated rat cardiac myocytes in adjacent microstructures and observed synchronized beating in them 90 min after they had made physical contact. Our results indicate that the system can make and use microstructures for cell-network cultivation in a minimal amount of time without any expensive microfabrication facilities or complicated procedures.     

A Dodecalanthanide Wheel Supported by p‐tert‐Butylsulfonylcalix[4]arene

A dodecaholmium wheel of [Ho₁₂(L)₆(mal)₄(AcO)₄(H₂O)₁₄] ( 1 ; mal=malonate) was synthesized by using p‐tert‐butylsulfonylcalix[4]arene (H₄L) as a cluster‐forming ligand. The wheel consists of three fragments of mononuclear A^3? ([Ho(L)(mal)(H₂O)]^3?), trinuclear B^3? ([Ho(H₂O)₂(mal)(Ho(L)(AcO))₂]^3?), and C³⁺ ([Ho(H₂O)₂]³⁺), and an alternate arrangement of these fragments (A^3?? C³⁺? B^3?? C³⁺? A^3?? C³⁺? B^3?? C³⁺? ) results in a wheel structure. The longest and shortest diameters of the core were estimated to be 17.7562(16) and 13.6810(13) Å, respectively, and the saddle‐shaped molecule possesses a pocketlike cavity inside.     

Proposed mechanism for the reaction catalyzed by a diterpene cyclase,aphidicolan-16beta-ol synthase: experimental results on biomimetic cyclization and examination of the cyclization pathway by ab initio calculations

To examine the mechanism of the cyclization reaction catalyzed by aphidicolan-16beta-ol synthase (ACS), which is a key enzyme in the biosynthesis of diterpene aphidicolin, a specific inhibitor of DNA polymerase alpha, skeletal rearrangement of 2a and biomimetic cyclization of 4b were employed. The structures of the reaction products, which reflect penultimate cation intermediates, allowed us to propose a detailed reaction pathway for the Lewis acid-catalyzed cyclizations and rearrangements. Isolation of these products in an aphidicolin-producing fungus led us to speculate that the mechanism of the ACS-catalyzed cyclization reaction is the same as that of a nonenzymatic reaction. Ab initio calculations of the acid-catalyzed reaction intermediates and the transition states indicate that the overall reaction catalyzed by ACS is an exothermic process though the reaction proceeds via an energetically disfavored secondary cation-like transition state. In conjunction with the solvent effect in the acid-catalyzed reactions, this indicates that the actual role of ACS is to provide a template which enforces conformations of the intermediate cations leading to the productive cyclization although it has been believed that the cation-pi interaction between cation intermediates and aromatic amino acid residues in the active site is important for the enzymatic catalysis. This study provided important information on the role of various cationic species, especially secondary cation-like structures, in both nonenzymatic and enzymatic reactions.     

Synthesis of Optically Active P‐Chiral and Optically Inactive Oligophosphines

A series of optically active P‐chiral oligophosphines (S,R,R,S)‐ 2 , (S,R,S,S,R,S)‐ 3 , (S,R,S,R,R,S,R,S)‐ 4 , and (S,R,S,R,S,R,R,S,R,S,R,S)‐ 5 with four, six, eight, and 12 chiral phosphorus atoms, respectively, were successfully synthesized by a step‐by‐step oxidative‐coupling reaction from (S,S)‐ 1 . The corresponding optically inactive oligophosphines 1′ – 5′ were also prepared. Their properties were characterized by DSC, XRD, and optical‐rotation analyses. While optically active bisphosphine (S,S)‐ 1 and tetraphosphine (S,R,R,S)‐ 2 behaved as small molecules, octaphosphine (S,R,S,R,R,S,R,S)‐ 4 and dodecaphosphine (S,R,S,R,S,R,R,S,R,S,R,S)‐ 5 exhibited the features of a polymer. Furthermore, DSC and XRD analyses showed that hexaphosphine (S,R,S,S,R,S)‐ 3 is an intermediate between a small molecule and a polymer. Comparison of optically active oligophosphines 1 – 5 with the corresponding optically inactive oligophosphines 1′ – 5′ revealed that the optically active phosphines have higher crystallinity than the optically inactive counterparts. It is considered that the properties of oligophosphines depend on the enantiomeric purity as well as the oligomer chain length.     

Theoretical study on spin alignments in ferromagnetic heterospin chains with competing exchange interactions: a generalized ferrimagnetic system containing organic biradicals in the singlet ground state

Spin alignments in heterospin chains are examined from numerical calculations of model spin Hamiltonians. The Hamiltonians of the heterospin chains mimic an open-shell molecular assemblage composed of an organic biradical in a singlet (S = 0) ground state and a doublet (S = 1/2) monoradical, which are coupled by intermolecular ferromagnetic exchange interactions. It is found from numerical calculations of the spin Hamiltonians that the spin value S2 of the ground-state singlet biradical embedded in the exchange-coupled assemblage deviates from zero and contributes to the bulk magnetization. The alternating chain is found to have two kinds of ground spin states, a high- and a low-spin state. All the spins are parallel to each other in the high-spin state, which is characterized by the spin correlation function of (S(i).S(j)) = 0.25. On the other hand, the spin alignment in the low-spin state is found to be dependent on the topology of the intermolecular exchange interactions. The energy preference of the two states depends on the relative amplitude of the exchange interactions in the chain. The intermolecular ferromagnetic couplings are competing in the ground-state singlet biradical with the intramolecular antiferromagnetic interaction. The appearance of the two kinds of ground states is attributed to a quantum spin frustration effect inherent in the triangular motif of the competing interactions. Magnetic properties of a zigzag chain complex composed of a nitronyl nitroxide biradical with a singlet ground state and Cu(hfac)2 are examined on the basis of the theoretical calculations. The vanishing magnetic moments, or the product of susceptibility and temperature chiT, at low temperatures observed for the complex are consistent with those of the low-spin state predicted in the theoretical calculations.