Volumetric properties of H2O, D2O, and methanol in acetonitrile at 278.15—318.15 K

The densities of H₂O, D₂O, and MeOH solutions in acetonitrile with the solute concentrations up to 0.07 molar fractions at 278.15, 288.15, 298.15, 308.15, and 318.15 K were measured using vibrating-tube densimetry with an error 8·10^–6 g cm^–3. The limiting partial molar volumes for the H/D isotopomers of water and IaII in acetonitrile (V^– ₂ ) and the isotope effects in V^– ₂ and in excess molar volumes of acetonitrile—water mixtures were calculated. Molecules of H₂O, D₂O, and IaII form associates with acetonitrile molecules via hydrogen bonds. The associates have the packing volumes close to those in the individual solute. The water and methanol molecules were assumed to be incorporated into the acetonitrile structure without substantial changes in the latter. However, this process results in some compression of the system with a simultaneous increase in its expansibility.     

Heat capacity of alcohols in aqueous solutions in the temperature range from 5 to 125°C

Using a precise technique of scanning microcalorimetry the heat capacity differences between water and dilute aqueous solutions of ethanol, n-propanol, n-butanol and n-pentanol were measured from 5 to 125°C and the partial molar heat capacities of these substances in water were determined. It was found that the heat capacity increment for alcohol disolved in water is proportional to the number of the-CH ₂ ^– groups and decrease with a temperature increase. The heat capacity increment of hydration of non-polar groups is shown to be positive and large at room temperature and decreases in magnitude as the temperature increases. In contrast, the heat capacity increment of hydration of polar groups is negative at room tempreature and increases as the temperature increases. From the temperature dependence of the heat capacity increment one can assume that the water molecules solvated by the non-polar groups of the alcohols behave in a non-cooperative manner.     

四元轻稀土硝酸盐水溶液体系{H2O+La(NO3)3+Pr(NO3)3+Nd(NO3)3}的热力学研究

在298.15 K条件下, 利用等压法研究了四元轻稀土硝酸盐水溶液{H2O La(NO3)3 Pr(NO3)3 Nd(NO3)3}及其3个二元亚系{H2O La(NO3)3}, {H2O Pr(NO3)3}和{H2O Nd(NO3)3}的热力学性质. 以NaCl或CaCl2水溶液为参考溶液, 测定了不同水活度条件下该四元溶液的渗透系数及各溶质组元的活度系数. 实验结果表明, 上述四元系与其3个二元亚系之间存在简单共性, 在实验误差允许范围之内(|Δ|≤0.0010), 该四元系符合偏理想溶液模型.     

Some chemical transformations of the neo-clerodane diterpene teubotrin

Starting from the natural neo-clerodane diterpenoid teubotrin (1) several neo-clerodane derivatives (3-7,9-11) have been obtained. The naturally occurring diterpenoid teuscordinon (12) has also been synthesized from teubotrin (1), showing thereby how some of these transformations can be useful for the synthesis of other natural neo-clerodane diterpenes. The latter are of interest due to their activity as insect antifeedants and other important biological properties.     

Liquid structure of vanadium tetrachloride from neutron diffraction study

Assuming the separation of the intermolecular scattering function into the radial and angular parts and using Egelstaffet al’s orientational model for tetrachlorides, the structure of liquid vanadium tetrachloride has been studied. It has been observed that such a separation is approximate for this liquid and the introduction of a third correction term is required to account for the molecular structure function. The chlorine-chlorine partial structure and effective angleaveraged intermolecular chlorine-chlorine potential in the liquid has been evaluated. Without taking the third correction term, introduced to generate theoretically the molecular structure function, the centre structure function has been obtained in an approximate way from the experimentally observed molecular structure function and from it the centre radial distribution function, centre direct correlation function and the angle-averaged vanadium-vanadium effective potential has been evaluated.     

The ionization of perchloric and hydrofluoric acids in aqueous solution

Cyclical bifurcated hydrogen bonded structures are proposed for aqueous solutions of hydrofluoric acid and for the bifluoride ion which are consistent with the spectral data. The structure proposed for HF is also applicable to solutions in organic solvents. Raman spectra of tetramethylguanidinium perchlorate suggest that the corresponding Raman spectra of perchloric acid solutions may not be interpreted in terms of a completely dissociated acid. Other evidence including activity coefficient, heat capacity and partial molal volume data suggest that there is some association in relatively dilute perchloric acid solutions between the perchlorate ion and the hydrated proton. This association decreases in concentrated aqueous solutions.     

Volumes,heat capacities and solubilities of amyl compounds in decyltrimethylammonium bromide aqueous solutions

Apparent molar heat capacities and volumes of amylamine (PentNH₂) 0.02m, capronitrile (PentCN) 0.02m and nitropentane (PentNO₂) 0.009m in decyltrimethylammonium bromide (DeTAB) micellar solutions, in water and in octane were measured at 25°C. By assuming that their concentration approaches the standard infinite dilution state, heat capacities and volumes were rationalized by means of previously reported equations following which the distribution constant between the aqueous and the micellar phase and heat capacity and volume of the additives in both phases are simultaneously derived. The present results are compared to those we have previously obtained for pentanol (PentOH). The thermodynamic properties of PentNH₂ in water and in micellar phase are substantially identical to those of PentOH but different from those of PentCN and PentNO₂ whereas the opposite behavior was observed in their pure liquid state and in octane. The nature of the solvent medium seems to affect the thermodynamic behavior of PentNH₂. Also, the study of the apparent molar heat capacities of the amyl compounds investigated here in micellar solutions as a function of surfactant concentration shows evidence of a maximum at about 0.4m DeTAB, which can be attributed to a micellar structural transition. Accordingly, the solubilities of PentCN and PentNO₂ as a function of the DeTAB concentration drop in the neighborhood of the concentration where heat capacities display the maximum.     

Partial Oxidation of Methane to Synthesis Gas over Hexaaluminates LaMAl11O19-δ catalysts

A series of M-substituted hexaaluminates LaMAl11O19-δ (M=Fe, Co, Ni, Mn, and Cu)were prepared and characterized by XRD, XPS, TPR and TGA techniques, respectively. They exhibited different reducibility and catalytic activity for partial oxidation of methane (POM) to synthesis gas. Among the LaMAl11O19-δ samples, LaNiAl11O19-δ showed the best catalytic activity for the topic reaction and selectivity for synthesis gas at 780 ℃ for 2 h. The conversion of CH4 was over 99.2%, and the product selectivity for both CO and H2 was above 90.3%.     

含钒杂多酸催化发烟硫酸中甲烷液相部分氧化反应

 以H5PV2Mo10O40 为催化剂,在发烟硫酸中进行了甲烷液相部分氧化,考察了催化剂用量、反应温度、反应时间和发烟硫酸浓度等工艺条件对反应收率的影响. 甲烷在反应中首先转化为硫酸甲酯,硫酸甲酯随后水解为甲醇. 对于甲烷液相部分氧化反应,发烟硫酸中游离的SO3是非常重要的影响因素. 在工艺条件为催化剂用量7.0 mmol, 反应温度473 K, 反应压力3.5 MPa, 反应时间3 h和发烟硫酸中SO3含量50%时,甲烷转化率可达48.5%, 目的产物甲醇收率为41.5%.     

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

The performance of uspported and unsupported molybdenum carbide for the partial oxidation of methane (POM) to syngas was investgated.An evaluation of the catalysts indicates that bulk molybdenum carbied has a higher methane conversion during the initial stage but a lower selectivity to CO and H2/CO ratio in the products.The rapid deactivation of the catalyst is also a significant problem.However,the supported molybdenum carbide catalyst shows a much higher methane conversion,increased selectivity and significantly improved catalytic stability.The characterization by XRD and BET specific area measurements depict an improved dispersion of molybdenum carbide when using alumina as a carrier.The bulk or the supported molybdenum carbide exists in the β-Mo2C phase,while it is transformed into molybdenum dioxide postcatalysis which is an improtant cause of molybdenum carbide deactivation.