EXACT AUGMENTED LAGRANGIAN FUNCTION FOR NONLINEAR PROGRAMMING PROBLEMS WITH INEQUALITY CONSTRAINTS

An exact augmented Lagrangian function for the nonlinear nonconvex programming problems with inequality constraints was discussed. Under suitable hypotheses, the relationship was established between the local unconstrained minimizers of the augmented Lagrangian function on the space of problem variables and the local minimizers of the original constrained problem. Furthermore, under some assumptions, the relationship was also established between the global solutions of the augmented Lagrangian function on some compact subset of the space of problem variables and the global solutions of the constrained problem. Therefore, from the theoretical point of view, a solution of the inequality constrained problem and the corresponding values of the Lagrange multipliers can be found by the well-known method of multipliers which resort to the unconstrained minimization of the augmented Lagrangian function presented.     

局部荷载作用下网架结构的拟夹层板分析法

把正交正放类网架结构简化为构造上正交异性的夹层板，采用考虑剪切变形的具有三个广义位移的平板弯曲理论来分析，给出了网架结构在局部荷载作用下的内力、位移解析计算公式，并用有限元方法进行了验证．     

脉劝流条件下血管壁的应力分布

为了分析血液-血管耦合运动所产生血液脉动压力载荷对血管壁应力分布的影响,利用线性化的血液-血管耦合运动方程的Womersley解,导得血液脉动压力载荷下的血管壁Green应变,同时利用Fung的血管壁应变能密度函数,导得相应血管壁应力分布的一般表达式.数值结果表明,在脉动流条件下,当考虑血液-血管耦合运动时,血管壁中周向应力最大,轴向应力居中,径向应力最小;血管壁的残余应力将明显减小血管内壁的应力集中;脉动压力载荷将导致血管壁周向应力在一个心动周期中随时间的脉动,而且随着Womersley数α和血管轴向约束参数K～＊的增大,血管壁周向应力的脉动将明显加剧,提示在分析动脉重建时必须计及血液-血管耦合运动对血管壁应力分布的影响.     

动脉狭窄对血液流速的影响

为了定量计算动脉局部狭窄对动脉管中血液流动速度的影响，本文分别对狭窄区域内定常流和非定常流动进行了求解，得出了狭窄区域内定常流和脉动流的速度表达式。本文将均匀段的流速形经Ｆｏｕｒｉｅｒ分解成定常和脉动两部分，然后分别计算出狭窄区域内对应的定常和脉动流速，经Ｆｏｕｒｉｅｒ合成还原成流速时域波形，同时针对各种情况将不同狭窄对不同的流速波形的作了分析比较。     

结构局部非线性修改灵敏度分析及其应用

以线性系统的非线性修改方法为基础，导出了局部非线性振动的灵敏度分析方法；提出了灵敏度为指导的优化设计思想，并将其应用于大型结构上的局部非线性因素的优化设计。文中介绍一些典型非线性特征的数学描述。最后，本文以火炮结构中的炮口振动为例，提出在炮口处增设炮口减振器的设计思想，并用本文方法对炮口减振器的参数进行优化设计，得到满意的结果。     

旋转压电纳米梁的振动分析

本文基于非局部弹性理论，对旋转压电纳米梁模型的振动进行了分析．首先由哈密顿原理导出旋转压电纳米梁的动力学控制方程及相应的边界条件；再通过微分求积法对控制方程和两类边界条件进行离散；最后通过数值计算分析振动特性．通过改变旋转角速度、轮毂半径、非局部参数以及外部电压分析它们对压电纳米梁振动频率的影响关系．数值结果表明这些参数对压电纳米梁固有频率有不可忽略的影响，本文进一步讨论了旋转角速度对结构模态的影响．     

ANALYSIS OF THE LOCALIZATION OF DAMAGE AND THE COMPLETE STRESS-STRAIN RELATION FOR MESOSCOPIC HETEROGENEOUS ROCK UNDER UNIAXIAL TENSILE LOADING

The mechanical behavior of rock under uniaxial tensile loading is different from that of rock under compressive loads. A micromechanics-based model was proposed for mesoscopic heterogeneous brittle rock undergoing irreversible changes of their microscopic structures due to microcrack growth. The complete stress-strain relation including linear elasticity, nonlinear hardening, rapid stress drop and strain softening was obtained. The influence of all microcracks with different sizes and orientations were introduced into the constitutive relation by using the probability density function describing the distribution of orientations and the probability density function describing the distribution of sizes. The influence of Weibull distribution describing the distribution of orientations and Rayleigh function describing the distribution of sizes on the constitutive relation were researched. Theoretical predictions have shown to be consistent with the experimental results.     

岩土材料应变局部化的有限元分析方法

采用有限单元法分析岩土材料的应变局部化时经常会遇到单元尺寸敏感性问题和网格锁定问题。自适应网格技术能够有效地解决网格锁定问题,但仍然无法克服计算结果对单元尺寸的依赖性,尽管在一维情况下被证明是可行的。复合体理论(均匀化理论)和弱非连续有限元方法可以成功地解决岩土材料的单元尺寸敏感性问题,在一维情况下两类方法实际上是一致的。本文针对岩土材料应变局部化的有限元新技术所存在的若干问题进行了详细的讨论,并给出了有关算例。     

The micropolar fluid model for blood flow through a tapered artery with a stenosis

A micropolar model for axisymmetric blood flow through an axially nonsymmetreic but radially symmetric mild stenosis tapered artery is presented. To estimate the effect of the stenosis shape, a suitable geometry has been considered such that the axial shape of the stenosis can be changed easily just by varying a parameter （referred to as the shape parameter）. The model is also used to study the effect of the taper angle Ф. Flow parameters such as the velocity, the resistance to flow （the resistance impedance）, the wall shear stress distribution in the stenotic region and its magnitude at the maximum height of the stenosis （stenosis throat） have been computed for different values of the shape parameter n, the taper angle Ф, the coupling number N and the micropolar parameter m. It is shown that the resistance to flow decreases with increasing the shape parameter n and the micropolar parameter m while it increases with increasing the coupling number N. So, the magnitude of the resistance impedance is higher for a micropolar fluid than that for a Newtonian fluid model. Finally, the velocity profile, the wall shear stress distribution in the stenotic region and its magnitude at the maximum height of the stenosis are discussed for different values of the parameters involved on the problem.     

Response of saturated porous media subjected to local thermal loading on the surface of semi-infinite space

Heat source function method is adopted in the present paper to derive elementary solutions of coupled thermo-hydro-mechanical consolidation for saturated porous media under conjunct actions of instantaneous point heat source, instantaneous point fluid source and constant volume force. By using the so-called fictitious heat source method and images method, the solutions of a semi-infinite saturated porous medium subjected to a local heat source with time-varied intensity on its free surface are developed from elementary solutions. The numerical integral methods for calculating the unsteady temperature, pore pressure and displacement fields are given. The thermomechanical response are analyzed for the case of a circular planar heat source. Besides, the thermal consolidation characteristics of a saturated porous medium subjected to a harmonic thermal loading are also given, and the fluctuation processes of the field variables located below the center of heat source are analyzed. The project supported by the National Natural Science Foundation of China (50578008) The English text was polished byYunming Chen.