High‐molar‐mass polypropene with tunable elastic properties by hafnocene/borate catalysts

Elastic polypropene has gained growing industrial and academic interest as a thermoplastic elastomer. In this study, “rac”‐ and “meso”‐dimethylsilyl(3‐benzylindenyl)(2‐methylindenyl)hafnium dichloride complexes (Hfr and Hfm, respectively), activated with [NHMe₂Ph][B(C₆F₅)₄]/triisobutyl aluminum, were used in propene polymerization. Using these catalyst systems, we obtained polymers with high molar masses, up to 550 kg/mol, and moderate isotacticities between 34 and 52%. By varying the polymerization conditions, we could modify the polymer microstructure and molar mass. ¹³C NMR was used to calculate the polymer pentad sequence distributions. The crystalline parts of the polymers were analyzed with the differential scanning calorimetry successive self‐nucleation and annealing (SSA) technique. The SSA thermograms revealed that Hfr produced polypropene with a more uniform lamellar structure than Hfm. The mechanical properties were tested with dynamic mechanical analysis creep‐recovery tests. In the series, the polymers with the lowest isotacticities and therefore lowest crystallinities showed the best elastic properties. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 4743–4751, 2006     

THE ELECTRON SPIN POLARIZATION OF THE DONOR-TRIPLET STATE IN NATIVE and MODIFIED PHOTOSYNTHETIC REACTION CENTERS FROM

The electron spin polarization (ESP) pattern of the donor-triplet state (P^R) of reaction centers (RC's) of the purple bacterium Rhodobacter (formerly Rhodopseudomonas) sphaeroides R-26 was investigated. δm =±1 triplet EPR spectra were recorded of unmodified RC's as well as of RC's from which Fe²⁺ or ubiquinone was removed, or ubiquinone was substituted by menaquinone.
The relative amplitude of the Y peaks in the triplet EPR powder spectrum of P^R decreases when the temperature is increased from 8 K to 100 K in RC's with an intact quinone-iron complex. This decrease is more pronounced when the primary ubiquinone is substituted by menaquinone. These observations provide further support for the hypothesis that the observed lineshape of the P^R triplet state EPR spectrum reflects the presence of a third electron spin, magnetically coupled to I^- in the P⁺I^- radical pair, as suggested by Van Wijk et al. (1986) (Photobiochem. Photobiophys . 11, 95–100). Our observations suggest that this phenomenon may be general in purple bacteria.     

Polymerization of methyl methacrylate in the presence of iron(II) complex with tetradentate nitrogen ligands under conditions of atom transfer radical polymerization

Four tetradentate nitrogen ligands, viz. dichloro{[N,N^′-diphenyl-N,N^′-di(quinoline-2-methyl)]-1,2-ethylene diamine} (1), {[N,N^′-dioctyl-N,N^′-di(quinoline-2-methyl)]-1,2-ethylene diamine} (2), {[N,N^′-dibenzyl-N,N^′-di(quinoline-2-methyl)]-1,2-ethylene diamine} (3), and (1R,2R)-(−)-N,N^′-di(quinoline-2-methyl) di-iminocyclohexane (4), were investigated as novel complexing ligands in iron-mediated atom transfer radical polymerization (ATRP) of methyl methacrylate where ethyl-2-bromoisobutyrate was the initiator in o-xylene at 90 °C. With ligands 1 and 2 the experimental molecular weights increased gradually with monomer conversion. High to moderate conversions (87%, 43%) were obtained in relatively short times (90 min for 1 and 30 min for 2), which indicates an efficient catalyst system, but after these times a dramatic increase in viscosity of the polymerization medium led to loss of control. It is noteworthy that polymerization proceeded in a controlled manner with ligand 1, which has two rather bulky substituents on the N-atom. Such bulky ligands did not work for a copper-based system, where they led to excessive terminations or other side reactions. When the bulkiness of the substituents was significantly increased, as in ligand 3, a decrease in polymerization rate and loss of control occurred. Ligand 4 was less efficient than the other ligands, probably because the ethylene bridge was replaced by cyclohexane bridge.     

Heterogenization of racemic ethylenebis(1-indenyl)zirconium dichloride on trimethylaluminum vapor modified silica surface

Heterogeneous metallocene catalysts were prepared by adsorbing rac-Et(Ind)₂ZrCl₂ on a modified silica surface in solution. The modification of silica was conducted in gas phase with atomic layer chemical vapor deposition (ALCVD) technique, where the silica, preheated at either 350 or 600°C, was allowed to react with vaporized trimethylaluminum (TMA) at 250°C. Modified carriers and heterogeneous catalysts were characterized with FTIR, ¹H MAS (magic-angle spinning) NMR, ¹³C, and ²⁹Si CP (cross-polarization) MAS NMR spectroscopies and elemental analyses. In the reaction of TMA with silica, a saturated surface was formed consisting of different (---O)_4−nSi(CH₃)_n (n=1, 2 or 3) and ---AlCH₃ groups. The ratio of ---SiMe to ---AlMe groups was approximately 1.5 in the TMA/SiO₂ carriers. When the metallocene was adsorbed onto the carrier it seemed to react with the surface ---AlCH₃ groups and possibly ---ZrCH₃ groups were formed. Heterogeneous catalysts were tested in the polymerization of ethylene and propylene in the presence of methylalumoxane (MAO). And they produced similar polymer as the homogeneous rac-Et(Ind)₂ZrCl₂ catalyst, but with lower activity. A catalyst with the best activity was achieved from silica that was preheated at 600°C. Moreover, leaching of catalyst was examined whereupon a part of zirconium was observed to desorb from the carrier.     

PAMAM structure-based multifunctional fluorescent conjugates for improved fluorescent labelling of biomacromolecules

Fluorescent probes are of increasing interest in medicinal and biological applications for the elucidation of the structures and functions of healthy as well as tumour cells. The quality of these investigations is determined by the intensity of the fluorescence signal. High dye/carrier ratios give strong signals. However, these are achieved by the occupation of a high number of derivatisation sites and therefore are accompanied by strong structural alterations of the carrier. Hence, polyvalent substances containing a high number of fluorescent dyes would be favourable because they would allow the introduction of many dyes at one position of the compound to be labelled.A large number of different dyes have been investigated to determine the efficiency of coupling to a dendrimer scaffold and the fluorescence properties of the oligomeric dyes, but compounds that fulfil the requirements of both strong fluorescence signals and reactivities are rare. Herein we describe the synthesis and characterisation of dye oligomers containing dansyl-, 7-nitro-2,1,3-benzoxadiazol-4-yl- (NBD), coumarin-343, 5(6)-carboxyfluorescein and sulforhodamine B2 moieties based on polyamidoamine (PAMAM) dendrimers. The PAMAM dendrimers were synthesised by an improved protocol that yielded highly homogeneous scaffolds with up to 128 conjugation sites. When comparing the fluorescent properties of the dye oligomers it was found that only the dansylated dendrimers met the requirements of enhanced fluorescence signals. The dendrimer containing 16 fluorescent dyes was conjugated to the anti-epidermal-growth-factor receptor (EGFR) antibody hMAb425 as a model compound to show the applicability of the dye multimer compounds. This conjugate revealed a preserved immunoreactivity of 54%.We demonstrate the applicability of the dye oligomers to the efficient and applicable labelling of proteins and other large molecules that enables high dye concentrations and therefore high contrasts in fluorescence applications.