Vacuum‐driven fluid manipulation by a piezoelectric diaphragm micropump for microfluidic droplet generation with a rapid system response time

Recently, we developed a convenient microfluidic droplet generation device based on vacuum‐driven fluid manipulation with a piezoelectric diaphragm micropump. In the present study built on our previous work, we investigate the influence of settings applied to the piezoelectric pump, such as peak‐to‐peak drive voltage (V_p‐p) and wave frequency, on droplet generation characteristics. Stepwise adjustments to the drive voltage in ±10‐V_p‐p increments over the range of 200?250 V_p‐p during droplet creation revealed that the droplet generation rate could be reproducibly controlled at a specific drive voltage. The droplet generation rate switched within <0.5 s after the input of a new voltage. Although the droplet generation rate depended on the drive voltage, this setting had almost no influence on droplet size. The frequency over the selected range (50?60 Hz) did not markedly influence the droplet generation rate or droplet size. We show that the current fluid manipulation system can be conveniently used for both droplet generation and for rapid droplet reading, which is required in many microfluidic‐based applications.     

双奇核188Au的准粒子带结构研究

利用在束γ谱学实验技术, 通过¹⁷³Yb(¹⁹F,4nγ)反应 布居了¹⁸⁸Au的高自旋态, 并对其准粒子带结构进行了研究. 基于实验测量结果, 对原有的双奇核¹⁸⁸Au能级纲图做了较大的修改. 通过系统性比较, 对15⁺以上的能级结构进行了讨论.     

A Simple Chaotic Circuit with Impulsive Switch Depending on Time and State

This paper presents a simple chaotic circuit consisting of two capacitors, one linear two-port VCCS and one time-state-controlled impulsive switch. The impulsive switch causes rich chaotic and periodic behavior. The circuit dynamics can be simplified into a one-dimensional return map that is piecewise linear and piecewise monotone. Using the return map, we clarify parameter conditions for existence of chaotic and periodic attractors and coexistence state of attractors.     

Magneto-Optical Measurement of Organic Conductor Using Rotational Cavity System

We have developed a new magneto-optical measurement system using a rotational cavity system equipped with a millimeter vector network analyzer and a 14 T solenoid type super conducting magnet. The measurement can be performed in the transmission configuration down to 1.6 K. The results of the precise angular dependence measurement of quasi-one-dimensional organic conductor (DMET)₂I₃ using the new system are shown, and its Fermi surface will be discussed in connection with the previous reports.     

Diversification of shotgun process

Three protocols for shotgun process are put forth in which simultaneous multi-fold reactions occur exclusively to each other. The first one involves simple combination of selective and non-selective reactions. Even if the simple protocol fails to give rise to the high selectivity, satisfactory outcome can be achieved by kinetic control or adjustment of functional groups.     

Rotational bands in 181Ta

High-spin states in ¹⁸¹Ta have been studied via the ¹⁷⁶Yb(¹¹B,α2n) reaction at 52 MeV using the PEX array and at 57 MeV using the NORDBALL array, with α-particle detection. The previously known, K^π=(7/2)⁺ ground state band and K^π=(9/2)⁻ band have been extended to spins (29/2)⁺ and (31/2)⁻, respectively. Two new one-quasiparticle bands, the K^π=(5/2)⁺ band built on the known (5/2)⁺ isomer and a K^π=((1/2)⁻) band have been observed. Two other rotational bands with three-quasiparticle structure, K^π=(15/2)⁻ and ((19/2)⁺ with π(7/2)[404]ν²(1/2)[510](9/2)[624] and π(9/2)[514]ν²(1/2)[510](9/2)[624] configurations, respectively, have been newly observed. The half-life of the K^π=((19/2)⁺) bandhead which decays to the head of the (15/2)⁻ band has been measured to be 140(36) ns. However, transitions from the ((19/2)⁺) state to the (15/2)⁻ band have not been observed. Received: 26 August 1998     

Effect of nitriding on grain oriented silicon steel bearing aluminum (the second study)

All kinds of high-permeability GO are manufactured using AlN as the main inhibitor. From a purely metallurgical viewpoint, three types of inhibitor preparation for high-permeability GO have been shown. They include a complete solution without nitriding, a complete precipitation with nitriding and a partial precipitation with nitriding. In this study, another possibility, i.e., a complete solution method with nitriding, was investigated to avoid the extra high-temperature slab reheating and to examine the effect of nitriding on GO bearing Al. This method can also provide the sharp Goss texture, and nitriding is shown to be very useful for changing the inhibitor intensity, depending on the primary grain size.     

Effects of natural polysaccharide addition on drug release from calcium-induced alginate gel beads

Calcium-induced alginate gel beads (Alg-Ca) containing various polysaccharides, including an alginate hydrolysate, were prepared and the drug release profiles were investigated. Hydrocortisone (HC) was gradually released from Alg-Ca into the mimic gastric fluid, while in intestinal fluid, it was quickly released with the dissolution of Alg-Ca. However, with Alg-Ca containing 5% chitin (CT), dissolution of Alg-Ca was not observed, and release of HC showed apparent zero-order kinetics. Furthermore, addition of the alginate hydrolysate altered the HC-release profile for Alg-Ca.