光寻址电位传感器的正交相位检波检测方法

光寻址电位传感器的幅度检测方法易受噪声干扰,灵敏度差,信噪比和精度低,且受调制光源的影响较大,影响检测结果的准确性.为此提出了一种基于正交相位检波的光寻址电位传感器检测方法.该方法是将光寻址电位传感器的输出光电流信号分别与两路正交信号相乘,通过低通滤波提取直流分量并相除,即可得到光寻址电位传感器的输出信号相位信息.与已有的光寻址电位传感器相位检测方法相比,该方法具有算法复杂度低、实时性高的优点.实验研究了调制光源光强对光寻址电位传感器幅度检测和相位检测的影响,对比分析了光寻址电位传感器的传统幅度检测方法与正交相位检波检测方法对pH检测的灵敏度、线性度及信噪比.结果表明,相比于幅度检测方法,调制光源光强对光寻址电位传感器的相位检测影响更小,在频率为10 kHz,pH的范围为1.68~10.01的情况下,相位检测方法比幅度检测方法测得的灵敏度增加了7 mV/pH,精度提高了14.9 mpH,非线性误差减小了0.003%,均方差减少了0.1051×10^-5,信噪比增加了8.2827 dB.该方法特别适用于弱光下的光寻址电位传感器检测.     

二氧化钒薄膜的低温制备及其性能研究

针对VO₂薄膜在微测辐射热计上的应用，采用射频反应溅射法，在室温下制备氧化钒薄膜；研究了氧分压对薄膜沉积速率、电学性质及成分的影响.通过调节氧分压，先获得成分接近VO₂的非晶化薄膜，再在400℃空气中氧化退火，便可制得高电阻温度系数，低电阻率的VO₂薄膜，电阻温度系数约为-4%/℃，薄膜方块电阻为R_□为100—300kΩ；薄膜在室温下沉积，400℃下退火的制备方法与微机电加工(micro electromechanic 关键词： 二氧化钒 电阻温度系数 氧分压 射频反应溅射法     

在不同激光脉宽下的高次谐波

用数值计算方法计算了不同强激光脉冲宽度下高次谐波的产生.我们发现对于激光场强度不高,不能有效电离初态的激光场,长脉冲宽度可以更有效产生高次谐波;而对于高场强的激光场,由于它能够在几个光学周期之内把原子的初态全部电离,所以短脉冲的激光场能够更有效产生高次谐波.     

光学仪器 遥感、空间光学仪器

TP73 2006065467空间遥感仪器卡塞格伦镜筒的设计及轻量化研究=Design and lightweight research of Cassegrain drawtubes in space remote instruments[刊,中]/刘春霞(中科院上海技物所．上海(200083))．//红外技术．—2006,28(5)．—253-256介绍了空间遥感仪器中卡塞格伦镜筒的结构设计,利用三维CAD技术构建了产品模型。针对主镜筒的轻量化问题,设计了几种结构方案,利用CAE有限元力学分析对设计方案进行了选择和评价,通过对整个装配体的静力学分析和模态分析考察了结构的整体性能。图4表2参5     

非线性光学 位相共轭、自聚焦等相关效应

O4372006010275不同基体刚性偶氮化合物光致光学各向异性及其唯象模拟=Photoinduced anisotropy of azo polymer with differentmatrices rigidity and their phenomenological si mulation[刊,中]/罗锻斌(华东理工大学物理系.上海(200237)),邓莉∥光学学报.—2005,25(10).—1385-1390在不同刚性的聚合物基体聚甲基丙烯酸甲酯(PM-MA)、聚乙烯咔唑(PVK)和聚苯乙烯(PS)薄膜基体中掺入相同质量分数(均为0.003)的分散红13(DR13)偶氮染料。以线偏振连续Ar 激光(514nm)作为控制光,连续He-Ne激光(632.8nm)作为信号光,考察了具有相同厚度的3…     

一种不等带宽光学梳状滤波器

提出了一种新型—Michelson—三面镜FabryPerot型50GHz不等带宽光学梳状滤波器设计方案,分析和模拟表明:该器件将一路信道间隔为50GHz的输入信号分离成信道间隔为100GHz的奇偶两路输出信号,其中在3dB处,奇数信道带宽大于30GHz用于10Gb/s传输,偶数信道带宽大于60GHz用于40Gb/s传输对于将来的40Gb/s系统,该器件具有优势.     

半导体激光自混频干涉式传感器中的干涉与调制

应用F-P模型，阐述了半导体激光自混频干涉式传感器的干涉与调制过程，同时给出了相应的计算．     

Harmonic beam splitter design and fabrication

Two problems of half-wave hole and high ripples in the transmittance region for a harmonic beam splitter had been pointed out and analyzed. Based on the application of a half-wavelength control and a new admittance matching methods, a harmonic beam splitter was designed and fabricated. The former method eliminated the half-wave hole fundamentally, and the latter smoothed high ripples in the transmittance region effectively. The matching stack consisted of a symmetrically periodic structure and provided a complete matching at the desired wavelength, i.e., both conditions for the equivalent admittance and phase thickness were fulfilled. Furthermore, both the theoretical and the tested curves had been given, and a good agreement between them was obtained.     

半无限空间中光子密度波扩散方程的求解

O436 2004064048 半无限空间中光子密度波扩散方程的求解=Solution of diffusion equation in semi-infinite space with photon density wave[刊,中]/朱拓(江南大学理学院.江苏,无锡(214036)),孔艳…∥光电子·激光.—2004,15(5).—625-629 改进了原无限大模型,求解了无限大空间中光子密     

Structure and Photoluminescence of Nano-ZnO Films Grown on a Si （100） Substrate by Oxygen- and Argon-Plasma-Assisted Thermal Evaporation of Metallic Zn

Nano-ZnO thin films were prepared by oxygen- and argon-plasma-assisted thermal evaporation of metallic Zn at low temperature, followed by low-temperature annealing at 300℃ to 500℃ in oxygen ambient. X-ray diffraction patterns indicate that the nano-ZnO films have a polycrystalline hexagonal wurtzite structure. Raman scattering spectra demonstrate the existence of interface layers between Zn and ZnO. Upon annealing at 400℃ for i h, the interface mode disappears, and photoluminescence spectra show a very strong ultraviolet emission peak around 381 nm. The temperature-dependent PL spectra indicate that the UV band is due to free-exciton emission.