吹气孔直径对RH精炼过程钢液流动和混合特性的影响

针对90t RH精炼装置,以水力学模拟研究了吹气孔直径对真空循环精炼过程中钢液流动和混合特性的影响.模型和原型的相似比为15.模型吹气孔直径分别为0.8 mm和1.2 mm.结果表明,1.2 mm孔径下环流量和主要工艺参数间的关系为Ql Q80.26Du0.69Dd0.80;在给定的吹气量和插入管内径下,增大吹气孔直径并不显著改变精炼过程中钢液流动特征,环流量随吹气孔直径的增大而略有增大,其关系式为Ql=2.40Q 0.23gD0.72u D0.88d d0.13in;相应地,混合时间稍有缩短;0.8和1.2 mm孔径下,τm与搅拌能密度的关系分别为τm ε5和τm ε0.49.     

Peptide late-stage C(sp3)–H arylation by native asparagine assistance without exogenous directing groups

There is a strong demand for novel native peptide motifs for post-synthetic modifications of peptides without pre-installation and subsequent removal of directing groups. Herein, we report an efficient method for peptide late-stage C(sp³)–H arylations assisted by the unmodified side chain of asparagine (Asn) without any exogenous directing group. Thereby, site-selective arylations of C(sp³)–H bonds at the N-terminus of di-, tri-, and tetrapeptides have been achieved. Likewise, we have constructed a key building block for accessing agouti-related protein (AGRP) active loop analogues in a concise manner.

An efficient method for peptide late-stage C(sp³)-H arylations assisted by unmodified side chain of asparagine (Asn) without any exogenous directing group has been reported.     

新型吡唑联吡咯类杂环化合物的合成及杀菌活性

为寻找具有更高生物活性、更环保的新农药杀菌剂,基于杀菌剂氟咯菌腈设计并合成了10个新型吡唑联吡咯类杂环化合物,以吡唑环代替氟咯菌腈上原有的苯环,以期提高其杀菌活性.采用1H NMR,FTIR,单晶X射线衍射、元素分析和熔点测定等测试手段对目标化合物及其中间体的结构进行了表征与确认,并通过挥发法培养得到了6个目标化合物的单晶.还对其中6个化合物进行了生物活性测试,测试结果表明各化合物对水稻纹枯病、黄瓜灰霉病、黄瓜霜霉病均表现出一定的抑菌效果,可作为先导化合物对其结构进行深入的研究,为新农药杀菌剂的开发提供了理论支持.     

散裂靶中质子束窗的散射效应

 质子束窗是在高功率靶区中的一个分界窗,它将质子输运线上高真空区域和氦容器中的氦环境分开。在其他散裂中子源中质子束窗的热效应以及机械问题都已经被研究过了,但质子束在该窗中散射效应的研究却很少被报导,然而在靶设计中如果没有处理好质子束窗的散射效应会有很大的问题。报导了质子束窗散射效应的模拟计算结果,包括不同质子束窗的材料和结构选择,并以中国散裂中子源（CSNS）为例,介绍了在CSNS一期和二期中质子束窗采用周边水冷的铝合金单层结构,CSNS三期采用中间水冷的铝合金夹层结构。文中给出了不同结构的质子束窗和不同的与靶距离散射效应对靶上经非线性磁铁均匀化的束流分布的影响的模拟计算结果。模拟结果显示质子窗的散射效应对束流损失和靶上的束流分布有重要的影响。     

薄壁柱壳的圆度及三维变形测量技术

本文采用一种新的形状位置（Ｐｒｏｆｉｌｉｍｅｔｒｙ）自动测量计算机处理方法,对钢质圆柱壳的椭圆度进行了测试。具体使用投影光栅,于壳体表现形成栅线影象,自动形成栅线光频率线性编码,用ＣＣＤ摄象机采集到频率编码壳体光栅影象,构成形西半球工波图。将载波的图象经过计算机图象系统获得数值图象。计算机经过快速富立叶变换法解码,输出频率位相值,经数据处理可得到精确的壳面尺度。     

Quantitative analysis by comprehensive two-dimensional gas chromatography using interval Multi-way Partial Least Squares calibration

A new approach for target quantitative analysis for comprehensive two-dimensional gas chromatography (GC × GC), interval Multi-way Partial Least Square (iNPLS) is presented and evaluated in this paper. In iNPLS, the two-dimensional chromatogram is split in small sections; each of these pieces is treated as an independent new chromatogram. Separated conventional NPLS calibration models for the concentration of the target analyte are built for each of the pieces of the whole chromatogram, and the best model is selected for quantitative analysis. An algorithm for iNPLS running on MatLab platform was written, preliminarily evaluated with using solutions of model compounds with different chemical properties and subsequently applied to quantify some allergens in perfume samples. The results were found to be adequate, and good precision and accuracy was obtained even for poorly resolved peaks.     

Identification of volatiles from pineapple (Ananas comosus L.) pulp by comprehensive two-dimensional gas chromatography and gas chromatography/mass spectrometry

Combining qualitative data from the chromatographic structure of 2-D gas chromatography with flame ionization detection (GC×GC-FID) and that from gas chromatography-mass spectrometry (GC/MS) should result in a more accurate assignment of the peak identities than the simple analysis by GC/MS, where coelution of analytes is unavoidable in highly complex samples (rendering spectra unsuitable for qualitative purposes) or for compounds in very low concentrations. Using data from GC×GC-FID combined with GC/MS can reveal coelutions that were not detected by mass spectra deconvolution software. In addition, some compounds can be identified according to the structure of the GC×GC-FID chromatogram. In this article, the volatile fractions of fresh and dehydrated pineapple pulp were evaluated. The extraction of the volatiles was performed by dynamic headspace extraction coupled to solid-phase microextraction (DHS-SPME), a technique appropriate for slurries or solid matrices. Extracted analytes were then analyzed by GC×GC-FID and GC/MS. The results obtained using both techniques were combined to improve compound identifications.     

Chemical immobilization of crosslinked polymeric ionic liquids on nitinol wires produces highly robust sorbent coatings for solid-phase microextraction

Super elastic nitinol (NiTi) wires were exploited as highly robust supports for three distinct crosslinked polymeric ionic liquid (PIL)-based coatings in solid-phase microextraction (SPME). The oxidation of NiTi wires in a boiling (30% w/w) H₂O₂ solution and subsequent derivatization in vinyltrimethoxysilane (VTMS) allowed for vinyl moieties to be appended to the surface of the support. UV-initiated on-fiber copolymerization of the vinyl-substituted NiTi support with monocationic ionic liquid (IL) monomers and dicationic IL crosslinkers produced a crosslinked PIL-based network that was covalently attached to the NiTi wire. This alteration alleviated receding of the coating from the support, which was observed for an analogous crosslinked PIL applied on unmodified NiTi wires. A series of demanding extraction conditions, including extreme pH, pre-exposure to pure organic solvents, and high temperatures, were applied to investigate the versatility and robustness of the fibers. Acceptable precision of the model analytes was obtained for all fibers under these conditions. Method validation by examining the relative recovery of a homologous group of phthalate esters (PAEs) was performed in drip-brewed coffee (maintained at 60 °C) by direct immersion SPME. Acceptable recoveries were obtained for most PAEs in the part-per-billion level, even in this exceedingly harsh and complex matrix.