High-throughput characterization of local conductivity of Nd0.9Ca0.1Ba2Cu3O7−δ thin film by the low-temperature scanning microwave microscope

We developed a scanning microwave microscope (SμM) designed for high-throughput electric-property screening as well as for rapid construction of electronic phase diagrams at low temperatures. As a sensor probe, we used a high-Qλ/4 coaxial cavity resonator to which a thin needle with ball-tip end was attached. The sensor module was mounted on the low-temperature XYZ stage, which allowed us to map out the change of resonance frequency and quality factor due to the local tip-sample interaction at low temperatures. From the measurements of combinatorial thin films, such as Ti_1−xCo_xO_2−δ and Nd_0.9Ca_0.1Ba₂Cu₃O_7−δ (NCBCO), it was demonstrated that this SμM system has enough performance for the high-throughput characterization of sample conductance under variable temperature conditions.     

Reduction of dislocation density and improvement of optical quality in ZnO layers by MgO-buffer annealing

Optical properties of ZnO thin films with/without MgO-buffer annealing were investigated by low and room temperature photoluminescence measurements. The ZnO films were grown on c-sapphire substrates by plasma-assisted molecular-beam epitaxy employing a thin MgO-buffer layer. Dislocation density of ZnO layer was reduced from 5.3 × 10⁹ to 1.9 × 10⁹ cm⁻² by annealing MgO-buffer prior to the growth of ZnO. The intensity of free exciton emission from the sample with MgO-buffer annealing was almost twice of that from the sample without annealing, while the deep level emission from the sample with MgO-buffer annealing was about 1/3 of that without annealing. The MgO-buffer annealing improves optical quality of overgrown ZnO films.     

Investigation of the drying conditions for amidosulfuric acid.

The drying conditions for primary standards of volumetric analysis have a significant effect on the titration results due to changes in the purity, stability and homogeneity. Amidosulfuric acid, a strong acid used as a reference material for volumetric analysis in Japan, was dried in a vacuum desiccator or heated at different temperatures, and then measured by Karl-Fischer titration, thermogravimetry/mass spectroscopy (TG-MS), ion chromatography and coulometric titration. The optimum drying conditions were at 50 degrees C for 24 h with crushing.     

Inhibitory effects of 3-O-acyl-(+)-catechins on Epstein-Barr virus activation

In the course of an exploratory investigation of antitumor-promoting catechins, 3-O-acyl-(+)-catechins of varying carbon lengths from C(4) to C(18) were assessed for inhibitory effects on the activation of the Epstein-Barr virus early antigen. Like 3-O-acyl-(-)-epigallocatechins, the (+)-catechin derivatives showed promising effects with the C-3 acyl chain of C(8)-C(11) carbon atoms.     

Synthesis,crystal structure and charge transport characteristics of stable peri-tetracene analogues

peri-Acenes have shown great potential for use as functional materials because of their open-shell singlet biradical character. However, only a limited number of peri-acene derivatives larger than peri-tetracene have been synthesized to date, presumably owing to the low stability of the target compounds in addition to the complicated synthesis scheme. Here, a very simple synthesis route for the tetrabenzo[a,f,j,o]perylene (TBP) structure enables the development of highly stable peri-tetracene analogues. Despite a high degree of singlet biradical character, the compounds with four substituents at the zigzag edge show a remarkable stability in solution under ambient conditions, which is better than that of acene derivatives with a closed-shell electronic configuration. The crystal structures of the TBP derivatives were obtained for the first time; these are valuable to understand the relationship between the structure and biradical character of peri-acenes. The application of peri-acenes in electronic devices should also be investigated. Therefore, the semiconducting properties of the TBP derivative were investigated by fabricating the field-effect transistors.

Highly stable peri-tetracene analogues with a high degree of singlet biradical character were synthesized in a very simple route, and their crystal structures and semiconducting properties were investigated.     

Total Synthesis of Natural PI-091, a New Platelet Aggregation Inhibitor of Microbial Origin

The total synthesis of a new platelet aggregation-inhibiting gamma-lactam PI-091 (1) gave a 1:1 diastereomeric mixture at the gamma-ketal carbon. The high-yielding aldol reaction of an appropriately protected 1,3,4-trihydroxy-4-methyldecan-2-one 42, prepared from D-glucose, with the kinetically generated enolate of 3-methyl-2-butanone provided 43. The resulting diastereomeric mixture of the aldol adduct 43 was converted to a 2,4-alkylated furan 45 via an intramolecular ketalization followed by dehydration. The addition of a singlet oxygen to the alpha-trimethylsilylated furan 48derived from 45 under photochemical conditions efficiently provided an alpha,gamma-dialkylated gamma-hydroxy gamma-lactone 47. The transformation of methyl ketal 52 prepared from 47 into gamma-hydroxy gamma-lactam 53 was achieved by exposure to liquid ammonia in MeOH. The total synthesis of 1 was achieved from 52 through the Dess-Martin periodinane oxidation of the secondary hydroxy group in the side chain. The present total synthesis revealed that the stereogenic carbon center in the side chain in natural 1 is S.     

The flameless atomic absorption spectrometric determination of aluminum with a carbon atomization system

The atomic absorption spectrometry of aluminum with a carbon tube atomizer is described, with particular reference to the heating cycle, argon flow rate and amplifier time constant. Interferences are eliminated by pre-atomization heating or with a hydrogen-argon-entrained air flame. Under optimal conditions, the sensitivity (1 % absorbance) is 5·10^?11g, and the relative standard deviation is 2.3 for 2.5 ng Al.     

Optical microscopy and in situ Raman scattering of single crystalline ethylene hydrate and binary methane-ethylene hydrate at high pressures

Visual observations through a microscope and in situ Raman measurements have been made for single crystalline ethylene hydrate (EH) and binary methane-ethylene hydrate (MEH) at pressures up to 3.7 GPa and room temperature. Both hydrates showed pressure-induced phase transitions at 1.6, 2.0, and 3.0 GPa for EH and at 1.7, 2.1, and 3.3 GPa for MEH. The cubic sI phase of EH and MEH remains stable up to 1.6 and 1.7 GPa, respectively, which are more widely ranging values than the values for the methane hydrate sI phase. In this sI phase of binary MEH, the cage occupancies by methane and ethylene molecules are investigated from Raman spectra. Above P = 3.0 GPa for EH and 3.3 GPa for MEH, they decomposed by associating with the formation of the polyethylene.     

How constant are Ritchie's "constant selectivity relationships"? A general reactivity scale for n-, pi-, and sigma-nucleophiles

The kinetics of 82 reactions of benzhydrylium ions (Ar(2)CH(+)) with n-nucleophiles has been determined at 20 degrees C. Evaluation by the equation log k = s(N + E) delivered the reactivity parameters N and s for 15 n-nucleophiles (water, hydroxide, amines, etc.). All nucleophiles except water (s = 0.89) and (-)SCH(2)CO(2)(-) (s = 0.43) have closely similar slope parameters (0.52 < s < 0.71), indicating that the reactions of most n-nucleophiles approximately follow Ritchie's constant selectivity relationship (s = constant). The different slope parameter for water is recognized as the main reason for the deviations from the Ritchie relationship reported in 1986. Correlation analysis of the rate constants for the reactions of benzhydrylium ions with the n-nucleophiles (except H(2)O) on the basis of Ritchie's equation log k = N(+) + log k(0) yields a statistically validated set of N(+) parameters for Ritchie-type nucleophiles and log k(0) parameters for benzhydrylium ions. The N and s parameters of the n-nucleophiles derived from their reactions with benzhydrylium ions were combined with literature data for the reactions of these nucleophiles with other carbocations to yield electrophilicity parameters E for tritylium, tropylium, and xanthylium ions. While the E parameters for tropylium and xanthylium ions appear to be generally applicable, it is demonstrated that the E parameters of tritylium ions can be used to predict reactivities toward n-nucleophiles as well as hydride transfer rate constants but not rates for the reactions of tritylium ions with pi-nucleophiles. It is now possible to merge the large data sets determined by Ritchie and others with our kinetic data and present a nucleophilicity scale comprising n- (e.g., amines), pi- (e.g., alkenes and arenes), and sigma-nucleophiles (e.g., hydrides).     

Enantiodifferentiating photoaddition of alcohols to 1,1-diphenylpropene in supercritical carbon dioxide: sudden jump of optical yield at the critical density

In the enantiodifferentiating photoaddition of ROH (R = Me, Et, i-Pr) to 1,1-diphenylpropene sensitized by fructosyl 1,4-naphthalenedicarboxylate in supercritical carbon dioxide, the enantiomeric excess of photoadduct increased with increasing bulkiness of the alcohol at all pressures used, with an accompanying sudden jump at the critical density, for which the enhanced clustering of alcohol, particularly in the subcritical pressure region, was revealed to be responsible from the fluorescence spectral examinations.