On s-hamiltonian line graphs of claw-free graphs

For an integer $s\ge 0$, a graph $G$ is $s$-hamiltonian if for any vertex subset $S?V\left(G\right)$ with $\left|S\right|\le s$, $G?S$ is hamiltonian, and $G$ is $s$-hamiltonian connected if for any vertex subset $S?V\left(G\right)$ with $\left|S\right|\le s$, $G?S$ is hamiltonian connected. Thomassen in 1984 conjectured that every 4-connected line graph is hamiltonian (see Thomassen, 1986), and Ku?zel and Xiong in 2004 conjectured that every 4-connected line graph is hamiltonian connected (see Ryjá?ek and Vrána, 2011). In Broersma and Veldman (1987), Broersma and Veldman raised the characterization problem of $s$-hamiltonian line graphs. In Lai and Shao (2013), it is conjectured that for $s\ge 2$, a line graph $L\left(G\right)$ is $s$-hamiltonian if and only if $L\left(G\right)$ is $(s+2)$-connected. In this paper we prove the following.(i) For an integer $s\ge 2$, the line graph $L\left(G\right)$ of a claw-free graph $G$ is $s$-hamiltonian if and only if $L\left(G\right)$ is $(s+2)$-connected.(ii) The line graph $L\left(G\right)$ of a claw-free graph $G$ is 1-hamiltonian connected if and only if $L\left(G\right)$ is 4-connected.     

影响单摆实验的因素及改进方法

用单摆测定当地的重力加速度和单摆振动定律的验证,很容易做.下面谈谈影响单摆实验的几个因素及其解决方法.1 用单摆测定当地重力加速度 可见,g的测定主要取决于l和T.因此,为了提高实验的精度,在测量过程中必须注意以下几个方面.     

CPL冷凝单管融化过程的双倒易边界元分析

1引言CPL（毛细泵两相流回路）能传输较高的热负荷，而且不需要循环泵、阀门等运动部件，重量轻可靠性好；在飞行器热控制方面有很好的应用前景[1]。CPL在恶劣的空间环境中运行，需要防止工作介质出现冷冻，为此，我们已经用解析[2]和数值的方法[3]进行了初步的分析，得到了一些可供工程设计参考应用的结果。另外，在恶劣的空间环境中，如果出现冻结，需要融化起动，热管的安全设计需要研究它的融化特性，以确保热管在空间能正常运行。双倒易边界元方法用Laplace基本解[4]，通过对一类偏微分方程两侧进行转化，将它全部转化为纯边界积分…     

大学物理实验中分类教学的探索和研究

本文对大学物理实验课程的教学现状进行了分析,提出了对大学物理实验课程进行分类教学改革的指导思想和遵循的原则及采取的措施。     

反应磁控溅射制备TiO2和Nb2O5混合光学薄膜

利用反应磁控溅射技术在BK-7基片上制备了二氧化钛和五氧化二铌均匀混合的光学薄膜.薄膜的内部微结构、表面形貌、化学成分比例以及光学性质等用X射线衍射、高分辨扫描电子显微镜、原子力显微镜、X射线光电子能谱和紫外可见近红外分光光度计进行研究；发现制备的薄膜为非晶结构，薄膜的表面平整、内部结构致密，不存在柱状结构或结晶颗粒的缺陷，TiO2与Nb2O5的成分比例大致是1∶1.54.从光学透射光谱计算的折射率和消光系数显示，在550 nm波长处的折射率为2.34，消光系数为2.0×10－4.结果表明制备的薄膜是TiO2和Nb2O5均匀混合的高质量光学薄膜.     

Hamiltonian N2‐locally connected claw‐free graphs

A graph G is N₂‐locally connected if for every vertex ν in G, the edges not incident with ν but having at least one end adjacent to ν in G induce a connected graph. In 1990, Ryjá?ek conjectured that every 3‐connected N₂‐locally connected claw‐free graph is Hamiltonian. This conjecture is proved in this note. © 2004 Wiley Periodicals, Inc. J Graph Theory 48: 142–146, 2005     

成分和厚度的依赖

通过调整Mn的成分，系统地研究了Ni81Fe19/Ni100-xMnx双层膜的磁学性质，特别是交换偏置场(Hex)的变化.当Ni100-xMnx中Mn的原子百分比在534%到600%之间时，对于150nm的Ni81Fe19，得到了最大的交换偏置场175kA/m，同时由于Mn对Ni81Fe19层的扩散所造成的磁矩的降低小于20%；高角x射线衍射证明Ni100-xMnx的晶格常数随着Mn成分的改变而变化，Mn含量越多，其晶格常数越大；制备态Ni100-xMnx膜晶格常数与θ相NiMn膜晶格常数的接近程度与NiMn膜θ相形成的容易程度相对应.也研究了交换偏置场随着Ni１００-xMnx厚度的变化，第一次得到了当Ni100-xMnx中Mn的原子百分比为706%时，Ni81Fe19(150nm)/Ni100-xMnx(90nm)双层膜在经过240℃，5h退火后，可以有80kA/m的交换偏置场，此时铁磁层磁矩的大小几乎不变. 关键词： Ni81Fe19/Ni100-xMnx 交换偏置场     

Highly strained InxGa(1−x)As−InyAl(1−y)As (x>0.8,y<0.3) layers for short wavelength QWIP and QCL structures grown by MBE

Highly strained quantum cascade laser (QCL) and quantum well infrared photodetector (QWIPs) structures based on In_xGa_(1−x)As−In_yAl_(1−y)As (x>0.8,y<0.3) layers have been grown by molecular beam epitaxy. Conditions of exact stoichiometric growth were used at a temperature of 420°C to produce structures that are suitable for both emission and detection in the 2–5 μm mid-infrared regime. High structural integrity, as assessed by double crystal X-ray diffraction, room temperature photoluminescence and electrical characteristics were observed. Strong room temperature intersubband absorption in highly tensile strained and strain-compensated In_0.84Ga_0.16As/AlAs/In_0.52Al_0.48As double barrier quantum wells grown on InP substrates is demonstrated. Γ–Γ intersubband transitions have been observed across a wide range of the mid-infrared spectrum (2–7 μm) in three structures of differing In_0.84Ga_0.16As well width (30, 45, and 80 Å). We demonstrate short-wavelength IR, intersubband operation in both detection and emission for application in QC and QWIP structures. By pushing the InGaAs–InAlAs system to its ultimate limit, we have obtained the highest band offsets that are theoretically possible in this system both for the Γ–Γ bands and the Γ–X bands, thereby opening up the way for both high power and high efficiency coupled with short-wavelength operation at room temperature. The versatility of this material system and technique in covering a wide range of the infrared spectrum is thus demonstrated.     

Combined effects of clay modifications and compatibilizers on the formation and physical properties of melt‐mixed polypropylene/clay nanocomposites

The melt mixing technique was used to prepare various polypropylene (PP)‐based (nano)composites. Two commercial organoclays (denoted 20A and 30B) served as the fillers for the PP matrix, and two different maleated (so‐called) compatibilizers (denoted PP‐MA and SMA) were employed as the third component. The results from X‐ray diffraction (XRD) and transmission electron microscope (TEM) experiments revealed that 190 °C was an adequate temperature for preparing the nanocomposites. Nanocomposites were achieved only if specific pairs of organoclay and compatibilizer were simultaneously incorporated in the PP matrix. For example, PP/20A(5 wt %)/PP‐MA(10 wt %) and PP/30B(5 wt %)/SMA(5 wt %) composites exhibited nanoscaled dispersion of 20A or 30B in the PP matrix. Differential scanning calorimetry (DSC) results indicated that the organoclays served as nucleation agents for the PP matrix. Generally, their nucleation effectiveness increased with the addition of compatibilizers. The thermal stability enhancement of PP after adding 20A was confirmed with thermogravimetric analysis (TGA). The enhancement became more evident as a suitable compatibilizer was further added. However, for the 30B‐included composites, thermal stability enhancement was not evident. The dynamic mechanical properties (i.e., storage modulus and loss modulus) of PP increased as the nanocomposites were formed; the properties increment corresponded to the organoclay dispersion status in the matrix. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4139–4150, 2004     

CATALYSIS OF POLYSTYRENE N-HYDROXYL SULFONAMIDE FOR ESTERIFICATION OF BUTANOL WITH ACETIC ANHYDRIDE

1. INTRODUCTION The development of efficient polymer-supported catalysts has attracted much attention [1]. For obtaining polymeric catalysts, catalytically active groups were introduced onto polymers mostly by copolymerization of the appropriate monomers bearing the desired catalyticfunctionalities (e.g. imidazole, OH, and COOH) or by modification of preformed polymers.Another possibility involves the attachment of side chains, containing the desired arrangement of functional groups, o…