气井携液临界流量计算方法研究

目前水平井中气液两相流动携液临界流量的计算方法仅考虑了水平井段的携液情况而没有考虑直井段与斜井段对携液的影响,所以在直井段和斜井段中未完全携带出的残余流体还是会流到井底,从而在水平井中产生积液.本文对液滴在水平井中直井段,斜井段和水平段进行受力分析发现,在不同的井段液滴因为受力不同从而产生不同的形变,从而计算的携液临界流量也不相同。基于携液理论与气液两相流型理论,根据不同位置的受力情况分别推导了液滴处于直井段,斜井段和水平段时的携液临界流量公式.而水平井的携液临界流量应该为液滴从直井段,斜井段和水平段流过时携液临界流量的最大值。最后通过理论计算与实验结果验证了方法的正确性.     

一些特殊的p核p群

给出了一些特殊的p核p群的分类,并给出了一些非正则p核p群的例子.     

HTS双饼线圈的加工工艺及实验研究

详细介绍了高温超导双饼线圈的加工工艺和流程,针对绕制时带材弯曲形变使临界电流退化的技术难点,重点阐述了其解决方法。在液氮温度、自场环境下对采用该加工工艺制作的YBCO双饼线圈及Bi2223/Ag双饼线圈进行低温实验,测试其V-I特性曲线。实验结果表明:该工艺制作的双饼线圈性能良好,工艺安全可靠,是合适的。同时,实验测量数据也为线圈在磁体中的进一步应用提供了可靠依据。     

中空纤维脂质体微筛选及其用于中药中香豆素类和木脂素类可透膜成分群的筛选和捕获

建立了中空纤维脂质体微筛选(Hollow fiber liposome microscreening,HFLMS)研究中药透膜化合物的方法。以中空纤维为脂质体载体,在模拟人体自然吸收的条件下,对中药提取液中可透膜化合物进行了筛选,并用HPLC进行分析。本研究在对空白和脂质体中空纤维表面性质表征的基础上,对中空纤维活性中心与目标物的非特异性结合和HFLMS方法的重现性进行了考察;将HFLMS与HPLC结合,分别对中药材蛇床子、补骨脂、羌活、独活提取液中透过脂质体的香豆素类成分群和五味子提取液中透过脂质体的木脂素类成分群进行了筛选和捕获;通过与对照品的色谱保留时间比对,对筛选出的与脂质体结合的部分化合物进行了结构鉴别。     

A class of finite groups with complete character degree graphs

In this paper, we construct a new class of finite groups whose common divisor graphs are complete graphs, while there is no prime dividing all the nontrivial degrees.     

群环Z_nD_m的代数结构

讨论了当m,n为素数时,群环Z_nD_m的代数结构,给出了其单位群和零因子.     

Alternating-current losses in two-layer superconducting cables consisting of second-generation superconductors coated by U-shaped ferromagnetic materials

Alternating-current losses in a two-layer superconducting cable, each layer being composed of 15 closely-spaced rectangular wires made up of second-generation superconductors when the ends of wires are coated by either a non-magnetic or strong ferromagnetic material having a U profile is numerically investigated. Computations are carried out through the finite-element method. The alternating-current losses do not increase significantly if the relative permeability of the coating is increased three orders of magnitude, provided that the current amplitude is less than half of the critical current in a superconducting wire. However, the losses are much higher for ferromagnetic coating if the amplitude of the applied current oscillating at 50 Hz is close to the critical current. The ferromagnetic coating is seen to accumulate the magnetic field lines normally on its surfaces, while the field lines are parallel to the long axes of the wires, leading to more significant flux penetration in the coated regions. This facilitates a uniform low-loss current flow in the uncoated regions of the wires. In contrast, coating with a non-magnetic material gives rise to a considerably smaller current flow in the uncoated regions, whereas the low-loss flow is maintained in the coated regions. Moreover, the current flows in opposite directions in the coated and uncoated regions, where the direction in each region is converse for the two materials.     

基于有限非阿贝尔群的密钥交换

从一般线性群GL（n,F）和对称群Sn上的困难问题出发,构造了几个密钥交换算法,新算法具有更高的效率.同时,指出基于一般线性群的密钥交换算法的安全性直接依赖于广义矩阵覆盖问题,基于对称群的密钥交换协议的安全性直接依赖于置换群上的共轭问题.     

厚度诱导的YBa2Cu3O7-δ超导薄膜剩余应力及临界电流变化

本文通过脉冲激光沉积法制备了不同厚度(80nm、320nm、1000nm和2000nm)的YBa2Cu3O7-δ(YBCO)超导薄膜,对它们的剩余应力和临界电流特性进行了对比研究.通过系列的激光显微Raman光谱和磁化曲线测量分别获得了薄膜剩余应力和磁化临界电流密度(Jc)对薄膜厚度的依赖关系.结果显示超导薄膜内剩余应力越小,Jc越高.对于中等厚度的薄膜样品(320nm和1000nm),其膜内剩余应力较小,同时由其特征的磁通匹配场大小推知在该厚度范围内的样品具有较高的线性缺陷密度,从而显示出较高的Jc值.     

Zr掺杂对MgB2超导微观结构和超导电性的影响

将Mg粉、Zr粉和B粉按比例混合获得Mg1-xZrxB2(x=5%10%和20%),压制成型后,在流通氩气的条件下于800℃烧结2h.利用X射线衍射仪(XRD)、扫描电子显微镜(SEM)分析烧结后样品的显微结构和化学组成,采用差热分析(DTA)观察Zr掺杂对MgB2分解温度的影响,并用物性测试仪(PPMS)测试样品的超...