Characteristics of black carbon aerosol in Jiaxing,China during autumn 2013

We conducted measurements of black carbon（BC） aerosol in Jiaxing,China during autumn from September 26 to November 30,2013.We investigated temporal and diurnal variations of BC,and its correlations with meteorological parameters and other major pollutants.Results showed that hourly mass concentrations of BC ranged from 0.2 to 22.0 μg/m³,with an average of 5.1 μg/m³.The diurnai variation of BC exhibited a bimodal distribution,with peaks at 07:00 and 18:00.The morning peak was larger than the evening peak.The mass percentages of BC in PM_2.5 and PM₁₀ were 7.1%and 4.8%,respectively.The absorption coefficient of BC was calculated to be 44.4 Mm^-1,which accounted for 11.1%of the total aerosol extinction.BC was mainly emitted from local sources in southwestern Jiaxing where BC concentrations were generally greater than 11 μg/m³ during the measurement period.Correlation analysis indicated that the main sources of BC were motor vehicle exhaust,and domestic and industrial combustion.     

An effective interference suppression algorithm for visible light communication system based on DBSCAN

In order to improve the signal-to-noise ratio and mitigate the damage of noise to the communication quality,an effective interference suppression algorithm,which is based on the improved density-based spatial clustering of applications with noise algorithms,is proposed for visible light communication systems using the complementary metal–oxide–semiconductor image sensor as the receiver.Experimental results show that the algorithm can learn the region where the payload data is located,filter out the noise data,and greatly decrease the interference.The effect of the algorithm is also studied through bit error ratio performance.     

变角度纤维复合材料层合斜板的颤振分析

假设纤维方向角沿层合板的长度方向线性变化，研究了变角度纤维复合材料层合斜板的颤振．通过坐标变换将斜板变换为正方形板，采用层合板表面连续变化的速度环量来模拟空气对其的作用，速度环量分布利用Cauchy积分公式计算．建立了系统的Lagrange方程并采用Ritz法得到了层合板的自振频率和颤振/不稳定性分离临界速度．通过数值算例验证了本文模型和方法的正确性和收敛性，分析了各个铺层内纤维方向角的变化对自振频率和颤振/不稳定性分离临界速度的影响．研究结果表明，通过纤维的变角度铺设，可有效地提高层合板的基频和颤振/不稳定性分离临界速度．经合理设计的变角度复合材料层合板具有抑制颤振的作用．     

氮化铝薄膜的光学性能

分别使用X衍射仪和紫外（190 nm～800 nm）分光光度仪,测量了用分子束外延法生长在SiC（001）基底面上的AIN薄膜的X衍射、透射谱和不同温度下的吸收谱.X衍射表明:实验所用的AIN薄膜在c-轴存在应变和应力，该应变和应力主要是由于AIN的晶格常量与基底SiC的晶格常量不匹配所致.透射谱表明:AIN薄膜的禁带宽度大约为6.2eV；而其对应的吸收谱在6.2eV处存在一个明显的台阶,此台阶被认为是AIN薄膜中的带边自由激子吸收所产生,忽略激子的结合能(与禁带宽度相比),则该值就对应为AIN的禁带宽度.而其对应的不同温度下（10 k～293 k）的吸收谱的谱线的形状和位置无明显的变化表明:温度对AIN薄膜的禁带宽度亦无明显的影响，这主要是由于在AIN薄膜中存在着应力所致.     

Lukasiewicz 命题逻辑系统一种新的理论的相容度

根据演绎定理和完备性定理,应用公式真度理论在Lukasiewicz命题模糊逻辑系统中讨论理论Γ的相容性,根据矛盾式■是Γ-结论的真度的大小,提出了一种新的极指标和相容度的概念.给出了理论Γ相容、不相容及其它相关结论的充分必要条件,并且获得了相容度与发散度之间联系的重要关系式.     

Least‐squares finite element method on adaptive grid for PDEs with shocks

We apply the least‐squares finite element method with adaptive grid to nonlinear time‐dependent PDEs with shocks. The least‐squares finite element method is also used in applying the deformation method to generate the adaptive moving grids. The effectiveness of this method is demonstrated by solving a Burgers' equation with shocks. Computational results on uniform grids and adaptive grids are compared for the purpose of evaluation. The results show that the adaptive grids can capture the shock more sharply with significantly less computational time. For moving shock, the adaptive grid moves correctly with the shock. © 2005 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq, 2006     

原子吸收法测定血清中的无机磷和钙

本文叙述了用原子吸收法测定同一个少量血清样品中的无机磷和钙。血清用高氨酸沉淀蛋白后,加过量钼酸铵。在pH0.4～1.6范围内,用乙酸丁酯萃取生成的微量磷钼酸,与过量的钼酸铵分离。水相测钙,有机相用稀氨水反萃后测钼,间接分析磷。     

Nitro-PAPS分光光度法测定葡萄糖酸锌

为建立一种快速、简便、灵敏分光光度法测定葡萄糖酸锌方法,在非离子型表面活性剂聚氧乙烯失水山梨醇油酸单脂(Tween-80)及聚氧乙烯异辛基苯基醚(TritonX-100)存在下,用水溶性试剂2-(5-硝基-2-吡啶偶氮)-5-[N-正丙基-N-(3-磺酸丙基)氨基]苯酚二钠(简称Nitro-PAPS)作显色剂直接光度法测定葡萄糖酸锌。结果表明,该法显色络合物最大吸收波长为580nm,本法线性范围为0~1μg/mL,表观摩尔吸光数为1.41×105L.mol-1.cm-1,回收率为98.5%~102.8%。该法具有操作快速、简便、结果灵敏可靠等优点,应用本法直接测定补锌口服液葡萄糖酸锌含量,结果满意。     

玻璃载体表面脱氧核糖核酸的固定及其化学发光检测

用硅烷化偶联剂把ＤＮＡ直接共价固定在载玻片表面，将辣根过氧化物酶标记的探针与之进行核酸杂交，杂交后用增强的化学发光检测。方法的检出限为７５ｐｇ。研究了ＤＮＡ分子固定在玻璃载体表面的各种条件，并建立了在玻璃载体表面进行核酸杂交的体系，为研究光纤ＤＮＡ生物传感器打下了基础。     

Polymer nano- and microspheres with bumpy and chain-segregated surfaces

Reported is a novel and simple method for the preparation of polymer spheres bearing hemispherical surface bumps where one type of polymer chains concentrates. The method is used to produce spheres with a diameter between approximately 30 and approximately 500 nm. Spheres with chain-segregated bumpy surfaces may find applications in drug delivery and other areas.