Effect of Pr-Ca substitution on the transport and magnetic behavior of LaMnO3 perovskite

The effect of simultaneous substitution of a fluctuating cation and a divalent cation in LaMnO₃ perovskite modifies the properties of the material to exhibit large valence colossal magnetoresistance (CMR) effect. A good example of these properties is (La_1−2x Pr _x Ca _x )MnO₃ (LPCMO) type CMR material. In this communication it is reported that, with the increase in x (for x=0.1, 0.15, 0.2), the T _c varies between 100 and 120 K with improvisation in metal-insulator transition. Interestingly, resistance increases with x from few hundred ohms to few kilo ohms with corresponding decrease in the unit cell volume. The results of the studies using X-ray diffraction (XRD), electrical resistivity, magnetoresistance and ac susceptibility measurements on LPCMO samples for understanding the structural, transport and magnetic properties are discussed in detail.     

关于K个复相关矩阵相等的检验

§ 1.Ｉｎｔｒｏｄｕｃｔｉｏｎ　ＷｅａｒｅｇｉｖｅｎｋｉｎｄｅｐｅｎｄｅｎｔＷｉｓｈａｒｔｄｅｎｓｉｔｉｅｓｏｆｔｈｅ (ｐ +ｑ)× (ｐ +ｑ)ｒａｎｄｏｍｓｙｍｍｅｔｒｉｃｐｏｓｉｔｉｖｅｄｅｆｉｎｉｔｅｍａｔｒｉｃｅｓＧ1,… ,Ｇｋｔｏｂｅｇ(Ｇｉ) =Ｋｅｘｐ -12 ｔｒＲ- 1ｉ Ｇｉ Ｇｉ12 (ｎｉ- ｑ-ｐ- 1) ,(1 )ｗｈｅｒｅｉ=1 ,… ,ｋ,ａｎｄＲｉｄｅｎｏｔｅｓｔｈｅｐｏｐｕｌａｔｉｏｎｃｏｒｒｅｌａｔｉｏｎｍａｔｒｉｘｏｆｔｈｅｉ ｔｈｐｏｐｕｌａｔｉｏｎａｎｄＫａｓａｇｅｎｅｒｉｃｌｅｔｔｅｒｄｅｎｏｔｅ…     

Identification of oxidation products of solanesol produced during air sampling for tobacco smoke by electrospray mass spectrometry and HPLC

Solanesol, a 45-carbon, trisesquiterpenoid alcohol found in tobacco leaves and tobacco smoke, has been used as a quantitative marker for tobacco smoke for years. However, solanesol appears to be unreliable as a quantitative marker for tobacco smoke during environmental air sampling because it can be degraded substantially when present as a component of tobacco smoke and by as much as 100% when present as pure solanesol on fortified filters during air sampling. Since there is strong evidence that ozone is the agent responsible for the degradation, solanesol appears to be unreliable as a quantitative marker during indoor air sampling when indoor levels of ozone are greater than about 15 ppb. The degree of loss of pure solanesol is directly proportional to the concentration of ozone and the length of the sampling period and depends on the type of 37 mm membrane filter used for air sampling (PTFE or quartz fiber). While the degree of loss of solanesol is inversely proportional to the relative humidity of the air at a sampling rate of 1.7 L min(-1), the degree of loss is virtually independent of relative humidity at a lower sampling rate; i.e., 0.25 L min(-1). A curve of loss of solanesol on a filter versus concentration of ozone from an ozone generator is virtually identical to a curve segment based on atmospheric ozone under the same conditions of air sampling. Oxidation of solanesol by ozone to approximately 25 to 60% completion produces at least three series of products for a total of at least 26 compounds: (1) isoprenoid acetones, (2)omega-hydroxyisoprenoid acetaldehydes, and (3) isoprenoid oxoaldehydes. All products in each series were tentatively identified as their derivatives with 2-(p-aminophenyl)ethanol (APE) by electrospray mass spectrometry (ES-MS). Ten ozonation products were detected as their 2,4-dinitrophenylhydrazine derivatives by HPLC at 360 nm: 4-oxopentanal and nine isoprenoid acetones (acetone, 6-methyl-5-hepten-2-one, geranylacetone, farnesylacetone, tetraprenylacetone, geranylfarnesylacetone, farnesylfarnesylacetone, farnesylgeranylgeranylacetone and bombiprenone.     

A technique for the identification and direct analysis of hexahydro-1,3,5-tris(2-hydroxyethyl)-s-triazine in metalworking fluids using electrospray-mass spectrometry

Hexahydro-1,3,5-tris(2-hydroxyethyl)-s-triazine is a widely used biocide in metalworking fluids that resists direct quantification in many analytical methods due to instability. It can be detected in electrospray-mass spectrometry (ES-MS) due to the formation of a charged and relatively stable adduct with the sodium ion. This adduct produces a distinct ion spectrum via collision-induced fragmentation, which should promote specific detection of the analyte in complex matrices. ES-MS detection of the analyte added to, or already present in, metalworking fluid samples at microg mL(-1) levels is demonstrated. Parameters affecting the formation and detection of the sodium adduct, including choice of solvent, alkalinity, and sodium ion level are explored. Linearity of response in flow injection mode is demonstrated.     

Effects of Microphone Type on Acoustic Measures of Voice

Acoustic measures provide an objective means to describe pathological voices and are a routine component of the clinical voice examination. Because the voice sample is obtained using a microphone, microphone characteristics have the potential to influence the values of parameters obtained from a voice sample. This project examined how the choice of microphone affects key voice parameters and investigated how one might compensate for such microphone effects through filtering or by including additional parameters in the decision process. A database of 53 normal voice samples and 100 pathological voice samples was used in four experiments conducted in an anechoic chamber using four different microphones. One omnidirectional microphone and three cardioid microphones were used in these experiments. The original voice samples were presented to each microphone through a speaker located in an anechoic chamber, and the output of each microphone sampled to computer disk. Each microphone modified the frequency spectrum of the voice signal; this, in turn, affected the values of the voice parameters obtained. These microphone effects reduced the accuracy with which acoustic measures of voice could be used to discriminate pathological from normal voices. Discrimination performance improved when the microphone output was filtered to compensate for microphone frequency response. Performance also improved when spectral moment coefficient parameters were added to the vocal function parameters already in use.     

Structural studies and T c dependence in La2−x Dy x Ca y Ba2Cu4+y O z type mixed oxide superconductors

A new series of mixed oxide superconductors with the stoichiometric composition La_2−x Dy _x Ca _y Ba₂Cu_4+y O _z (x=0.0 − 0.5, y=2x) has been studied for structural and superconductiong properties. Our earlier studies on La_2−x (Y/Er) _x Ca _y Ba₂Cu_4+y O _z series, show a strong dependence of T _c on hole concentration (p _sh). In the present work, the results of the analysis of the neutron diffraction measurements at room temprerature on x=0.3 and 0.5 samples are reported. It is interesting to know that Ca substitutes for both La and Ba site with concomitant displacement of La onto Ba site. Superconductivity studies show that maximum T _c is obtained for x=0.5, y=1.0 sample (T _c ∼ 75 K), for La_1.5Dy_0.5Ca₁Ba₂Cu₅O _z (La-2125).     

Suppression of large edge-localized modes in high-confinement DIII-D plasmas with a stochastic magnetic boundary

A stochastic magnetic boundary, produced by an applied edge resonant magnetic perturbation, is used to suppress most large edge-localized modes (ELMs) in high confinement (H-mode) plasmas. The resulting H mode displays rapid, small oscillations with a bursty character modulated by a coherent 130 Hz envelope. The H mode transport barrier and core confinement are unaffected by the stochastic boundary, despite a threefold drop in the toroidal rotation. These results demonstrate that stochastic boundaries are compatible with H modes and may be attractive for ELM control in next-step fusion tokamaks.