N-Protection of amines using pyridinium 2, 2, 2-trifluoroacetate ionic liquid as an efficient and reusable catalyst

A simple, green, and efficient method for the N-tert-butoxycarbonylation of amines by pyridinium 2,2,2- trifluoroacetate （[Py][OTf]） as an efficient and reusable catalyst is reported. In general, electron donating groups on aryl group give rise to the higher yields than electron withdrawing groups. Clean reaction, short reaction times, high yields, reusability of catalyst, and easy preparation of it are some advantages of this work.     

Coking-resistant Ni-ZrO2/A1203 catalyst for CO methanation

Highly coke-resisting ZrO2-decorated Ni/A1203 catalysts for CO methanation were prepared by a two-step process. The support was first loaded with NiO by impregnating method and then modified with ZrO2 by deposition-precipitation method （IM-DP）. Nitrogen adsorption- desorption, X-ray diffraction, scanning electron microscopy, transmission electron microscopy, thermogravimetdc analysis, H2 temperature- programmed reduction and desorption, NH3 temperature-programmed desorption, and zeta potential analysis were employed to characterize the samples. The results revealed that, compared with the catalysts with the same composition prepared by co-impregnation （CI） and sequential impregnation （SI） methods, the Ni/A1203 catalyst prepared by IM-DP showed much enhanced catalytic performance for syngas methanation under the condition of atmospheric pressure and a high weight hourly space velocity of 120000 mL.g-1 .h-1. In a 80 h life time test under the condition of 300-600 ~C and 3.0 MPa, this catalyst showed high stability and resistance to coking, and the amount of deposited carbon was only 0.4 wt%. On the contrary, the deposited carbon over the catalyst without ZrO2 reached 1.5 wt% after a 60 h life time test. The improved catalytic performance was attributed to the selective deposition of ZrO2 nanoparticles on the surface of NiO rather than A1203, which could he well controlled via changing the electrostatic interaction in the DP procedure. This unique structure could enhance the dissociation of CO2 and generate surface oxygen intermediates, thus preventing carbon deposition on the Ni particles in syngas methanation.     

4-单取代-1,2,3-三氮唑的合成进展(Ⅱ)—通过去取代基反应

1,2,3-三氮唑衍生物是近些年研究热点化合物之一,随着4-单取代型衍生物在医药、农药、材料等领域的广泛应用,该类化合物的合成及应用近些年引起了广大研究者的关注并获得了可喜进展。本文阐述了4-单取代-1,2,3-三氮唑衍生物的合成发展历史,着重综述了近十年来该类唑衍生物的合成发展情况。内容主要涵盖二取代-1,2,3-三氮唑的去取代基反应,包括脱羧、脱苄基、脱羟(酰氧)基及脱取代乙基等反应。文章还包括一些合成方法及其产物的应用,并对一些重要的反应机理做了分析。文章最后对该类化合物的合成做了总结并展望了未来发展方向。     

厌氧-曝气生物滤池处理水杨酸废水的研究

采用厌氧-曝气生物滤池(AF-BAF)工艺处理工业水杨酸废水,研究了不同进水ρ[COD(NaAc)]/ρ[COD(SA)]比值[表示乙酸钠与水杨酸(SA)的化学需氧量(COD)浓度配比]对有机物去除和脱氮效果的影响。结果表明,当进水SA浓度低于187mg/L时,经AF工艺处理后,废水生化需氧量(BOD)5/COD由0.27增大至0.38,UV254/氧化还原电位(ORP)由-7.68增大至-3.22,可生化性明显提高。最佳水力停留时间(HRT)为10h,当比值为300∶300时,COD去除率最高(91.74%),SA去除率为91.4%;当比值为0∶600时,COD去除率最低(42%),SA去除率为52.48%。进水碳源变化对NH4+-N去除影响较小,去除率可达99.83%。SA功能菌依赖于非SA功能菌分泌的代谢产物生存,失去非SA功能菌分泌的代谢产物后,SA功能菌的活性开始降低。     

多峰映射族中非双曲奇异吸引子的丰富性

本文考虑多峰映射族中非双曲奇异吸引子的丰富性,证明多维参数空间中存在正测度的参数集合,对应系统具有绝对连续的不变测度.     

带附加噪声的随机广义2D Ginzburg-Landau方程的渐进行为

考虑带附加噪声的随机广义2D Ginzburg-Landau方程.通过先验估计的方法,随机动力系统的紧性得到证明,进一步验证了该随机动力系统在础存在随机整体吸引子.     

以L-组氨酸为模板仿生合成针状纳米碳酸钙

依据仿生合成原理, 以L-组氨酸为有机基质, 无水氯化钙和无水碳酸钠为原料, 通过简单的复分解反应制备出了平均直径约为80 nm, 长径比约为12∶1的针状纳米碳酸钙晶体. 利用高分辨扫描电子显微镜(FESEM)、X射线衍射仪(XRD)、傅里叶红外光谱议(FTIR)对产物进行了表征, 结果表明, 在不添加有机基质的溶液中得到立方状微米级的碳酸钙晶体, 添加L-组氨酸后得到针状纳米级的碳酸钙晶体, 并对L-组氨酸在仿生合成针状纳米碳酸钙过程中的作用机理进行了初步探讨.     

N-硫代酰基硫乙酸功能化三乙撑四胺交联PVC树脂的制备及对Hg~(2+)的吸附

以聚氯乙烯为原料依次与四乙烯五胺、CS_2和ClCH_2COONa反应合成了一种新的含N、O、S的N-硫代酰基硫乙酸功能化三乙撑四胺交联聚氯乙烯螯合树脂,树脂结构经红外分析和元素分析表征. 探讨了在不同pH值、Hg~(2+)初始浓度、吸附温度和时间等条件下合成树脂对Hg~(2+)的吸附性能. 结果表明,螯合树脂对Hg~(2+)有较快的吸附速率,pH值约为2.0时,树脂对Hg~(2+)的吸附效果最好,随温度升高吸附量逐渐增大. 温度在35 ℃、Hg~(2+)起始浓度为17.66 mmol/L时,树脂对Hg~(2+)的吸附量可达3.330 mmol/g. 树脂对Hg~(2+)的吸附符合Langmuir和Freundlich等温式. 用0.2 mol/L HNO3-10%硫脲对吸附后的树脂进行洗脱,脱附率达99.20%.     

聚(丙烯酸-co-丙烯酰胺)/蒙脱土/腐殖酸钠复合物对Pb2+的吸附性能

用制备的聚(丙烯酸-co-丙烯酰胺)/蒙脱土/腐殖酸钠复合吸附剂,研究了溶液pH值、吸附时间和Pb2+溶液初始浓度等因素对重金属Pb2+的吸附性能,探讨了复合吸附剂对Pb2+的吸附机理。结果表明,在pH值为6.0、吸附时间2 h、Pb2+溶液初始浓度0.01 mol/L和吸附剂用量0.10 g的条件下,复合吸附剂对Pb2+的吸附量达到364.05 mg/g,平衡所需的时间为15 min。与蒙脱土相比,复合吸附剂具有更高的吸附容量和更快的吸附速率。     

β-MnO2纳米棒的电磁特性和多极化驰豫损耗

采用低温水热合成法,以(NH₄)₂S₂O₈作氧化剂,以MnSO₄·H₂O为锰源,在高压反应釜中加热120 ℃并保压48 h制备了β-MnO₂纳米棒。利XRD,SEM,TEM和振动样品磁强计(VSM)对产物进行表征,并就产物的电磁特性和多极化损耗机制进行研究。结果表明,纳米粉体产物是直径为50～70 nm,长度约为几个微米并具有四方晶体结构的β-MnO₂纳米棒,同时产物表现出超顺磁性特征。β-MnO₂纳米棒具有优异的电磁波损耗特性,厚度为1 mm的试样其最大反射损耗在18 GHz能达到-8.1 dB,优于-5 dB的有效吸收带处于15.7～18 GHz宽频段内;2 mm厚的试样在9.8 GHz其反射损耗达到-25 dB,并且优于-5 dB的有效吸收带处于8～12.8 GHz。