辉石系矿渣微晶玻璃冲蚀磨损研究

采用熔融法以白云鄂博尾矿和粉煤灰为主要原料,制备了亚微米级辉石系矿渣微晶玻璃.采用XRD、SEM表征了其结构.以等量国产标准36#黑色SiC颗粒为磨粒,分别研究了该微晶玻璃在不同冲蚀角(30°～ 90°)、磨粒流量(0.22～3.9 g·s-1)、载荷(0.1 ～0.5 MPa)下的磨耗量变化规律.并通过冲蚀表面、剖面分析,单冲击实验和断裂分析研究了该微晶玻璃冲蚀磨损过程和机制.结果表明该微晶玻璃在相应冲蚀条件下,磨耗量随冲蚀角的增加逐渐增大;随磨粒流量的增加而减少;随着载荷的增加而线性增加.其冲蚀磨损去除方式以远大于晶粒的颗粒或残片脆性断裂为主导,部分冲蚀区域会产生冲蚀裂纹.断裂主要沿晶断裂或者穿过玻璃相断裂,也可能存在穿晶解理断裂.     

电喷雾萃取电离质谱法用于掺假白酒的快速分析

采用自行研制的电喷雾萃取电离源(EESI)与LTQ-XL质谱仪耦合,并结合主成分分析(PCA)和聚类分析(CA),建立了一种能在无需样品预处理的条件下直接、快速、准确鉴别茅台等八种掺假白酒(混掺水和工业酒精,且通过酒精计调控掺假酒的酒精度与真酒保持一致)的新方法. 同时,利用串联质谱能够对目标组分进行准确鉴定. 研究结果表明,EESI-LTQ-MS检测单个样品的时间小于1 min,且重现性好,PCA区分正确率高达96.5%. 通过设置未知样分析进一步验证了该方法的可行性. 此外,还结合单光子电离飞行时间质谱法(SPI-TOF-MS)对检测谱图进行对比分析. 阐述了EESI和SPI两种电离技术在挥发性有机物分析上具有各自的优势,且两种检测手段具有互补的特点. 为市场上酒类饮品真假的快速鉴别及品质鉴定建立了一个综合的分析方法,对于快速筛选伪劣酒类产品具有非常重要的应用价值.     

三种二元水溶液体系中氢键对拉曼线宽的影响

采用显微共聚焦拉曼光谱对三种二元水溶液(乙腈/水、二甲基亚砜(DMSO)/水和丙酮/水)进行测量,得到含有氢键作用的水溶液体系拉曼频移和线宽随浓度的变化规律。应用混合模型和相互作用体系的线宽经验公式对实验结果进行了分析。结果表明,含有氢键作用的水溶液体系中,氢键作用越强线宽越大,并且线宽随单位浓度变化率大;同种氢键体系中,线宽不仅受浓度浮动的影响,氢键作用也是一个重要的影响因素,定量分析证明线宽与浓度、氢键作用关系很好地符合Ojha等提出的线宽公式。     

A biosensor based on graphene nanoribbon with nanopores: a first-principles devices-design

A biosensor device,built from graphene nanoribbons(GNRs) with nanopores,was designed and studied by firstprinciples quantum transport simulation.We have demonstrated the intrinsic transport properties of the device and the effect of different nucleobases on device properties when they are located in the nanopores of GNRs.It was found that the device’s current changes remarkably with the species of nucleobases,which originates from their different chemical compositions and coupling strengths with GNRs.In addition,our first-principles results clearly reveal that the distinguished ability of a device’s current depends on the position of the pore to some extent.These results may present a new way to read off the nucleobases sequence of a single-stranded DNA(ssDNA) molecule by such GNRs-based device with designed nanopores     

通过确定初始电离位点预测吲哚类生物碱质谱的特征裂解规律

确定初始电离位点是EI源质谱解析中一个至关重要的环节. 本文提出了一种确定初始电离位点的新方法. 该法通过计算和分析分子离子自旋密度, 进而比较从中性分子到分子离子的电荷变化和键长变化, 从而确定初始电离位点. 对简单吲哚类生物碱质谱的特征裂解机理进行了预测, 结果与标准物质的质谱吻合. 在此基础上, 与传统的根据基团电离能确定电离位点的方法进行了比较. 结果表明, 该法优于电离能方法. 此法不仅可用于预测以α-裂解为主导的吲哚生物碱和其它含氮化合物的质谱裂解规律, 还为揭示其它小分子化合物以及气相多肽离子的裂解机理奠定了基础.     

Controlled decoherence of three-level rf-SQUID qubit with asymmetric potential

A scheme is proposed to controll the decoherence of three-level rf-SQUID qubit with asymmetric potential by designing an external electric circuit for superconductive flux qubit. The results show that it may not only raise the gate speed but also extend decoherence time for a three-level structure.     

Operating a geometric quantum gate by external controllable parameters

A scheme to perfectly preserve an initial qubit state in geometric quantum computation is proposed for a single-qubit geometric quantum gate in a nuclear magnetic resonance system. At first, by adjusting some magnetic field parameters, one can let the dynamic phase be proportional to the geometric phase. Then, by controlling the azimuthal angle in the initial state, we may realize a geometric quantum gate whose fidelity is equal to one under cyclic evolution. This means that the quantum information is no distortion in the process of geometric quantum computation.     

Negative differential resistance behaviour in N-doped crossed graphene nanoribbons

By using first-principles calculations and nonequilibrium Green’s function technique, we study elastic transport properties of crossed graphene nanoribbons. The results show that the electronic transport properties of molecular junctions can be modulated by doped atoms. Negative differential resistance (NDR) behaviour can be observed in a certain bias region, when crossed graphene nanoribbons are doped with nitrogen atoms at the shoulder, but it cannot be observed for pristine crossed graphene nanoribbons at low biases. A mechanism for the negative differential resistance behaviour is suggested.     

2-噻吩甲胺的合成研究

以2-噻吩甲醛为原料,通过与盐酸羟胺的肟化反应制得2-噻吩甲醛肟,然后将其在氢氧化钠水溶液中用锌粉还原生成了2-噻吩甲胺。提供了一条合成2-噻吩甲胺的新路线,2步反应的总收率为64%。文中对上述2步反应的条件分别进行了优化。考察了溶液酸碱度,温度和时间对肟化反应的影响,并     

微波法热处理制备CaO-MgO-Al2O3-SiO2系微晶玻璃的研究

以二氧化硅,三氧化二铝,氧化钙和氧化镁为主要原料,分别采用微波辐射和传统电加热制备了一系列CaO-MgO-Al2O3-SiO2 (CMAS)系微晶玻璃材料,对比两种方法的热处理制度对微晶玻璃结构与性能的影响,并进一步讨论了微波非热效应的影响.利用DTA、XRD、SEM和综合力学性能仪等手段,研究了两种对该系微晶玻璃显微结构及性能的影响.实验结果表明,两种方法制备的微晶玻璃主晶相均为辉石相,力学性能也基本相当.与传统热处理方法相比,微波法可在更短时间内制备出性能较好的微晶玻璃材料,微波非热效应有助于降低其晶化温度.