Fibre raman amplifier properties for applications to long-distance optical communications

This paper reviews recent theoretical and experimental studies on optical amplification by stimulated Raman scattering (Raman amplification) in single-mode optical fibres, and discusses its possible applications to long-distance optical communications. The fibre Raman amplifier can be used as an in-line optical amplifier in both repeaterless and non-regenerative all-optical repeater configurations. In the former application, signal transmission of over 400 km has been predicted theoretically, although high-power pump sources are considered to be required. In the latter configuration, in which optical fibre losses are compensated for by Raman gains, it has been shown that extremely long-distance transmission over more than 1000 km is feasible in terms of signal-to-noise ratio, where the distance achievable is mainly limited by the accumulation of Raman noise. Recent experimental demonstrations including bit-error rate measurements on the Raman amplified signal, and laser-diode pumped amplification, etc., are also reviewed. The results confirm the effectiveness of fibre Raman amplifiers in future long-haul systems.     

New approaches to liquid interfaces through changes in the refractive index and nonlinear susceptibility utilizing ultrashort laser pulses.

Molecules in inhomogeneous liquid environments, such as air/liquid, liquid/liquid, solid/liquid interfaces interact with each other specifically, and sometimes form characteristic structures and emerge unique properties. Here, we introduce two newly developed spectroscopic techniques, the total-internal-reflection ultrafast transient lens method (TIR-UTL) and second harmonic generation-coherent vibrational spectroscopy (SHG-CVS), to investigate the characteristic behaviors of molecules in such inhomogeneous environments. TIR-UTL probes the refractive-index change with sub-picosecond resolution and provides information on ultrafast changes in the population, density, and thermal properties, such as temperature increase and energy transfer from the solute molecules to the surrounding solvent molecules. On the other hand, SHG-CVS probes nonlinear susceptibility changes at the interfacial areas, and is expected to provide spectroscopic information on the low-frequency vibrational modes that reflect the corrective motion of the molecules in such an inhomogeneous environment. These new approaches are based on pump-probe techniques utilizing (ultra) short laser pulses. They are expected to provide further information on inhomogeneous environments from the viewpoints of solute-solvent interactions, changes in the molecular orientation, and the corrective motion of molecules at liquid interfaces.     

A simple and sensitive method for the determination of hydroxylamine in fresh-water samples using hypochlorite followed by gas chromatography.

A new and simple method for the determination of hydroxylamine in environmental water, such as fresh rivers and lakes using hypochlorite, followed by its gas choromatographic detection, has been developed. A glass vial filled with sample water was sealed by a butyl-rubber stopper and aluminum cap without head-space, and then sodium hypochlorite solution was injected into the vial through a syringe to convert hydroxylamine to nitrous oxide. The head-space in the glass vial was prepared with 99.9% grade N2 using a gas-tight syringe. After the glass vial was shaken for a few minutes, nitrous oxide in the gas-phase was measured by a gas chromatograph with an electron-capture detector. The dissolved nitrous oxide in the liquid-phase was calculated according to the solubility formula. The proposed method was applied to the analysis of fresh-water samples taken from Iu river and Hii river, flowing into brackish Lakes Nakaumi and Shinji, respectively.     

Fabrication and transport properties of multiwall carbon nanotube crossroads

A multiwall carbon nanotube crossroads has been fabricated by a manipulation technique using a glass microcapillary, and the low temperature transport properties investigated. The two-terminal conductance of an individual tube shows Tomonaga–Luttinger liquid behavior G∝T^α at high temperature and dI/dV ∝V ^α at low temperature. However, no evidence of such a power-law behavior is obtained in the four-terminal conductance at the junction, where the conductance shows an almost metallic behavior ‘corrected’ by weak localization. Weak localization would essentially appear in electron states at the junctions of MWNTs.     

Endoscopic Observation of Tissue by Narrowband Illumination

We propose a new illumination method for a medical endoscope: narrow band imaging (NBI), in which the spectral bandwidth of the filtered light is narrowed. To confirm how the spectral specifications of the filtered light influence a reproduced image, an experiment was conducted observing the endoscopic images of the back mucosa of a human tongue. In addition, the effect of NBI on endoscopic images was investigated through preliminary clinical tests in colonoscopy and upper gastrointestinal endoscopy. It has been shown that NBI can enhance the capillary pattern and the crypt pattern on the mucosa. These patterns are useful features for diagnosing an early cancer.     

Local structure analysis of smoky and colorless topaz using single crystal Al NMR

The angular dependence of the ²⁷Al NMR spectrum was measured for single crystals of smoky and colorless topaz, Al₂SiO₄(F,OH)₂. Smoky topaz was obtained by irradiating high energy neutrons to colorless topaz. The quadrupole coupling constant e²Qq/h and the asymmetry parameter η were obtained from the analysis of the angular dependences of quadrupole splitting of the ²⁷Al NMR spectrum. The local structures around the aluminum atoms in smoky and colorless topaz were discussed from the magnitude and the direction of the electric field gradient. The directions of principal axes of the EFG tensor of ²⁷Al were close to the directions of Al-O and Al-F bonds. The difference in the bond lengths between Al(1)-F(1) and Al(1)-F(2) was found to affect the x and y components of the EFG tensor.     

Analysis of Spectral Reflectance Using Normalization Method from Endoscopic Spectroscopy System

Objective assessment of gastrointestinal mucosal color is extremely important in the endoscopic diagnosis of digestive tract disease. In this paper, we propose a method to clarify the spectral characteristics of gastric and colon cancer. A large number of spectral reflectance data of mucous membrane are measured by the endoscopic spectroscopy system (ESS) in the National Cancer Center Hospital East, Kashiwa, Japan and the Department of Internal Medicine, Self-Defense Force Center Hospital, Tokyo, Japan. We assume that early cancer appears primarily in the spectral data of short wavelength, because it is usually present in a superficial cell where short wavelength light is scattered more strongly than long wavelength light. To identify the features in the short wavelength components, the spectral reflectance was divided by the reflectance of a long wavelength. We investigated the possibility of distinguishing early cancer from normal spectral data through statistical analysis, employing the projection axis as the mean difference between them. Early cancer and normal spectral data were projected on the projection axis, and the Student’s T-test was applied to evaluate the mean of the distribution between these data.     

Altered protein synthesis in rat kidney cells exposed to semiconductor materials

It is thought that the extensive industrial use of arsenic, gallium and indium, which have applications as the materials for III–V semiconductors, will increase human exposure to these compounds in the near future. We have undertaken the development of new biological indicators for assessing exposure to these elements. Element-specific alterations in protein synthesis patterns were expected to occur following exposure to arsenic compounds. We examined alterations in protein synthesis in primary cultures of rat kidney proximal tubule epithelial cells by sodium arsenite, gallium chloride and indium chloride, utilizing two-dimensional gel electrophoresis. After incubation with the chemicals for 20 h, newly synthesized proteins were labeled with [³⁵S]methionine. A protein with a molecular weight (M_r) of 30 000 was markedly induced on exposure to 10 μM arsenite or 300 μM gallium chloride, and synthesis of proteins with M_r values of 85 000, 71 000, 65 000, 51 000, 38 000 and 28 000 were also increased by exposure to arsenite and gallium chloride. No significant changes were observed upon exposure to indium. Some of these increased proteins could be heat-shock proteins.     

Purification and characterization of gamma-enolase from various mammals.

The gamma subunit of enolase (gamma-enolase) was purified from the brain tissues of cow, dog, goat, pig, rabbit, and rat. The purification was achieved in only three steps: ammonium sulfate-precipitation, DE 53 cellulose ion-exchange chromatography, and polyacrylamide gel electrophoresis (PAGE) in a preparative mode. The purification procedure was comparatively more simple than previously reported methods, and the yield of gamma-enolase was sufficient for subsequent structural and immunological analyses. In all mammals, the purified gamma-enolase migrated in sodium dodecyl sulfate-PAGE (SDS-PAGE) with a molecular mass of 46 kilodaltons (kDa), and the immunological cross-reactivity between those gamma-enolases was very strong. The structural homology of these gamma-enolases was examined by peptide mapping using cyanogen bromide cleavage and subsequent two-dimensional electrophoresis. The resulting peptide patterns were highly similar and in cow, dog, and goat, the patterns were almost identical. These results indicate that structural homology, that is, the species non-specificity of gamma-enolase, appears to be very high.     

Approximation of transient temperatures in complex geometries using fractional derivatives

It is shown that time-dependent temperatures in a transient, conductive system can be approximately modeled by a fractional-order differential equation, the order of which depends on the Biot number. This approximation is particularly suitable for complex shapes for which a first-principles approach is too difficult or computationally time-consuming. Analytical solutions of these equations can be written in terms of the Mittag-Leffler function. The approximation is especially useful if a suitable fractional-order controller is to be designed for the system.