还原氮化温度对氮化铌纳米管组成、结构与电化学性能影响研究

以铌箔为基底,用阳极氧化法结合氨气还原氮化法制备出氮化铌纳米管,利用X射线衍射仪(XRD)、X射线光电子能谱(XPS)和扫描电镜(SEM)等结构表征手段和循环伏安法(CV)、充放电(GCD)和交流阻抗法(EIS)等电化学测试手段研究了还原氮化温度对纳米管的物相、形貌以及电化学性能的影响.结果表明,还原氮化后出现了氮化铌物相,以氧氮化铌固溶体形式存在,当还原氮化温度为700℃时,氮化铌纳米管阵列结构均匀,纳米管的孔内径约为35 nm,管壁厚度约为12 nm,纳米管长度约为1.5μm,样品中内在阻抗和电荷转移电阻较小,在电流密度为0.1 mA/cm2时,其比电容为400μF/cm2.     

Light/Electricity Energy Conversion and Storage for a Hierarchical Porous In2S3@CNT/SS Cathode towards a Flexible Li-CO2 Battery

A photoinduced flexible Li-CO₂ battery with well-designed, hierarchical porous, and free-standing In₂S₃@CNT/SS (ICS) as a bifunctional photoelectrode to accelerate both the CO₂ reduction and evolution reactions (CDRR and CDER) is presented. The photoinduced Li-CO₂ battery achieved a record-high discharge voltage of 3.14 V, surpassing the thermodynamic limit of 2.80 V, and an ultra-low charge voltage of 3.20 V, achieving a round trip efficiency of 98.1 %, which is the highest value ever reported (<80 %) so far. These excellent properties can be ascribed to the hierarchical porous and free-standing structure of ICS, as well as the key role of photogenerated electrons and holes during discharging and charging processes. A mechanism is proposed for pre-activating CO₂ by reducing In³⁺ to In⁺ under light illumination. The mechanism of the bifunctional light-assisted process provides insight into photoinduced Li-CO₂ batteries and contributes to resolving the major setbacks of the system.     

O-Alkyldithiophosphate Nickel Complexes with dcpf Ligand as Efficient Electrocatalysts for Hydrogen Evolution

Six new O-alkyldithiophosphate nickel complexes with dcpf ligand, [(dcpf)Ni(S₂P{O}OR)] (dcpf = 1,1′-bis (dicyclohexylphosphino)ferrocene, R = CH₃ ( 1 ), CH₃CH₂ ( 2 ), Ph ( 3 ), 4-MeC₆H₄ ( 4 ), PhCH₂ ( 5 ) and PhCH₂CH₂ ( 6 )), have been synthesized by the treatment of dcpf with ((RO)₂PS₂)₂Ni in satisfactory yields. These complexes were characterized by elemental analysis, spectroscopy (FTIR, UV–vis, ¹H, ¹³C, and ³¹P NMR), thermogravimetric analysis and single crystal X-ray diffraction. The nickel atom in 1 , 2 ·CH₂Cl₂, 3 ·CH₂Cl₂, 4 ·2CH₂Cl₂·THF, and 2( 5 )·hexane adopts a slightly distorted square-planar coordination environment finished by two phosphorus atoms of dcpf ligand and two sulfur atoms of O-alkyldithiophosphate ligand. Furthermore, the electrochemical properties for complexes 1 – 6 were also investigated by cyclic voltammetry. With the addition of 120 mM trifluoroacetic acid (TFA), the turnover frequency (TOF) values for 1 – 6 are estimated to be 1243.83, 1046.54, 1331.71, 2545.29, 1899.03, and 1191.37 s⁻¹, with the overpotential (η) values of 0.62, 0.58, 0.71, 0.67, 0.60, and 0.56 V, respectively. The result of electrochemical studies indicates that all complexes can be used as efficient molecular eletrocatalysts for the reduction of protons to hydrogen in the presence of TFA in MeCN.     

羧酸桥联的四核镧系簇合物的磁热效应和慢磁弛豫

在水热条件下,通过使用羧酸和螯合配体得到了一个系列的四核镧系簇合物,即[Ln₄(mnba)₁₂(tzp)₂(H₂O)₂](Ln=Gd(1),Tb(2),Er(3);Hmnba=间硝基苯甲酸;tzp=2-(1H-1,2,4-三唑-3-基)吡啶))。这3个化合物是同构的,且具有线性的四核簇结构。磁性研究表明,化合物1和3中簇内镧系离子之间是弱铁磁耦合的,但化合物2中铽离子之间是弱的反铁磁相互作用和(或)铽离子激发的斯塔克能级的去布居。化合物1具有较大的磁热效应(-ΔS_m^max=20.6 J·kg^-1·k^-1)。交流磁化率测试表明化合物3展现出频率和温度依赖的虚部信号,这是慢磁弛豫的典型特征,原因是铒离子的强各向异性和铁磁耦合的存在。     

PW11Cu/TiO2膜光催化剂的制备及可见光催化性能

以PW₁₁Cu为可见光活性组分,TiO₂为载体结构组分,采用溶胶-凝胶法制备了PW₁₁Cu/TiO₂复合膜可见光催化剂,并用UV-Vis DRS、IR、Raman、XRD、SEM、TEM等手段对催化剂的光吸收性质、化学组成、晶相、表面结构和形貌进行了表征,同时,以模型污染物RhB的可见光降解为探针评估了它的光催化活性,考察了膜处理温度、PW₁₁Cu含量和溶液酸性对催化活性的影响,最后,通过催化剂循环降解RhB试验评估了PW₁₁Cu/TiO₂膜的稳定性。实验结果表明,PW₁₁Cu/TiO₂膜对可见光有明显吸收,低温(100℃)处理的膜为无定形态,高温(500℃)处理的膜为多晶态;低温处理的膜具有较高的可见光催化活性,用于RhB的可见光催化降解,在中性条件下反应80 min,RhB的降解率为100%,TOC去除达32%(4 h);提高溶液酸性有利于催化剂活性的提高,在pH=2.5的条件下,达到100%的RhB降解仅需30 min。在本实验条件下,PW₁₁Cu的最佳剂量是3.0 g。经过10次循环降解RhB,催化剂的光催化活性仍保留约90%。     

DMSO作为新的合成子在有机合成中的应用研究进展

二甲亚砜(DMSO)不但可以作为有机溶剂,同时还可以作为反应试剂,在有机合成中得到了广泛的应用.由于其具有来源广、价格低廉、操作简单等优点,近年来将DMSO作为反应试剂应用于有机合成反应引起了广大化学家的关注.本文作者对近几年来DMSO作为合成子在有机合成中的应用按照引入官能团的种类进行了总结,详细阐述了其转化为甲磺酰基、甲酰基、氰基、甲硫基等官能团的方法学研究,以期为开发DMSO新的应用提供参考依据.     

Multilayer Porous Vanadium Nitride Microsheets Anodes for Highly Stable Na-ion Batteries

Sodiumion batteries(SIBs)have attracted intensive attention as promising alternative to lithium-ionbatteries(LIBs)for large scale energy storage systems because of low cost of sodium,similar energy storage mechanism and the reasonable performance.However,it is still a great challenge to search and design a robust structure of anode materials with excellent cycling stability and high rate capability for SIBs.Herein,multilayer porous vanadium nitride(VN)microsheets are synthesized through a facile and scalable hydrothermal synthesis-nitrogenization strategy as an effective anode material for SIBs.The multilayer porous VN microsheets not only offer more active sites for fast Na+insertion/extraction process and short diffusion pathway,but also effectively buffer the volume change of anode due to more space in the multilayer porous structure.The large proportions of capacitive behavior imply that the Na+charge storage depends on the intercalation pseudocapacitive mechanism.The multilayer porous VN microsheets electrodes manifest excellent cycling stability and rate capability,delivering a discharge capacity of 156.1 mA·h/g at 200 mA/g after 100 cycles,and a discharge capacity of 111.9 mA·h/g at 1.0 A/g even after 2300 cycles with the Coulombic efficiency of nearly 100%.     

Ni-Mg复合催化剂催化裂解CH_4制氢动力学研究

基于定温热重实验,建立了甲烷催化裂解反应动力学模型和催化剂表面积炭失活动力学模型。其中,甲烷催化裂解动力学模型将初始产氢速率视为催化剂未积炭条件下的动力学基础数据;催化剂表面积炭失活动力学则基于甲烷催化裂解速率的降低。实验使用Ni-Mg复合催化剂,分别在535、585、635℃,甲烷分压10~4、2×10~4、3×10~4Pa条件下展开甲烷催化裂解动力学特性研究。结果表明,甲烷催化裂解的反应级数为0.5,活化能为82 k J/mol;Ni-Mg复合催化剂反应失活级数为0.5,催化剂失活活化能为118 k J/mol。实验条件下均制得了多壁碳纳米管。     

锌离子荧光探针研究进展

锌广泛存在于人体内,具有重要生理功能。因此,对游离锌离子的选择性识别和有效检测具有重要意义。荧光探针因其设计简单、易于操作、灵敏度高、可细胞成像等诸多优点而广泛应用于锌离子的识别研究。锌离子荧光探针常见的识别机理包括光致电子转移、分子内电荷转移、荧光共振能量转移、聚集诱导荧光增强、螯合荧光增强等。其中,基于螯合荧光增强机理的锌离子探针,其荧光团通常可同时作为识别基团,因此,相比于其它探针,具有设计较为简单、合成较为便捷的优点。本文综述了近年来文献中报道的基于以上各种识别机理的锌离子荧光探针,并着重介绍了螯合荧光增强机理在锌离子识别中的应用。     

X射线荧光光谱法测定萤石中CaF2、CaCO3、S、Fe及SiO2

X射线荧光光谱法分析是目前快速分析方法之一,精密度受基体效应、均匀性、元素间干扰等影响。采用粉末压片法制备样品,用X射线荧光光谱法直接测定F、Ca元素,得出CaF_2及CaCO_3含量,并同时分析萤石中S、Fe、SiO_2的含量。精密度实验表明,待测元素的相对标准偏差均低于0.66%(RSD,n=10),能满足萤石中各元素的检测要求。