射频等离子制备石墨烯负载Co3O4催化剂及其析氧性能研究

氢能的引入能有效提升配电网的供电可靠性,而电解水制氢是实现低碳转型的关键技术,开发高效的电解水催化剂势在必行。过渡金属氧化物储量大、催化活性高,是具有广阔应用前景的析氧反应催化剂。本文通过射频等离子体处理制备石墨烯上负载Co₃O₄析氧催化剂,XRD、Raman和XPS测试结果显示,二维结构石墨烯的引入加速表面电子迁移,增大了反应面积。等离子体处理促进了纳米粒子在石墨烯上的负载,利用等离子体刻蚀作用在催化剂表面制造出大量碳结构缺陷和氧空位结构,改善了活性位点分布,有效调控Co₃O₄电子结构,提高析氧催化活性。电化学测试表明,本文中合成的Co₃O₄@rGO在电流密度为50 mA·cm^-2时的过电位为410 mV,动力学反应速率较快,表现出优于商业IrO₂的析氧催化活性。     

自掺杂SnO2微球的水热合成及其可见光催化性能

本研究采用水热法,以柠檬酸为螯合剂,通过控制n(Sn⁴⁺)/n(Sn²⁺)的数值,合成了由具有丰富氧空位的SnO₂纳米晶体组装成的微球。通过X射线衍射(XRD)、扫描电子显微镜(SEM)、透射电子显微镜(TEM)、傅里叶红外光谱(FT-IR)、X射线光电子能谱(XPS)及UV-Vis漫反射光谱对SnO₂纳米微球进行表征分析,结果表明:在酸性水热条件和柠檬酸的螯合作用下,二氧化锡纳米晶体聚集形成微球;在Sn⁴⁺/Sn²⁺摩尔比例为3:7时,其微球尺寸最小,整体分散性较好;同时适量二价锡离子的掺杂使得该样品氧空位浓度达到最佳,氧空位的存在将使得样品光吸收范围拓展至可见光,因而该样品显示出较强的可见光催化效率,在8 min内完全降解甲基橙。     

Transition probabilities of the X1Σ+, A1Π, B1Δ, C1Σ+, and D1Π states of the AlO+ cation

ABSTRACT

This study computes the potential energy curves of the X¹Σ⁺, A¹Π, B¹Δ, C¹Σ⁺, and D¹Π states of AlO⁺ cation and the transition dipole moments between them. The orders of the rotationless radiative lifetimes are 10–100?μs for the A¹Π state, 1–1000?ms for the B¹Δ state, 10?ns for the first well and 100?ns for the second well of the C¹Σ⁺ state, and 1?μs for the D¹Π state. Emissions of the B¹Δ–A¹Π and D¹Π–C¹Σ⁺ systems are so weak that they are hardly measured via spectroscopy, the emissions of the C¹Σ⁺–X¹Σ⁺, C¹Σ⁺–A¹Π, and D¹Π–X¹Σ⁺ systems are so strong that they can be detected readily, and emissions of the A¹Π–X¹Σ⁺ and D¹Π–A¹Π systems can be observed through spectroscopy only by a significant effort. There is a strong great similarity between spontaneous emissions of the A¹Π–X¹Σ⁺ system of the AlO⁺ cation and the A²Π–X²Σ⁺ system of the AlO radical. The emissions of the A²Π–X²Σ⁺ system of the AlO radical have been measured in outer space Therefore, it is highly possible that the emissions of the A¹Π–X¹Σ⁺ system of the AlO⁺ cation can be detected in the astrophysical media.     

Comparison of the stability of thymine tautomers and the interaction of its tautomers with Na+, K+, Mg2+ and Ca2+ in gas and solvent phases

The present study compared the interactions among Na ⁺, K ⁺, Mg²⁺ and Ca²⁺, thymine and its tautomers in the gas and solvent phase, an interaction dependent upon the electronic construction of the tautomers. Three types of cation interaction with thymine and its tautomers were observed. In the first one, the metal cations interacted with a lone pair of nitrogen or oxygen of the tautomers. In the second type, there was an interaction among the cations, nitrogen and oxygen at the same time; the last one was that of cations with the electron density of thymine π-system, where the cations were perpendicular to the ring of thymine. The interaction of metals cation with tautomers was studied in the gas and solvent phases; a comparison was then made between interactions in two phases. The interaction energy for all complexes indicated the stability of complexes, an energy which was higher in Ca²⁺ and Mg²⁺ compared with Na⁺ and K⁺. Concerning K⁺ and Na⁺, the stability of all complexes of tautomers was greater than that of thymine complexes; however, the stability of certain Ca²⁺ and Mg²⁺ complexes was lower than the complexes of thymine.     

Assessment of the nature of interactions of cations with cycloheptatriene derivatives using change in the aromaticity: Comparison with electron density and NBO results

ABSTRACT

Interactions of cycloheptatriene derivatives, C₇H₆X, (X?=?NH, PH, AsH, O, S, Se) with the cations H⁺, CH₃⁺, Cu⁺, Al⁺, Li⁺, Na⁺, and K⁺ are studied using B3LYP functional and 6-311++G(d,p) basis set. The calculated gas-phase cation affinities (CA) and cation basicities (CB) for all molecules decrease as H⁺ > CH₃⁺ > Cu⁺ > Al⁺ > Li⁺ > Na⁺ > K⁺. We used the induced aromaticity in the 7-membered ring of C₇H₆X upon interaction with the cations, M⁺, as a measure of C₇H₆X/M⁺ interaction. Nucleus-independent chemical shift (NICS) and harmonic oscillator model of aromaticity (HOMA) were used as two indices of aromaticity. The highest and lowest induced aromaticities were observed for interactions of H⁺ and K⁺, respectively. Also, the aromaticity induced by interaction with a cation in C₇H₆AsH and C₇H₆PH was larger than that in C₇H₆NH and C₇H₆O. Hence, the aromaticity was considered as a measure of covalency for the C₇H₆X/M⁺ interactions showing a rational dependence on both the molecule and cation. The nature of the interactions was also assessed using electron density, charge distribution analysis and NBO calculations. The results of the aromaticity indices, NICS and HOMA, were compared with the electron density and NBO results.     

Implementing a Two-Photon Three-Degrees-of-Freedom Hyper-Parallel Controlled Phase Flip Gate Through Cavity-Assisted Interactions

Hyper-parallel quantum information processing is a promising and beneficial research field. Herein, a method to implement a hyper-parallel controlled-phase-flip (hyper-CPF) gate for frequency-, spatial-, and time-bin-encoded qubits by coupling flying photons to trapped nitrogen vacancy (NV) defect centers is presented. The scheme, which differs from their conventional parallel counterparts, is specifically advantageous in decreasing against the dissipate noise, increasing the quantum channel capacity, and reducing the quantum resource overhead. The gate qubits with frequency, spatial, and time-bin degrees of freedom (DOF) are immune to quantum decoherence in optical fibers, whereas the polarization photons are easily disturbed by the ambient noise.     

Optimization of anionic conductivity through the coexistence of ionomer cluster and backbone-backbone morphologies in anion exchange membranes

Random copolymers of poly(4-vinylpyridine) and polyisoprene were synthesized, and subsequently quaternized with 1-alkylbromides. The number of carbons on the pendant side-chain of the resultant comb-shaped polymer, n, ranged from 2–8. The comb-shaped polymers were crosslinked employing thiol-ene chemistry to give mechanically robust ion conducting membranes. Analysis by wide and medium-angle X-ray scattering show three morphology regimes that are dependent on the number of carbons on the pendant side-chains. When n = 2, ionomer cluster morphology was dominant, when n = 8 backbone-backbone morphology was dominant, and when n = 3–6, the membrane showed a coexistence of both ionomer cluster and backbone-backbone morphologies. Evaluation of the water uptake of the membranes showed a maximum water uptake per cation of 9.5 when n = 5 at 95% relative humidity (RH) and 60°C. Conductivity of the samples characterized by electrochemical impedance spectroscopy showed bromide conductivity as high as 110 mS/cm when n = 3 at 95% RH and 90°C.     

第三族金属氧化物离子对二氧化碳转化的红外光谱研究

本文利用红外光解离光谱研究了第三族金属氧化物离子对二氧化碳分子的转化机制. 研究表明，对于[ScO(CO₂)_n]⁺体系，在n≤4时，形成了溶剂化结构；在n=5时，形成了碳酸盐结构，实现了二氧化碳的转化. 对于[YO(CO₂)_n]⁺体系，需要4个二氧化碳分子就可以实现二氧化碳的转化. 而在[YO(CO₂)_n]⁺体系中，只发现了溶剂化结构，没有观察到碳酸盐结构. 理论计算表明，[YO(CO₂)_n]⁺体系拥有最小的溶剂化结构向碳酸盐结构转化能垒，[LaO(CO₂)_n]⁺体系拥有最大的溶剂化结构向碳酸盐结构转化能垒. 本文从分子水平揭示了不同金属氧化物离子对二氧化碳分子转化的影响规律.     

Interpretation of the Role of Composition on the Inclusion Efficiency of Monovalent Cations into Cobalt Hexacyanoferrate

Cobalt hexacyanoferrate of various compositions was prepared in flow mode and the role of the vacancy on the structure, thermogravimetric (TG) properties, and the adsorption efficiency was studied. The material, Na_yCo[Fe(CN)₆]_1−x ⋅ z H₂O, with a minimum vacancy of x=0.014 to the highest x=0.47, was obtained. The TG-differential scanning calorimetry (DSC) profile showed a distinct influence of the vacancy on the water release temperature. Materials with x>0.35 showed a smooth release of water at a relatively lower temperature. However, for the materials with x<0.35, water release took place in multiple steps, suggesting the existence of various forms of water. The FTIR profiles supported the existence of free and bonded water molecules. However, the materials with multiple water peaks in the FTIR spectra showed a shift of the major XRD peaks when heated at 285 °C in N₂ atmosphere. Regarding the effect of the vacancy on the adsorption behavior, for NH₄, the adsorption was found to be proportional to the number of Na atoms in the material, confirming the ion-exchange process. On the contrary, the materials with low vacancy and high Na content showed nominal Cs adsorption capacity. Interestingly, the K adsorption capacity was found to be in between that of the other two ions. This means the ionic size decides the rate of placement into the interstitial sites. For larger ions like Cs, the ease of percolation via the vacancy decides the overall adsorption efficiency.