Elongating the area of plasma/fluid interaction of surface nanosecond pulsed discharges

Plasma-assisted flow control is of high industrial interest, but practical applications at full scale require a large surface of interaction. Nanosecond pulsed Dielectric Barrier Discharge (DBD) have demonstrated promising results of flow control, but their interacting region is limited to only a few cm². In this paper, the conditions to extend a surface nanosecond DBD are documented. It is shown that a sliding discharge regime can fully fill an inter-electrode distance of 40 mm. This discharge regime promotes the formation of two hemispheric pressure waves originating from both air-exposed electrodes while an horizontal region of pressure gradient is also observed.     

VRPTW的扰动恢复及其TABU SEARCH算法

本文对带时间窗的车辆路线安排扰动恢复问题进行了讨论,分析了各种可能的扰动:增加减少客户,时间窗、客户需求及路线可行性的扰动,构造了扰动模型.利用禁忌搜索算法对问题进行求解,同时通过对模型参数重新设置,得到了多个满足要求的不同的解,这样使解更具有实际可行性和有效性.     

托卡马克工程试验混合堆等离子体性能的等值线图分析

本文简要叙述托卡马克工程试验混合堆等离子体概念设计的物理基础,对等离子体性能进行了等值线图(Plasma Operation Contour)分析。根据工程试验混合堆的要求,得出一组等离子体参数。     

Magnetic properties of oxygenated carbon nitride films from RF-discharge in an acetylene, nitrogen, and oxygen mixture environments

Properties of oxygenated carbon nitride films have attracted the attention of physics researchers due to their magnetic and physical properties, as well as for their usefulness in the industry. The free radicals were investigated using electron paramagnetic resonance applied in the study of spin concentration due to the different mechanism of preparation of carbon nitride films by RF-discharge with different kinds of plasma. Unpaired spin concentrations, in the order of 10²⁰ per cm³, were measured and their time recombination dependency was important in those films. The films were grown by plasma enhanced chemical vapor deposition using mixtures of hydrocarbons, N₂ and O₂ in different proportions.     

一种新的WDM光网中的共享链路保护策略

研究了WDM光网中的链路保护问题.提出了一种新的共享链路保护策略--基于SRLG的共享链路保护策略(SRLG-SLP).SRLG(共享风险链路组)定义了对一条工作光通道分配保护资源时的资源可用性的约束.它规定任意两条有着同样故障风险或者说处于同一个SRLG的工作光通道不能利用同样的保护资源.另外,还提出了一种更加符合实际的单链路故障模型,其中链路故障间隔时间和链路故障保持时间被考虑作为两个独立的变量.基于该链路故障模型,通过大量的仿真试验,比较了专用链路保护(DLP)、共享链路保护(SLP)和提出的SRLG-SLP保护策略的资源利用率、保护效率以及业务中断率.结果显示,我们提出的SRLG-SLP在保护效率和业务中断率方面的保护性能远好于DLP和SLP,但会牺牲一些资源利用率.     

A generalized quasi-sum relations for oscillator strengths in transition arrays: theoretical study of the opacity of Ge plasmas

We present a simplified relativistic configuration interaction method (SRCI), by which all the energy levels and oscillator strengths in each transition array can be calculated. There exist generalized quasi-sum relations for the calculated oscillator strengths in the relevant transition arrays by the SRCI and by an unresolved transition array model (UTA). Based on UTA and the detailed configuration accounting (DCA), with a fully relativistic treatment incorporated with the quantum defect theory, the X-ray absorption spectra for any middle- and high-Z plasmas or composite plasmas can be calculated with much less computational efforts. The gross features of calculated spectra by DCA-UTA are in agreement with the relevant experimental measurements, except some detailed structures in some narrow spectral ranges. Such detailed structures can be calculated by SRCI incorporated with DCA-UTA. As an illustrative example, the absorption spectra of Ge plasmas are calculated by DCA-UTA-SRCI and are in agreement with the experimental opacity data. Therefore, the theoretical method (DCA-UTA-SRCI) verified by experimental measurements will not only be a basic tool to provide “precision” opacity data for the inertial confinement fusion research (ICF) and studies in stellar physics but also can be used to analyze the relevant diagnostic measurements for ICF plasmas.     

采用空心阴极放电等离子体化学气相沉积方法制备a-CH薄膜

 研究了不同衬底-阴极距离、直流电压和H₂流量对a-CH薄膜沉积速率的影响。结果表明：衬底-阴极距离必须大于0.5cm，随着该距离的增加，薄膜的沉积速率减少；直流电压达550V时沉积速率最大；随着H2含量的增加，CH₄含量相对减少，沉积速率随之降低。用AFM观察了以该方法制得的448.4nm CH薄膜的表面形貌，表面粗糙度约为10nm。最后测出了不同条件下CH薄膜的UV-VIS谱，由此可以计算得到薄膜的禁带宽度及折射率。     

HL-1M边缘等离子体静电湍流扰动

对HL－1M边缘等离子体静电湍流扰动进行了初步的实验研究。获得了扰动的基本特征量，估计了低杂波引起的径向粒子流的变化。在加低杂波（2．45GHz)前、后，电子密度扰动和极向电场扰动的幅度及其关联性变化不大。虽然低杂波部分抑制了静电湍流，但在数量上不能解释粒子约束改善的实验结果。     

Ion implantation induced by Cu ablation at high laser fluence

High energy laser plasma-produced Cu ions have been implanted in silicon substrates placed at different distances and angles with respect to the normal to the surface of the ablated target. The implanted samples have been produced using the iodine high power Prague Asterix Laser System (PALS) using 438 nm wavelength irradiating in vacuum a Cu target. The high laser pulse energy (up to 230 J) and the short pulse duration (400 ps) produced a non-equilibrium plasma expanding mainly along the normal to the Cu target surface. Time-of-flight (TOF) technique was employed, through an electrostatic ion energy analyzer (IEA) placed along the target normal, in order to measure the ion energy, the ion charge state, the energy distribution and the charge state distribution. Ions had a Boltzmann energy distributions with an energy increasing with the charge state. At a laser fluence of the order of 6 × 10⁶ J/cm², the maximum ion energy was about 600 keV and the maximum charge state was about 27+.In order to investigate the implantation processes, Cu depth profiles have been performed with Rutherford backscattering spectrometry (RBS) of 1.5 MeV helium ions, Auger electron spectroscopy (AES) with 3 keV electron beam and 1 keV Ar sputtering ions in combination with scanning electron microscopy (SEM). Surface analysis results indicate that Cu ions are implanted within the first surface layers and that the ion penetration ranges are in agreement with the ion energy measured with IEA analysis.     

Mössbauer and X-ray diffraction characterization of Fe60Al40 coatings prepared by thermal spraying

Microstructured (atomized) and nanostructured (milled) Fe₆₀Al₄₀ powders together with their corresponding coatings synthesized by High Velocity Oxy-fuel (HVOF) or Atmospheric Plasma Spray (APS) thermal spraying techniques have been characterized by Mössbauer Spectroscopy (MS) and X-ray Diffraction (XRD). The evolution of the microstructure and the atomic ordering degree in the powders and coatings are discussed at the light of the various processing conditions. The operational correlation between the parameters of the duplex morphology of coatings and the processing parameters is discussed.