Strategies for synthesizing non-bioaccumulable alternatives to PFOA and PFOS

This minireview describes the strategies for synthesis of fiuorinated surfactants potentially nonbioaccumulable.Various strategies have been focused on(Ⅰ) reducing the length of the perfluorocarbon chain,(Ⅱ) introducing hetero atoms into the fluorocarbon chain,(Ⅲ) introducing branch(herein and after branch means the fluoro-carbon chain section is not straight).In most cases,the surface tensions versus the surfactant concentrations have been assessed.These above strategies led to various highly fiuorinated(perfluorinated or not perfluorinated) surfactants whose chemical changes enabled to obtain novel alternatives to perfluorooctanoic acid(PFOA) and perfluorooctane sulphonate(PFOS).     

Two cubane-like [M4O4] {M = nickel(II), cobalt(II)} complexes: syntheses,crystal structures and magnetic properties

Transition Metal Chemistry - Two cubane-like complexes, namely [Ni4L4(HOEt)4] (1), [Co4L4(HOEt)4] (2) (H2L?=?(E)-2-((3-hydroxypropylimino)methyl)-6-methoxyphenol), were prepared under...     

Evaluation of Charged Defect Energy in Two-Dimensional Semiconductors for Nanoelectronics: The WLZ Extrapolation Method

Defects play a central role in controlling the electronic properties of two-dimensional (2D) materials and realizing the industrialization of 2D electronics. However, the evaluation of charged defects in 2D materials within first-principles calculation is very challenging and has triggered a recent development of the WLZ (Wang, Li, Zhang) extrapolation method. This method lays the foundation of the theoretical evaluation of energies of charged defects in 2D materials within the first-principles framework. Herein, the vital role of defects for advancing 2D electronics is discussed, followed by an introduction of the fundamentals of the WLZ extrapolation method. The ionization energies (IEs) obtained by this method for defects in various 2D semiconductors are then reviewed and summarized. Finally, the unique defect physics in 2D dimensions including the dielectric environment effects, defect ionization process, and carrier transport mechanism captured with the WLZ extrapolation method are presented. As an efficient and reasonable evaluation of charged defects in 2D materials for nanoelectronics and other emerging applications, this work can be of benefit to the community.     

气体压强对纳秒激光诱导空气等离子体特性的影响

环境气体的压强对激光诱导等离子体特性有重要影响.基于发射光谱法开展了气体压强对纳秒激光诱导空气等离子体特性影响的研究,探讨了气体压强对空气等离子体发射光谱强度、电子温度和电子密度的影响.实验结果表明,在10-100 kPa空气压强条件下,空气等离子体发射光谱中的线状光谱和连续光谱依赖于气体压强变化,且原子谱线和离子谱线强度随气体压强的变化有明显差别.随着空气压强增大,激光击穿作用区域的空气密度增加,造成激光诱导击穿空气几率升高,从而等离子体辐射光谱强度增大.空气等离子体膨胀区域空气的约束作用,增加了等离子体内粒子间的碰撞几率以及能量交换几率,并且使离子-电子-原子的三体复合几率增加,因此造成原子谱线OⅠ777.2 nm与NⅠ821.6 nm谱线强度随着气体压强增大而增大,在80 kPa时谱线强度最高,随后谱线强度缓慢降低.而离子谱线N Ⅱ 500.5 nm谱线强度在40 kPa时达到最大值,气体压强大于40 kPa后,谱线强度随压强增加而逐渐降低.空气等离子体电子密度均随压强升高而增大,在80 kPa后增长速度变缓.等离子体电子温度在30 kPa时达到最大值,气体压强大于30 kPa后,等离子体电子温度逐渐降低.研究结果可为不同海拔高度的激光诱导空气等离子体特性的研究提供重要实验基础,为今后激光大气传输、大气组成分析提供重要的技术支持.     

Global dynamics of a flexible asymmetrical rotor

Nonlinear Dynamics - Global dynamics of a flexible asymmetrical rotor resting on vibrating supports is investigated. Hamilton’s principle is used to derive the partial differential governing...     

YBa2Cu1-xCox(Cu1-yZny)2Oz体系的Co,Zn共同掺杂效应

本文报道通过对YBa₂Cu_1-xCo_x(Cu_1-yZn_y)₂O_z(0≤x,y≤0.1)体系晶体结构、氧含量、正常态电阻-温度关系、Hall效应以及超导临界温度等的综合测量,发现随着Co和Zn含量的增加,体系经历了从正交结构的超导金属向四方结构的非超导半导体的转变,超导临界温度T_c和载流子浓度n_h均迅速下降,Co 关键词：     

355nm Nd∶YAG激光在H_2中的高效一级斯托克斯转换

对脉冲Nd∶YAG激光(355 nm)在H2和H2∶He-Ar混合气体中的受激拉曼散射(SRS)进行了研究。在0.5 MPa的氢气中,同时测量到从二级反斯托克斯到三级斯托克斯的多波长输出,其总转化效率达88%;而高压下只剩下一级和二级斯托克斯输出,其中二级斯托克斯最大能量转化效率达44%(对应量子效率为63%)。由于高级斯托克斯的竞争,纯氢气中一级斯托克斯的最大能量转换效率不超过43%。通过向3 MPa氢气中掺入2 MPaAr气后,很好地抑制了二级斯托克斯的产生,从而获得了能量转换效率高达71%(对应量子效率为83%)的一级斯托克斯输出。对四波混频和级联受激拉曼散射在氢气多级斯托克斯产生中的作用以及惰性气体对它们的影响进行了讨论。     

空间有源消声的微机控制

本文讨论用通用微机控制空间有源消声．以修正的PID（比例、积分、微分）算法加上逻辑判断构成的控制软件，使得系统收敛迅速，跟踪速度快，消声效果令人满意，而且系统工作稳定可靠，     

射流式单重态氧发生器研究

单重态氧O2 (a1Δg)是迄今唯一能用纯化学反应高效产生的具有长寿命的亚稳激发态分子 .为了考察提出的用两个O2 (1Δ)能量汇集反应生成氧第二单重激发态O2 (b1Σ+ g)以实现近可见短波长化学激光方案的现实性 ,设计和实验了一个氯流量为 3～ 10mmol/s的射流式单重态氧发生器 (JSOG) .考察了三种具有不同孔径和孔数目的喷头、氯气流量和脱水冷阱温度等对JSOG出口的O2 (1Δ)浓度、O2 (1Δ)分压、氯利用率及水蒸气含量的影响 .发现用聚氯乙烯管作冷阱时 ,最佳冷阱介质温度为 - 140～ - 15 0℃ ,对此提出了O2 (1Δ)表面脱活与脱水互相竞争的解释 .在最佳条件下 ,可将O2 (1Δ)气中水分压降低至 4Pa ,这一结果是首次报导