Synthesis,Structures, and Properties of Highly Strained Cyclophenylene–Ethynylenes with Axial and Helical Chirality

Single and double cyclophenylene–ethynylenes (CPEs) with axial and helical chirality have been synthesized by the Sonogashira cross-coupling of di- and tetraethynyl biphenyls with a U-shaped prearomatic diiodoparaphenylene followed by reductive aromatization. X-ray crystallographic analyses and DFT calculations revealed that the CPEs possess highly twisted bent structures. Bend angles on the edge of the paraphenylene units were close to the value of [5]cycloparaphenylene (CPP)—the smallest CPP to date. The double and single CPEs possessed stable chirality despite flexible biphenyl structures because of the high strain in the diethynyl–paraphenylene moiety. In both the single and double CPEs, orbital interactions along the biphenyl axis were observed by DFT calculations in LUMO and LUMO+2 of the single CPE and LUMO+1 of the double CPE, which likely cause lowering of these orbital energies. Concerning chiroptical properties: boosting of the g_abs value was observed in the biphenyl-based double CPE, as well as the binaphthyl-based single CPE, compared to the biphenyl-based single CPE.     

砂岩方梁断裂过程区范围的实验确定方法

裂纹前端的断裂过程区是引起岩石非线性断裂及尺寸效应的主要原因。利用数字图像相关技术对砂岩开展了三点弯曲梁实验,获得观测区域高精度的全场位移和应变数据,根据断裂韧带区域水平位移和水平应变的分布特征,结合裂尖岩石颗粒变化的微观分析,提出采用裂纹尖端水平位移波动性和水平应变突变性所得到的波动系数和水平应变突变值,确定断裂过程区形状和临界尺寸的方法。结果表明:砂岩断裂过程区的形状为不规则的狭长带状区域,断裂过程区的临界长度为11~13mm,临界宽度为1.58~2.36mm。断裂过程区区域内形变在趋向裂尖时呈指数增加,但其单位区域内的形变增量呈波动状态。该方法能够更加准确判断岩石断裂过程区的范围,有助于分析岩石的非线性断裂特性。     

压气机悬臂静叶流场非定常数值模拟

以现代高压压气机一排悬臂静叶与一排转叶组成的典型级为研究对象,采用非定常数值模拟方法,分析了非定常与定常数值模拟计算得出的级特性线以及峰值效率点气动参数在展向分布的差异,并对悬臂静叶内部流场结构进行了详细分析,结果表明:当悬臂静叶的轮毂设计间隙为2.5%叶高时,非定常计算的综合喘振裕度比定常大5.85%;在峰值效率点工况下,悬臂静叶总压损失和转子效率的非定常影响范围在10%以内,转叶进口相对气流角沿展向分布的影响在0.5°以内。悬臂静叶根部10%叶高以下区域出现了明显的泄漏流动,3.4%叶高压力系数变化最大,轮毂泄漏流起始于20%弦长附近,发展到70%弦长位置时泄漏损失最大,随后逐渐减弱.     

Experimental and Numerical Investigation on Effects of the Steam Ingestion on the Aerodynamic Stability of an Axial Compressor

In order to investigate the influence of steam ingestion on the aerodynamic stability of a two-stage low-speed axial-flow compressor, multiphase flow numerical simulation and experiment were carried out. The total pressure ratio and stall margin of the compressor was decreased under steam ingestion. When the compressor worked at 40% and 53% of the nominal speed, the stall margin decreased, respectively, by 1.5% and 6.3%. The ingested steam reduced the inlet Mach number and increased the thickness of the boundary layer on the suction surface of the blade. The low-speed region around the trailing edge of the blade was increased, and the flow separation region of the boundary layer on the suction surface of the blade was expanded; thus, the compressor was more likely to enter the stall state. The higher the rotational speed, the more significant the negative influence of steam ingestion on the compressor stall margin. The entropy and temperature of air were increased by steam. The heat transfer between steam and air was continuous in compressor passages. The entropy of the air in the later stage was higher than that in the first stage; consequently, the flow loss in the second stage was more serious. Under the combined action of steam ingestion and counter-rotating bulk swirl distortion, the compressor stability margin loss was more obvious. When the rotor speed was 40% and 53% of the nominal speed, the stall margin decreased by 6.3% and 12.64%, respectively.     

用标准件对梯度磁场定标

就标准厚度卡片在霍尔传感器的定标方面的应用作了有益的探讨。在纵向测量微小长度时,霍尔片处于磁场边缘位置,其对磁场的梯度更大,即灵敏度更高,且靠中心位置的线性更好。     

Two-dimensional optical coherence tomography for real-time structural dynamical characterization

We present a two-dimensional optical coherence vibration tomography (2DOCVT) system with an ultra-precision displacement resolution of ~0.1 nm that is capable of in site real-time absolute displacement measurement of structural line vibrations. Experimental results of sinusoidal, sweep and impulse vibrations were reported. The key figures of merit such as the 2DOCVT system could obtain fast line vibration measurement without scanning and it also could be used to capture structural modal parameters in one single impulse excitation measurement without any vibration excitation input information, making it attractive for the application in low-frequency vibration measurement and response-only modal analysis.     

Control of Axial Chirality by Planar Chirality Based on Optically Active [2.2]Paracyclophane

Optically active X-shaped molecules based on the planar chiral [2.2]paracyclophane building block were prepared, in which di(methoxy)terphenyl units were stacked on the central benzene rings. At 25 °C, anisolyl rings freely rotate in solution, while in the crystal form, they are fixed by intramolecular CH–π interactions, thereby leading to the expression of the axial chirality, i.e., propeller chirality was exhibited by the planar chiral [2.2]paracyclophane moiety. The X-shaped molecule exhibited good circularly polarized luminescence (CPL) profiles with moderate Φ_PL and a large g_lum value in the order of 10⁻³ at 25 °C, in solution. In contrast, at −120 °C, dual CPL emission with opposite signs was observed. According to the theoretical studies, the rotary motion of the anisolyl units is suppressed in the excited states, and so emission from two isomers could be observed. These results demonstrate that the axial chirality was controlled by the planar chirality, leading ultimately to propeller chirality.     

简支及悬臂箱梁在角隅轴向荷载作用下的翼板纵向应力

基于能量变分原理，拟定轴向荷载作用下箱梁的纵向位移函数，得到关于翼板剪切变形引起的位移差函数的基本微分方程，继而推导出箱梁翼板纵向应力表达式，并首次得出角隅轴向荷载作用下翼板出现应力不均匀分布的荷载及边界条件。通过对一模型箱梁进行计算，并与通用有限元软件ANSYS壳单元计算结果进行比较，验证了该方法和所推导公式的正确性。研究结果表明，当作用于简支箱梁截面角隅处的轴向荷载（合力无偏心）为集中或分布荷载时，翼板不产生纵向应力不均匀现象；当作用于悬臂箱梁截面角隅处的轴向荷载（合力无偏心）为集中荷载时，翼板不产生纵向应力不均匀现象，而当荷载轴向分布时，翼板将产生纵向应力不均匀现象。实际工程中，横力弯曲使悬臂箱梁产生剪力滞效应，这种效应会与轴向分布荷载产生的效应叠加，设计时对此应予以充分考虑。     

Three-dimensional interfacial fracture analysis of a one-dimensional hexagonal quasicrystal coating

In this paper, the three-dimensional (3D) interfacial fracture is analyzed in a one-dimensional (1D) hexagonal quasicrystal (QC) coating structure under mechanical loading. A planar interface crack with arbitrary shape is studied by a displacement discontinuity method. Fundamental solutions of interfacial concentrated displacement discontinuities are obtained by the Hankel transform technique, and the corresponding boundary integral-differential equations are constructed with the superposition principle. Green’s functions of constant interfacial displacement discontinuities within a rectangular element are derived, and a boundary element method is proposed for numerical simulation. The singularity of stresses near the crack front is investigated, and the stress intensity factors (SIFs) as well as energy release rates (ERRs) are determined. Finally, relevant influencing factors on the fracture behavior are discussed.     

Assessing G4-Binding Ligands In Vitro and in Cellulo Using Dimeric Carbocyanine Dye Displacement Assay

G-quadruplexes (G4) are the most actively studied non-canonical secondary structures formed by contiguous repeats of guanines in DNA or RNA strands. Small molecule mediated targeting of G-quadruplexes has emerged as an attractive tool for visualization and stabilization of these structures inside the cell. Limited number of DNA and RNA G4-selective assays have been reported for primary ligand screening. A combination of fluorescence spectroscopy, AFM, CD, PAGE, and confocal microscopy have been used to assess a dimeric carbocyanine dye B6,5 for screening G4-binding ligands in vitro and in cellulo. The dye B6,5 interacts with physiologically relevant DNA and RNA G4 structures, resulting in fluorescence enhancement of the molecule as an in vitro readout for G4 selectivity. Interaction of the dye with G4 is accompanied by quadruplex stabilization that extends its use in primary screening of G4 specific ligands. The molecule is cell permeable and enables visualization of quadruplex dominated cellular regions of nucleoli using confocal microscopy. The dye is displaced by quarfloxin in live cells. The dye B6,5 shows remarkable duplex to quadruplex selectivity in vitro along with ligand-like stabilization of DNA G4 structures. Cell permeability and response to RNA G4 structures project the dye with interesting theranostic potential. Our results validate that B6,5 can serve the dual purpose of visualization of DNA and RNA G4 structures and screening of G4 specific ligands, and adds to the limited number of probes with such potential.