不同退火条件对PEALD制备的Ga2O3薄膜特性的影响

利用等离子增强原子层沉积技术(PEALD)在c面蓝宝石衬底上制备了氧化镓(Ga₂O₃)薄膜,研究了退火气氛(v(N₂)∶v(O₂)=1∶1(体积比)、空气和N₂)及退火时间对Ga₂O₃薄膜晶体结构、表面形貌和光学性质的影响。研究结果表明,退火前的氧化镓处于亚稳态,不同退火气氛下退火后晶体结构发生明显改变,而且退火气氛中N₂比例增加有利于Ga₂O₃重结晶。在N₂气氛下退火达到30 min,薄膜结构已由亚稳态转变成择优取向的β-Ga₂O₃。而且表面形貌分析表明,退火30 min后表面形貌开始趋于稳定,表面晶粒密度不再增加。另外实验样品在 400~800 nm的平均透射率几乎是100%,且光吸收边陡峭。采用N₂气氛退火,对于富氧环境下沉积的Ga₂O₃更利于薄膜表面原子迁移,以及择优取向Ga₂O₃重结晶。     

石墨烯负载的氧配位钴单原子稳定金属锂负极

Lithium (Li)-based batteries are the dominant energy source for consumer electronics, grid storage, and electrified transportation. However, the development of batteries based on graphite anodes is hindered by their limited energy density. With its ultrahigh theoretical capacity (3860 mAh∙g⁻¹), low redox potential (−3.04 V), and satisfactorily low density (0.54 g∙cm⁻³), Li metal is the most promising anode for next-generation high-energy-density batteries. Unfortunately, the limited cycling life and safety issues raised by dendrite growth, unstable solid electrolyte interphase, and "dead Li" have inhibited their practical use. An effective strategy is to develop a suitable lithiophilic matrix for regulating initial Li nucleation behavior and controlling subsequent Li growth. Herein, single-atom cobalt coordinated to oxygen sites on graphene (Co-O-G SA) is demonstrated as a Li plating substrate to efficiently regulate Li metal nucleation and growth. Owing to its dense and more uniform lithiophilic sites than single-atom cobalt coordinated to nitrogen sites on graphene (Co-N-G SA), high electronic conductivity, and high specific surface area (519 m²∙g⁻¹), Co-O-G SA could significantly reduce the local current density and promote the reversibility of Li plating and stripping. As a result, the Co-O-G SA based Li anodes exhibited a high Coulombic efficiency of 99.9% at a current density of 1 mA∙cm⁻² with a capacity of 1 mAh∙cm⁻², and excellent rate capability (high current density of 8 mA∙cm⁻²). Even at a high plating capacity of 6 mAh∙cm⁻², the Co-O-G SA electrode could stably cycle for an ultralong lifespan of 1300 h. In the symmetric battery, the Co-O-G SA based Li anode (Co-O-G SA/Li) possessed a stable voltage profile of 18 mV for 780 h at 1 mA∙cm⁻², and even at a high current density of 3 mA∙cm⁻², its overpotential maintained a small hysteresis of approximately 24 mV for > 550 h. Density functional theory calculations showed that the surface of Co-O-G SA had a stronger interaction with Li atoms with a larger binding energy, −3.1 eV, than that of Co-N-G SA (−2.5 eV), leading to a uniform distribution of metallic Li on the Co-O-G SA surface. More importantly, when matched with a sulfur cathode, the resulting Co-O-G SA/lithium sulfur full batteries exhibited a high capacity of 1002 mAh∙g⁻¹, improved kinetics with a small polarization of 191 mV, and an ultralow capacity decay rate of 0.036% per cycle for 1000 cycles at 0.5C (1C = 1675 mA∙g⁻¹) with a steady Coulombic efficiency of nearly 100%. Therefore, this work provides novel insights into the coordination environment of single atoms for the chemistry of Li metal anodes for high-energy-density batteries.     

U型通道内部流动与换热的数值研究

应用数值方法研究了燃气轮机叶片内部U型通道内流动与顶部换热特性.采用SST k-ω模型,分析了U型通道内光滑和带凹坑顶部结构以及不同Re数和旋转数对U型通道内部流动和顶部换热的影响。结果表明:在静止条件下,带凹坑结构的通道顶部Nu数较高,并且随着凹坑深度的增加,通道顶部换热能力增强;并且凹坑结构对通道压降的影响较小。随雷诺数增大,凹坑对通道顶部换热增强的幅度降低。在旋转状态下,随着旋转数的增加,通道顶部换热能力增强,但通道压降增大。     

石墨炉原子吸收光谱法测定明胶空心胶囊中铬的残留量

明胶空心胶囊样品经硝酸微波消解,采用石墨炉原子吸收光谱法测定其中铬的残留量。采用灰化温度为900℃,原子化温度为2 500℃。铬的质量浓度在2~30μg·L-1范围内与其吸光度呈线性关系,检出限(3s/k)为0.103mg·kg-1。应用此方法分析了明胶空心胶囊样品。用标准加入法进行回收试验,所得回收率在95.9%~102%之间,测定值的相对标准偏差(n=9)均小于2.0%。     

A multi-functional polymer coating that is heat-resistant,hydrophobic and transparent

A multi-functional polymer film with high hydrophobicity and transparency was formed by simple casting of a polycarbonate solution onto a substrate having micro-scale roughness.The high hydrophobicity was heat-resistant,which can be retained up to 390 ℃.The polymer film may have potentially wide-ranging applications in industry and high technology.     

以gp41为靶标的小分子-多肽缀合物作为HIV-1融合抑制剂的设计、合成及活性初筛

芳基吡咯类小分子化合物NB-2衍生物(Noc或Npc)与衍生于C34中的靶标特异性多肽P26所形成的缀合物具有低纳摩尔水平的融合抑制活性.本文通过不同长度或不同柔性的连接臂将Noc或Npc与衍生于C34的靶标特异性多肽P27缀合,探讨了C34中a位残基I635和连接臂对缀合物活性的影响.人体免疫缺陷病毒1型(HIV-1)Env介导的细胞-细胞融合实验结果表明,多肽与小分子之间产生了强的协同作用.     

基于罗丹明B的激活型α-酮戊二酸荧光探针

α-酮戊二酸(α-KA)是人体三羧酸循环的一个重要代谢中间体,异柠檬酸脱氢酶-1(IDH1)及异柠檬酸脱氢酶-2(IDH2)的突变将导致α-KA转化为2-羟基戊二酸(2HG),该过程与急性骨髓性白血病(AML)密切相关,因此检测人体内α-KA的含量变化具有重要意义。本文以罗丹明B作为荧光基团,通过将罗丹明B与水合肼反应得到能够检测α-KA的荧光增强型探针RBN,并优化了检测温度、pH及响应时间等条件。研究表明,RBN对α-KA表现出很好的选择性,不受人体内常见氨基酸、化学结构类似的羰基化合物及活性氧化物(ROS)的影响,具有潜在的应用价值。     

银(I)配位聚合物修饰Preyssler型多金属氧酸盐的高维、高连接结构的组装及性质

以AgNO3、K12.5Na1.5[Na P5W30O110]·15H2O及柔性配体1,1′-双(3,5-二甲基-1H-吡唑)甲烷(H2bdpm)为原料,利用水热合成方法合成了1个新的基于单核银为中心的Preyssler多酸阴离子的有机-无机杂化化合物:[Ag13(H2bdpm)8(H2O)5(HAg P5W30O110)]·2H2O(1),并通过元素分析、红外光谱、热重分析和X-射线单晶衍射等分析手段对化合物1进行了表征.X-射线单晶结构分析表明,该化合物属于三斜晶系,P1空间群,晶胞参数:a=19.135(5),b=20.313(5),c=28.400(5),Z=2,R1=0.0550,w R2=0.1542.化合物1包含罕见的以单核银为中心的Preyssler型多酸阴离子,该阴离子通过金属银连接形成二维无机层.相连的二维层之间通过多种Ag-H2bdpm金属有机亚单元进一步连接形成三维框架.该化合物最大的结构特点在于Preyssler型多酸阴离子的高连接(十八连接)以及Ag(I)离子多样的配位模式.     

活性炭吸附-火焰原子吸收光谱法测定粗硒中的金

建立了活性炭吸附-火焰原子吸收光谱法测定粗硒中金量的分析方法。讨论了称样量、溶样条件和活性炭的灰化程度对金量测定的影响,并且对火焰原子吸收光谱法与火试金法测定粗硒中的金量做了比较。火焰原子吸收光谱法和火试金法测定的相对标准偏差分别为1.3%~5.9%和0.91%~7.8%;加标回收率分别为93.1%~100.7%和94.8%~102.2%。结果表明,方法有较好的精密度和准确度,并且具有较强的实用性。     

火试金-原子吸收光谱法测定锡阳极泥中金、银含量

锡阳极泥是锡冶炼过程中的一种中间产物,其中含有大量的金、银等贵金属。准确测定锡阳极泥中金、银含量有很重要的现实意义。采用火试金法能实现锡阳极泥中金、银含量的连续测定,方法准确度高,精密度好,金、银回收率在97.46%~101.66%,能很好地满足锡阳极泥中高品位金、银的测定。