喷雾干燥-固相煅烧法制备球形钛酸狸负极材料的研究

通过喷雾干燥-固相煅烧法制备了球形钛酸钾.不同于传统喷雾干燥工艺采用固态钛源进行制备,本文采用的前驱体是钾盐,分散剂和钛酸四丁酯制备出的硝酸氧钛的混合溶液.由于制备方法中前驱体为原子级均匀分布,化学计量比可精确控制,制备出的材料颗粒细小,粒径、成分分布均匀,电化学性能优异.同时研究了不同钾钛摩尔比以及煅烧温度对球形钛酸钾的形貌和成分的影响,并研究了其作为钾离子电池电极材料的电化学性能.结果表明,钾钛摩尔比为0.816,煅烧温度为 800 ℃时钛酸钾的电化学性能最好,首圈容量 185.1 mAh/g,30 圈后容量为173.9 mAh/g,循环100圈后还有169.7 mAh/g的容量.     

熵的一种通俗教法

熵如力、能量和动量一样是物理学中一个重要概念,若能用一种通俗易懂的方法设计熵的教学,对文科物理的教学有重要意义.为此本文提出了一种通俗的熵的教法,这一教法不需要学生学习热力学第二定律也可以建立熵的概念.具体教学设计如下:通过日常生活例子引入熵的概念(也就是玻尔兹曼熵),设计两个例子让学生会计算熵,通过具体问题的讨论让学生充分理解熵的意义,通过一个实例由玻尔兹曼熵引入克劳修斯熵公式,设计一个演示实验强化教学效果,将熵与环境保护联系起来融入人文情怀,最后还强调了熵计算的不同层次.教学设计完全采用基于问题学习(PBL)的教学模式.     

Measured and Predicted Solubility Phase Diagrams of Quaternary Systems LiBr-NaBr-MgBr2-H2O and LiBr-KBr-MgBr2-H2O at 298.15 K

The stable phase equilibria of quaternary systems LiBr-NaBr-MgBr₂-H₂O and LiBr-KBr-MgBr₂-H₂O at 298.15 K were studied by both experimental measurement(isothermal solution saturation method) and theoretical prediction(Pitzer model). The solubilities of the saturated solution have been determined experimentally and two stable phase diagrams and relevant water diagrams of the two quaternary systems were obtained. Results show that quaternary system LiBr-NaBr-MgBr₂-H₂O is hydrate II type as NaBr and NaBr·2H₂O coexistence. Its phase diagram consists of only one invariant point, four univariant curves, and five crystallization fields. The quaternary system LiBr-KBr-MgBr₂-H₂O is a complex type as the double salt KBr·MgBr₂·6H₂O formed. In addition to this double salt, the three single salts LiBr·2H₂O, KBr and MgBr₂·6H₂O also crystallize. In this paper, the solubilities of phase equilibria in above quaternary systems were also calculated by the Pitzer's electrolyte solution model. All the needed parameters can be obtained from the literature or be fitted by experimental data. On the Basis of the experimental and calculated results, the phase diagram of the quaternary system was plotted for comparison. It shows that the calculation results are consistent with the experimental ones.     

Surface of room temperature ionic liquid [bmim][PF6] studied by polarization- and experimental configuration-dependent sum frequency generation vibrational spectroscopy

Understanding and control of the surface properties such as molecular orientations are of great importance in numerous applications of ionic liquids. However, there remain discrepancies among the previous experimental and theoretical studies on the surface orientation and structures of room temperature ionic liquids(RTIL) systems. In this article, the orientation of 1-butyl-3-methylimidazolium([bmin]) cation at the air/liquid interface of a characteristic RTIL, 1-butyl-3-methylimidazolium hexafluorophosphate([bmim][PF6]), was investigated by the sum frequency generation vibrational spectroscopy(SFG-VS). Detailed polarization and experimental configuration analyses of the SFG-VS spectra showed the possibility of a small spectral splitting in the CH3 symmetric stretching region, which can be further attributed to the probable existence of multiple orientations for the interfacial [bmim] cations. In addition, the(N)–CH3 vibrations were absent, ruling out the prediction by several recent molecular dynamics simulations which state that portions of the [bmim] cations orient with a standing-up(N)–CH3 group at the ionic liquid surface. Hence, new realistic theoretical models have to be developed to reflect the complex nature of the ionic liquid surface.     

改进型磁绝缘线振荡器的设计和数值模拟

 综合两种现有磁绝缘线振荡器的优点，对器件进行改进，将双渐变结构、轭流片和阻抗渐变三种增大功率的机制综合考虑，利用二维半全电磁PIC程序进行数值模拟，设计了一种新的改进型磁绝缘线振荡器，当外加电压为550kV，电流为35kA左右时，在L波段获得了6GW的峰值输出功率。     

差分吸收光谱法测量大气痕量气体浓度误差分析及改善方法

差分吸收光谱技术(DOAS)中采用线性最小二乘拟合方法,用痕量气体标准差分吸收截面对测量得到的差分吸收光谱进行拟合,得出大气中痕量气体的浓度.计算结果的准确性不仅取决于光谱的测量精度,而且受标准差分吸收截面以及仪器函数和温度等诸多因素的影响.详细地分析了计算误差的产生原因,提出了用高浓度样品池得到标准吸收截面的方法,针对光谱固有结构,以及温度对标准吸收截面的影响,改进了浓度反演算法.大量的实验表明,综合运用上述方法,即便对低浓度的样气,相对测量误差也能降低到10%以下.     

电子束流品质对自由电子激光小信号增益影响的计算

对电子束有一定初始能量分散或角度分散时的自由电子激光小信号增益用较简便的方法进行了分析计算,并给出了一个渐近公式,结果与用计算机模拟解自由电子激光微分方程组得到的结果一致。     

辐射传递蒙特卡洛法精度分析及数值试验

本文建立了蒙特卡洛法模拟散射参与性介质内辐射传递计算模型。对蒙特卡洛法的计算精度及运行时间进行了较为详细的分析,提出了几种判断计算精度的方法。同时,借助蒙特卡洛法模拟辐射传递过程,进行数值“辐射实验”。利用该“实验结果”进行了物性反问题研究。在已知光学厚度的前提下,得到散射反照率与后半球辐射热流之间的单值函数关系。     

半导体激光器发射光谱实验仪

设计了一种半导体激光器发射光谱实验仪 ,可以用来观测LD发射的荧光光谱、激光光谱 ,以及了解光栅外腔选取单纵模、压窄线宽、波长调谐的机理 .该实验仪结构紧凑 ,物理概念清晰 ,适用于大专院校的光学实验教学