Structural assignment of organotin hydrides containing the oxazoline ligand

A series of triorganotin hydrides and diorganotin dihydrides containing the optically active 2-(4-isopropyl-2-oxazolinyl)-5-phenyl ligand have been characterized by means of the multinuclear low-temperature NMR investigations, the results of which are discussed. In the corresponding organotin hydrides values of the ¹J(¹H-^117/119Sn) couplings appeared to be temperature dependent, supporting an axial/equatorial position of the hydrogen attached to the tin.     

Characterisation of anodic oxide films on zirconium formed in sulphuric acid: XPS and corrosion resistance investigations

Present work describes investigations of a two-step process consisting of galvanostatic anodising in a 1 M H₂SO₄ solution at 100 mA cm⁻² up to the limiting voltages of 20, 60, 80, 100 and 120 V, directly after which potentiostatic regime was employed and the current was allowed to drop. The total treatment time (5 min) was held constant for all samples. The treatment was carried out to improve the corrosion resistance of zirconium in physiological conditions, which was determined by electrochemical evaluation in Ringer’s solution. XPS studies revealed that after anodising sulphur was incorporated into the oxide film in the form of sulphated zirconia. The maximum content of sulphate in the oxide layer was observed after anodising at 80 V. Anodising at higher voltages resulted in formation of coatings with decreasing amount of sulphur. It was found that there is a strong correlation between the sulphur content in the oxide layers and the measured corrosion current density. On the other hand, the pitting corrosion resistance seemed to be unaffected by the presence of S and it was improving with the increasing limiting voltage of the treatment.

     

The phase envelopes of alternative solvents (ionic liquid,CO2) and building blocks of biomass origin (lactic acid,propionic acid)

Solid–liquid, liquid–liquid and vapour–liquid equilibrium measurements for binary and ternary systems containing building blocks of biomass origin such as propionic acid, lactic acid and alternative solvents like carbon dioxide and 1-ethyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide ionic liquid have been carried out at 313.15 K. The binary solid–liquid and liquid–liquid equilibrium measurements were performed at ambient pressure. The vapour–liquid equilibrium was studied in the range of pressure from 3.54 to 12 MPa while ternary systems were examined at 9, 10 and 12 MPa. The samples from the coexisting phases were taken and the compositions of both liquid and vapour phases were determined experimentally. The three-phase system was observed for lactic acid + ionic liquid + CO₂ as well. The achieved results were correlated using the Peng–Robinson equation of state with the Mathias–Klotz–Prausnitz mixing rule. The set of interaction parameters for the employed equations of state and the mixing rule for the investigated systems were obtained.     

Isothermal vapour–liquid equilibria in the binary and ternary systems consisting of an ionic liquid, 1-propanol and CO2

Vapour–liquid equilibrium measurements for binary and ternary systems containing carbon dioxide, 1-propanol, and 1-ethyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide or 1-decyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide or 1-ethyl-3-methylimidazolium trifluoromethanesulfonate ionic liquids are presented in this work. The binary CO₂ + 1-decyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide system at 313.15 K at pressure range from 2 to 14.4 MPa was examined. The obtained phase envelop shows that even at low pressure of CO₂ the solubility of the gas in the ionic liquid is high. The ternary phase equilibria were studied at 313.15 K and pressures in the range from 9 to 12 MPa. The ternary phase diagrams show that higher CO₂ pressure diminishes the miscibility gap.     

Volumetric Properties of the {x 1[C4mim][MeSO4] + (1 − x 1)MeOH} System at Temperatures from (283.15 to 333.15) K and Pressures from (0.1 to 35) MPa

Densities of pure 1-butyl-3-methylimidazolium methylsulfate, [C₄mim][MeSO₄], and its mixtures with methanol have been measured. Measurements were made with an accuracy of ±0.2 kg·m^?3, using a vibrating-tube densimeter, over the temperature and pressure ranges (283.15–333.15) K and (0.1–35) MPa, respectively. The experimental densities for the pure ionic liquid and alcohol have been correlated by the Tait equation. The results for the {x ₁[C₄mim][MeSO₄] + (1 ? x ₁)MeOH} system have been correlated by a van Laar equation involving parameters that are dependent on temperature and pressure. Excess volumes have been obtained directly from the experimental densities, while isobaric expansivities, isothermal compressibilities, and related excess properties were calculated from the correlation equation. Exceptionally strong pressure and temperature influences on these properties were observed.