周期性梯度折射率多层膜的软X射线反射率

由于界面互扩散的存在，实际的超薄多层膜很难具有清晰的界面结构.假设超薄多层膜为具有周期性梯度折射率的多层膜结构，用直线模型和余弦模型模拟了周期性梯度折射率多层膜的软X射线反射率.结果证明，折射率余弦渐变的多层膜虽然不具有清晰的界面，但它同样具有很高的反射率.     

一种不等带宽光学梳状滤波器

提出了一种新型—Michelson—三面镜FabryPerot型50GHz不等带宽光学梳状滤波器设计方案,分析和模拟表明:该器件将一路信道间隔为50GHz的输入信号分离成信道间隔为100GHz的奇偶两路输出信号,其中在3dB处,奇数信道带宽大于30GHz用于10Gb/s传输,偶数信道带宽大于60GHz用于40Gb/s传输对于将来的40Gb/s系统,该器件具有优势.     

相对论平均场理论中各种有效相互作用对中子星性质的影响

基于相对论平均场理论，研究了各种相互作用参数组(NL1、NL3、NLSH、TM1和GL-97)对中子星物质的性质和中子星整体结构的影响．发现参数组NL1、NL3和NLSH所给出的中子星内部的介子场强度、物质的组成比例、物态方程和中子星的整体特点基本相同，但与TM1和GL-97之间有较大的差别．相对于其他参数组，GL-97给出的介子场强度最弱，中子星的相对数密度最大，物态方程也最软，同时采用GL-97参数组计算的中子星的最大质量也最小．     

半导体激光自混频干涉式传感器中的干涉与调制

应用F-P模型，阐述了半导体激光自混频干涉式传感器的干涉与调制过程，同时给出了相应的计算．     

Harmonic beam splitter design and fabrication

Two problems of half-wave hole and high ripples in the transmittance region for a harmonic beam splitter had been pointed out and analyzed. Based on the application of a half-wavelength control and a new admittance matching methods, a harmonic beam splitter was designed and fabricated. The former method eliminated the half-wave hole fundamentally, and the latter smoothed high ripples in the transmittance region effectively. The matching stack consisted of a symmetrically periodic structure and provided a complete matching at the desired wavelength, i.e., both conditions for the equivalent admittance and phase thickness were fulfilled. Furthermore, both the theoretical and the tested curves had been given, and a good agreement between them was obtained.     

Structure and Photoluminescence of Nano-ZnO Films Grown on a Si （100） Substrate by Oxygen- and Argon-Plasma-Assisted Thermal Evaporation of Metallic Zn

Nano-ZnO thin films were prepared by oxygen- and argon-plasma-assisted thermal evaporation of metallic Zn at low temperature, followed by low-temperature annealing at 300℃ to 500℃ in oxygen ambient. X-ray diffraction patterns indicate that the nano-ZnO films have a polycrystalline hexagonal wurtzite structure. Raman scattering spectra demonstrate the existence of interface layers between Zn and ZnO. Upon annealing at 400℃ for i h, the interface mode disappears, and photoluminescence spectra show a very strong ultraviolet emission peak around 381 nm. The temperature-dependent PL spectra indicate that the UV band is due to free-exciton emission.     

Interface roughness, surface roughness and soft X-ray reflectivity of Mo/Si multilayers with different layer number

A series of Mo/Si multilayers with the same periodic length and different periodic number were prepared by magnetron sputtering, whose top layers were respectively Mo layer and Si layer. Periodic length and interface roughness of Mo/Si multilayers were determined by small angle X-ray diffraction (SAXRD). Surface roughness change curve of Mo/Si multilayer with increasing layer number was studied by atomic force microscope (AFM). Soft X-ray reflectivity of Mo/Si multilayers was measured in National Synchrotron Radiation Laboratory (NSRL). Theoretical and experimental results show that the soft X-ray reflectivity of Mo/Si multilayer is mainly determined by periodic number and interface roughness, surface roughness has little effect on reflectivity.     

有限长FGM圆筒的热/机应力的解析解

利用微分方程的级数求解方法,分析了两端简支的有限长功能梯度圆筒的轴对称稳态热弹性问题,推导出了稳态温度场与应力场的解析解。分析中采用指数函数模型来描述FGM圆筒中材料性能在厚度方向的连续变化,同时忽略温度对材料性能的影响。另外,论文以金属钼和多铝红柱石制成的功能梯度圆筒为例,给出了稳态温度场和应力场的数值结果。     

Effect of Alumina and Chromium Interlayers on Microstructures and Optical Properties of Thin Ag Films on Glass Substrates

Effects of alumina and chromium interlayers on the microstructure and optical properties of thin Ag films are investigated by using spectrophotometry, x-ray diffraction and AFM. The characteristics of Ag films in Ag/glass, Ag/l2O3/glass and Ag/Cr/glass stacks are analysed. The results indicate that the insertion of an Al2O3 or Cr layer decreases the grains and influences the reflectance of Ag films. The reflectance of the Ag film can be increased by controlling the thickness of alumina interlayer. The stability of Ag films is improved and the adhesion of Ag films on glass substrates is enhanced by alumina as an interlayer.     

CBP/Alq3有机量子阱结构的光致发光

采用多源有机分子气相沉积系统(OMBD)制备了CBP/Alq₃有机多量子阱结构,利用电化学循环伏安特性和吸收光谱、小角X射线衍射、荧光光谱研究了量子阱的能带、结构和光致发光的特性。电化学循环伏安特性和吸收光谱的测量结果表明,CBP的最低占据分子轨道(LUMO)与最高占据分子轨道(HOMO)的位置分别为-2.74,-6.00eV,Alq₃的LUMO与HOMO的位置分别为-3.10,-5.80eV,所以CBP/Alq₃有机量子阱为Ⅰ型量子阱结构。小角X衍射测量显示,在小角的位置(2θ的范围在0°～3°)观察到了对应于量子阱结构的多级布拉格衍射峰,表明多层量子阱结构是有序的层状结构,界面比较完整,界面质量比较好。荧光光谱的研究结果表明,Ⅰ型量子阱结构可以有效地把能量从垒层传递给阱层,从而增强了阱层材料的发光。阱层的厚度对发光峰的位置影响很大,随阱层厚度减小,阱层材料的发光峰出现蓝移现象。并对引起发光峰蓝移的原因进行了讨论。