Vacuum‐driven fluid manipulation by a piezoelectric diaphragm micropump for microfluidic droplet generation with a rapid system response time

Recently, we developed a convenient microfluidic droplet generation device based on vacuum‐driven fluid manipulation with a piezoelectric diaphragm micropump. In the present study built on our previous work, we investigate the influence of settings applied to the piezoelectric pump, such as peak‐to‐peak drive voltage (V_p‐p) and wave frequency, on droplet generation characteristics. Stepwise adjustments to the drive voltage in ±10‐V_p‐p increments over the range of 200?250 V_p‐p during droplet creation revealed that the droplet generation rate could be reproducibly controlled at a specific drive voltage. The droplet generation rate switched within <0.5 s after the input of a new voltage. Although the droplet generation rate depended on the drive voltage, this setting had almost no influence on droplet size. The frequency over the selected range (50?60 Hz) did not markedly influence the droplet generation rate or droplet size. We show that the current fluid manipulation system can be conveniently used for both droplet generation and for rapid droplet reading, which is required in many microfluidic‐based applications.     

Crosslinking network of bio‐based bis‐functional epoxides derived from trans‐limonene oxide

The thiol‐ene reaction between trans‐limonene oxide (trans‐LO) and ethane‐1,2‐dithiol in the presence of triethylborane affords a bio‐based bis‐functional epoxide (bis‐trans‐LO). The crosslinking reaction of bis‐trans‐LO with branched polyethyleneimine (BPEI; M_n = 600; BPEI₆₀₀) at a feed ratio of bis‐trans‐LO/BPEI₆₀₀ = 57/43 (wt/wt) yields the corresponding network polymer with T_d10 (10% thermal decomposition temperature) of 304.7 °C in 98% yield. In contrast, negligible amounts of network polymer are obtained by the reaction of bis‐LO (bis‐functional epoxide derived from cis and trans‐LO) and BPEI₆₀₀ regardless of the feed ratio. The mechanical strengths as measured by direct tensile tests of the network polymers derived from bis‐trans‐LO and BPEI_600,1800 (M_n = 600 and 1800) were approximately 16 and 11 times higher than that of bis‐LO and BPEI₁₈₀₀, respectively. The tensile shear strengths of the metal‐to‐metal adhesive bonds induced by bis‐trans‐LO and BPEI_600,1800 were 9.5 and 14.1 MPa, respectively. DMA revealed that the storage modulus of the network polymer derived from bis‐trans‐LO and BPEI₁₈₀₀ in the rubber region was higher than that of the material prepared from bis‐LO and BPEI₁₈₀₀, indicating higher crosslink density of the bis‐trans‐LO/BPEI₁₈₀₀ system. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019 , 57, 2466–2473     

Simulation of a High Harmonic Gyrotron with Axis-Encircling Electron Beam and Permanent Magnet

A computer code for simulation of beam-field interaction in a resonant cavity of a gyrotron has been developed. It is based on a self-consistent, time-independent, single-mode physical model. The code has been applied to the analysis of the electrodynamical system of a novel high-harmonic gyrotron with axis-encircling beam and a permanent magnet. In this paper both the physical model and numerical techniques used are outlined. Some results of the numerical experiments are presented and discussed.     

Interfacial adsorption state of protonated lipophilic porphyrins in a liquid-liquid system by using reflection spectrometry.

Analysis by reflection spectrometry was performed to clarify the interfacial adsorption of protonated lipophilic tetraphenylporphyrin derivatives in a dodecane-aqueous sulfuric acid system, and to confirm the utility of partial reflection spectroscopy. Interfacial adsorption was not observed for porphyrins substituted at the 2,6 positions of meso-phenyl groups, suggesting that the substituents prevent porphyrins from forming aggregates by steric hindrance. Polymorphous J-aggregates of acid dications were produced by tetra-p-tolylporphyrin with a saturated interfacial molecular density of 1.0 x 10(-10) mol cm(-2), which could yield 48 degrees as a mean tilting angle of the pyrrole ring plane from the interface normal. Partial-reflection spectrometry can provide sensitive detection and molecular orientation analysis of interfacial adsorbates.     

Gamma-ray spectroscopy of the neutron-rich Ni region through heavy-ion deep-inelastic collisions

Nuclei in the neutron-rich Ni region have been studied by γ-ray spectroscopy. Gamma-rays emitted from isomers, with T _1/2 > 1 ns, produced in heavy-ion deep-inelastic collisions were measured with an isomer-scope. The nuclear structure of the doubly magic ⁶⁸Ni and its neighbor ^69,71Cu is discussed on the basis of the shell model. Future experiments for more neutron-rich Ni nuclei are also viewed. Received: 1 May 2001 / Accepted: 4 December 2001     

Application of Novel Focusing Mirrors in Gyrotron Transmission Lines

A novel focusing mirror based on the shifting of the beam phase according to the Gaussian beam optics enabled us to realize a focusing elements with different focal lengths in different directions and to convert the gyrotron output into a Gaussian-like beam. In this paper, we compare the quality of beams produced by the new system (which includes novel mirrors) and a conventional system consisting of a quasi-optical antenna, an ellipsoidal mirror and two parabolic cylinder mirrors.     

Construction of self-assembled monolayer terminated with N-heterocyclic carbene-rhodium(I) complex moiety

Functionalization of self-assembled monolayer (SAM) of alkanethiolate with metal containing unit is one of the versatile methods to obtain functional surfaces such as heterogeneous catalysts. However, organic molecules that strongly bind to transition metals at SAM terminal are limited. Recently N-heterocyclic carbenes (NHCs) such as cyclic diaminocarbenes have emerged as strongly σ-donating ligands forming a robust bond with broad spectrum of transition metals. In the present study, for the purpose of establishment of a new robust basement for heterogeneous metal catalysts, a SAM of the alkanethiolate terminated with NHC-rhodium(I) complex moiety was prepared by utilizing a newly designed disulfide molecule bearing NHC-metal complex terminals. X-ray photoelectron spectroscopy (XPS) analysis and angle resolved XPS measurement revealed successful formation of the Rh-complex-terminated SAM on a gold substrate. Infrared reflection absorption spectroscopy (IRRAS) analysis suggested that the linker methylene chains connecting the rhodium complex moiety and the gold surface are in a loosely packed structure. This unique chemical species, NHC, would be a promising candidate as a basement for the construction of functional surface.     

Stereocontrolled synthesis of exocyclic olefins using arene tricarbonyl chromium complex-catalyzed hydrogenation. I. Efficient synthesis of carbacyclin and its analogs

An efficient synthesis of carbacyclin and its analogs (2-7) is described in which the stereospecific 1,4-hydrogenation of a 1,3-diene to an internal monoene plays a key role. That is, arene.Cr(CO)3 complex-catalyzed 1,4-hydrogenation of the dienes 13 and 58, obtainable from the Corey lactone in good yields, under high H2 pressure afforded the exocyclic olefins 14 and 61 stereospecifically in excellent yields, and these intermediates were converted to therapeutically useful carbacyclin (2) and its analogs 3-7 in a usual way.