Sobolev空间H~s(R~n)上矩阵伸缩的多尺度分析特征刻画

本文对高维Sobolev空间Hs(Rn)上具有矩阵伸缩的多尺度分析特征进行了 刻划,特别给出了稠密性特征的一个充分必要条件,从而解决了文献[4]中提出的一个 问题.所得结果覆盖了这方面的已知结论.     

LD泵浦Nd:YVO4/LBO临界相位匹配腔内倍频瓦级绿光激光器

报道了一种光纤耦合LD泵浦Nd:YVO₄晶体、腔内Ⅰ类临界相位匹配(角度匹配)LBO倍频、瓦级输出的全固态绿光激光器的设计方法和实验结果.采用短三镜折叠腔结构,通过对热透镜焦距的估算及计算机优化设计选取合适的谐振腔参量,在8 W的泵浦功率下,获得了1.6 W绿光基模输出,光-光转换效率达20%.经测量,绿光的偏振比超过400:1,4 h功率稳定度为±1.6%.     

轴流泵端壁区域流动三维粘性数值计算

本文采用通用流场分析软件FLUENT,基于N-S方程,选用RNG κ—ε湍流模型与SIMPLEC算法,对轴流泵叶轮内部(及端壁间隙)流动进行了三维粘性数值计算。通过实验验证,表明数值计算结果和实测数据吻合较好。详细分析了叶顶附近流场形态以及叶轮出口轴向、周向速度分布,进行了性能预估。并给出了实验装置图。     

对一个大单轴磁各向异性镍(Ⅱ)配合物中的磁跃迁的直接观察

最近Ruamps和同事发现三角双锥构型的Ni（Ⅱ）配合物[Ni（Me₆tren）Cl]ClO₄（1，Me₆tren=tris（2-（dimethylamino）ethyl）amine）具有大的单轴磁各向异性（J.Am.Chem.Soc.，2013，135：3017-3026）。他们利用HF-EPR研究获得横向零场分裂（ZFS）参数E=1.56（5）cm^-1但未能确定轴向零场分裂参数D。在本工作中，我们利用0~17.5 T和5 K的变磁场远红外光谱（FIRMS）来检测自旋基态S=1中的M_S=±1和M_S=0态之间的磁跃迁。在FIRMS中直接观察到Zeeman分裂态之间的跃迁，得出轴向ZFS参数D=-110.7（3）cm^-1。我们对1的晶体结构进行了Hirshfeld表面分析，揭示了1分子中的阳离子与阴离子之间以及分子之间的相互作用。     

水合醋酸铈直接热分解制备超细氧化铈及其抛光性能

Ultra fine ceria was prepared by calcining hydrate cerium acetate. The effects of pyrolysis temperature on the particle size, morphology, specific surface area and loose packing density of ceria were investigated, and the removal rate of optical glasses polishing by ceria was determined. The results show that with the increase of pyrolysis temperature, the loose deposit density and crystallinity increases and the specific surface area decreases, however, the particle size decreases firstly and then increases, the minimum medium particle size D₅₀ is 0.47 μm at pyrolysis temperature of 1 000 ℃. The SEM images of ceria prepared by the decomposition at 800 ℃ or at 1 100 ℃ show porous powders or quasi-sphere small particles with loosely agglomeration, respectively. It was found that the removal rate varied with pyrolysis temperature in preparation of ceria and the property of glass polished. The removal rate for three kinds of glasses was in the order of ZF7> F1> K9, and the maximum value appeared at around 1 000 ℃ for ZF7 and F1, and at around 1 100 ℃ for K9.     

电化学氟化的新进展

电化学氟化是利用电极反应将氟直接引入有机或无机物的一种重要方法。有机物的电化学氟化方法有两种: 一是Simons于1941年发明的, 用镍作阳极, 在无水氟化氢溶液中, 电解制备全氟化合物的方法。此方法在近年来有不少改进。另一是1970年Rozhkov提出的, 以有机溶剂(如含Et3N.3HF的MeCN)为介质, 在铂阳极上,氧化得到单氟化产物的方法。本文全面地综述了这两种方法, 并着重于最新民发展。     

STUDY ON THE SYNTHESIS OF POLYPERFLUOROTRIAZINE——The Synthesis and Polymerization of a Novel α,ω-Diiodoperfluorooxaalkyl s-Triazine Monomer*

In order to investigate synthetic route of polyperfluorotriazine elastomer, 2-trifluoromethyl4,6-bis(4′-iodo-2′-oxahexafluorobutyl)-1,3,5-triazine (1), a novel triazine monomer, was synthesized from 5-iodo-3-oxa-octafluoropentanesulfonyl fluoride (2) in eight-steps. 2 was reduced by potassium sulfite to the sulfinate (3), which was treated with hydriodic acid to yield 5-iodo-3oxa-hexafluoropentanoic acid (4). Compound 4 was transformed to 5-iodo-3-oxa-hexafluoropentanenitrile (7) through the corresponding ester 5 and amide 6. The desired product 1 was prepared by acylation-cyclodehydration of the imidoylamidine 9, obtained by condensation of the nitrile 7 with the amidine 8.The various methods for the esterification of perfluorocarboxylic acid were studied and a possible mechanism for the transformation of perfluorosulfinate to the corresponding perfluorocarboxylic acid by hydriodic acid was proposed.Crude 1 contained compounds 6, 11, 13, as impurities which were removed by low temperature crystallization followed by filtration through a short alumina column. The monomer 1 was polymerized by UV-irradiation in the presence of Hg with or without solvent. Polyperfluorooxaalkyl triazine 17 thus obtained showed good thermal stability. In the main chain of the polymer there was no weak unit of the uncyclized ring. Polymer 17 had an average molecular weight of ca. 1.33—2.0×10~4 (D. P.=27—42) and the temperature of 10% weight loss in nitrogen was 340℃.     

S2O2-8和SO2-4促进ZrO2固体超强酸正戊烷反应性能差异的研究

考察了常温下S2O2-8促进ZrO2(PSZ)固体超强酸催化剂上正戊烷的反应性能,并与SO2-4促进ZrO2(SZ)反应相比较,观察到PSZ和SZ对正戊烷都具有异构化和裂解的双重作用,主要产物分别为异戊烷和异丁烷.正戊烷的异构化转化率和表观反应速率常数主要取决于样品的焙烧温度.但对于正戊烷异构化反应,PSZ的最佳焙烧温度为550℃,比SZ的低50℃.在各自的最佳焙烧温度下反应1h后,前者的异戊烷生成率为后者的1.3倍.通过S含量和比表面积测定以及用XRD和FTIR等手段分析了PSZ的物理化学特性.从原位FTIR谱图发现,PSZ(550℃)表面S-O键的红外吸收明显比SZ(600℃)的强;通过吡啶红外手段发现PSZ(550℃)吡啶离子吸收峰的红移大于SZ(600℃),表明前者的Lewis酸强于后者.     

碳化钨负载S2O2-8/ZrO2固体超强酸催化剂上的正戊烷反应研究

首次研究了碳化钨负载S2O28-/ZrO2(PSZ)固体超强酸催化剂(WC/PSZ)上正戊烷的反应情况及影响催化剂活性的各种因素,并用GC-MS,XRD,BET等手段分析了正戊烷反应产物和催化剂的物理化学性质等.结果表明:WC/PSZ对正戊烷具有异构化和裂解的双重催化作用.PSZ在负载适量碳化钨后对正戊烷反应的活性和选择性显著提高,显示出优于Pt/PSZ催化剂的效果,碳化钨的负载量为20%的效果最佳.适当的焙烧、活化和反应温度等条件是取得良好反应效果的关键.     

用EM算法改进鸟枪法蛋白质鉴定中的无标记定量方法

蛋白质定量是探索疾病发生发展状况和寻找新药靶标的重要手段。在shotgun蛋白组学中,目前常用定量方法包括综合同位素标记后的质谱峰强度方法和无标记定量方法。根据数据类型无标记定量方法可以分为两类:基于鉴定蛋白的质谱数的方法和基于质谱峰强度的方法。本研究主要用EM算法改进基于鉴定蛋白质谱数的定量方法,并用免疫印迹实验获得的酵母全蛋白的丰度来验证EM算法改进后定量的有效性结果表明,改进后的质谱数和蛋白丰度的相关性比改进前有一定的提高。同时,利用这些数据对主要的几种基于鉴定蛋白的质谱数的模型进行了比较,发现PAI模型最好,SpS模型次之,emPAI模型最不适合于蛋白质定量。