Monte Carlo study of interfacial silicon suboxide layers and oxidation kinetics

A simple simulation scheme that simultaneously describes the growth kinetics of SiO₂ films at the nanometer scale and the SiO_x/Si interface dynamics (its extent, and spatial/temporal evolution) is presented. The simulation successfully applies to experimental data in the region above and below 10 nm, reproduces the Deal and Grove linear-parabolic law and the oxide growth rate enhancement in the very thin film regime (the so-called anomalous region). According to the simulation, the oxidation is governed mainly by two processes: (a) the formation of a transition suboxide layer and (b) its subsequent drift towards the silicon bulk. We found that it is the superposition of these two processes that produces the crossover from the anomalous oxidation region behavior to the linear-parabolic law.     

用于白光LED的高亮度蓝白色荧光粉Ca2SiO3Cl2：Eu2+的发光性质

采用固相法在较低温度下合成了Eu²⁺激活的Ca₂SiO₃Cl₂高亮度蓝白色发光材料,并对其发光性质进行了研究。其发射光谱由两个谱带组成,峰值分别位于420,498nm处,归结为Ca₂SiO₃Cl₂晶体中占据两种不同Ca²⁺格位的Eu²⁺离子的5d→4f跃迁发射。改变Eu²⁺浓度,可以使样品的发光在蓝白色和绿白色之间变化。当Eu²⁺浓度为0.005mol^-1时,样品呈现很亮的蓝白色发光。两个发射峰的激发光谱均分布在250~410nm的波长范围内,峰值分别位于333,369nm处。Ca₂SiO₃Cl₂:Eu²⁺可被InGaN管芯产生的近紫外辐射有效激发,是一种性能良好的白光LED用单一基质蓝白色荧光粉。     

非傍轴平顶高斯光束M2因子两种定义的比较研究

基于功率密度的二阶矩方法,推导出了非傍轴平顶高斯(FG)光束束宽和远场发散角的解析表达式·研究表明,当w0/λ→0时,远场发散角趋于渐近值θmax=63.435°,与阶数无关·使用非傍轴高斯光束代替傍轴高斯光束作为理想光束,研究了非傍轴FG光束的M2因子,并与传统定义的M2因子作了比较·在非傍轴范畴,非傍轴FG光束的M2因子不仅与阶数N有关,而且与w0/λ有关·按照定义,当w0/λ→0时,非傍轴FG光束的M2因子不等于0,对阶数N=1,2,3时,M2因子分别趋于0.913,0.882和0.886·当N→∞时,M2因子取最小值M2min=0.816·     

The influence of pulse duration on the stress levels in ablation of ceramics: A finite element study

We present a finite element model to investigate the dynamic thermal and mechanical response of ceramic materials to pulsed infrared radiation. The model was applied to the specific problem of determining the influence of the pulse duration on the stress levels reached in human dental enamel irradiated by a CO₂ laser at 10.6 μm with pulse durations between 0.1 and 100 μs and sub-ablative fluence. Our results indicate that short pulses with durations much larger than the characteristic acoustic relaxation time of the material can still cause high stress transients at the irradiated site, and indicate that pulse durations of the order of 10 μs may be more adequate both for enamel surface modification and for ablation than pulse durations up to 1 μs. The model presented here can easily be modified to investigate the dynamic response of ceramic materials to mid-infrared radiation and help determine optimal pulse durations for specific procedures.     

锐钛矿二氧化钛超细纳米晶的三声子互作用

本文通过对粒径为2.2-25.5nm的锐钛矿二氧化钛超细纳米晶在83-293 K温度范围内的变温拉曼光谱的研究,得到了三声子互作用对拉曼频率和线宽的贡献随粒径的变化关系。结果表明锐钛矿二氧化钛超细纳米晶的三声子相互作用随粒径减小而加强。     

光码分多址系统中光学相关接收机判决阈值的分析

介绍了光码分多址系统中常用地址码（一维扩时码、二维码和三维码）的特点，并对它们各自的互相关均值和方差进行了理论分析。基于非相干光码分多址系统中光学相关接收机的基本原理，结合不同的用户地址码，对系统误码率性能进行了分析，得到了接收机最佳判决阈值与地址码基本特性参数和系统同时用户数间的关系。最后，给出了数值仿真结果。结果表明，对于采用特定地址码的光码分多址系统，只有选择合适的接收机判决阈值，系统的误码率性能才能达到最佳。研究结果对光码分多址系统中接收机判决阈值的选取具有一定的参考作用。     

非傍轴平顶高斯光束M2因子两种定义的比较研究

基于功率密度的二阶矩方法，推导出了非傍轴平顶高斯(FG)光束束宽和远场发散角的解析表达式.研究表明，当w0/λ→0时，远场发散角趋于渐近值θmax=63.435°，与阶数无关.使用非傍轴高斯光束代替傍轴高斯光束作为理想光束，研究了非傍轴FG光束的M2因子，并与传统定义的M2因子作了比较.在非傍轴范畴，非傍轴FG光束的M2因子不仅与阶数N有关，而且与w0/λ有关.按照定义，当w0/λ→0时，非傍轴FG光束的M2因子不等于0，对阶数N=1, 2, 3时，M2因子分别趋于0.913,0.882和0.886.当N→∞时，M2因子取最小值M2min=0.816.     

Growth studies of m-GaN layers on LiAlO2 by MOCVD

This paper reports that the m-plane GaN layer is grown on （200）-plane LiAlO2 substrate by metal-organic chemical wpour deposition （MOCVD） method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer＇s thickness. The high transmittance （80%）, sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.     

蓝色长余辉光致荧光粉的研究

高温固相反应合成了蓝色长余辉光致荧光材料CaAl2O4∶Eu2 ,Nd3 ,La3 ,激发后在暗室中观察,余辉的颜色为蓝色。进行了添加辅助激活剂的实验,首次在CaAl2O4∶Eu2 ,Nd3 中添加La3 。测定了该长余辉材料的激发光谱、发射光谱、余辉亮度和可视余辉时间,并对长余辉发光机理进行了探讨。余辉发射光谱的峰值波长为440nm,可视余辉时间达到18h以上。波长为280~380nm的光都可将该材料激发。实验结果表明,添加辅助激活剂La3 ,延长了CaAl2O4∶Eu2 ,Nd3 的可视余辉时间。在CaAl2O4∶Eu2 ,Nd3 ,La3 中,Eu2 是发光离子,Nd3 和La3 是辅助激活剂,发射光谱由Eu2 的激发态4f65d到基态4f7的电子跃迁产生。     

基于旋转描述的三维几何造型方法

提出了一种能用凸四边形表示并可作平面展开的三维实体造型的设计方法。该方法用旋转描述表把二维平面展开图和三维实体联系起来，模拟人工折叠过程，由二维平面展开图逐次旋转变换完成三维造型重建。造型重建后，再通过纹理映射将平面设计图案映射到实体的各个面上，完成对实体着色渲染，生成具有真实感的三维实体。