铟镓共掺杂对n-ZnO纳米棒/p-GaN异质结生长行为和光电性能的影响

利用低温水热法在p-GaN薄膜上生长了铟(In)和镓(Ga)共掺杂的ZnO纳米棒。X射线衍射(XRD)、X射线光电子能谱(XPS)和X射线能量色谱仪(EDS)结果表明,In和Ga已固溶到ZnO晶格中。扫描电子显微镜(SEM)结果表明, ZnO纳米棒具有良好的c轴取向性,随着In和Ga共掺杂浓度的增加,纳米棒的直径减小,密度增加。XRD结果表明,In和Ga共掺杂引起ZnO晶格常数增大,导致(002)衍射峰向低角度方向偏移。同时,ZnO的光学性质受到In和Ga共掺杂的影响。与纯ZnO相比, 共掺杂ZnO纳米棒的紫外发射峰都出现轻微红移,这是表面共振和带隙重整效应综合作用的结果。I-V特性曲线表明,随着In和Ga共掺杂浓度的增加,n-ZnO纳米棒/p-GaN异质结具有更好的导电性。     

电感耦合等离子体原子发射光谱(ICP-AES)法测定高纯铝中Fe、Cu、Mg、Zn、Ti

建立了用电感耦合等离子体原子发射光谱(ICP-AES)法测定高纯铝中Fe、Cu、Mg、Zn、Ti的方法。详细讨论了基体元素和共存元素对分析元素的光谱干扰,以及盐酸用量的影响;选择了合适的分析谱线,同时得出了各元素的检出限。证明用基体匹配的方法在Fe 259.940nm、Cu 327.396nm、Mg279.079nm、Zn 213.856nm、Ti 334.941nm处可准确、可靠地测定高纯铝中含量范围在0.001%~0.01%的Fe、Cu、Mg、Zn、Ti元素。     

高比能锂离子电池层状富锂正极材料改性策略研究进展

层状富锂材料具有超过250 mAh∙g⁻¹的高可逆比容量,被认为是下一代高比能锂离子电池最具商业化前景的正极材料之一。然而,层状富锂材料在实际应用之前仍需解决诸多挑战,如高电压氧释放、层状到岩盐相的结构变化、过渡金属离子迁移等结构劣化,并由此带来了较低的初始库伦效率、电压/容量的衰减以及循环寿命的不足。针对以上问题,进行层状富锂材料改性无疑是一种行之有效的方法。本综述全面介绍了层状富锂材料的结构、组分以及电化学性能,在此基础上对材料改性策略进行了系统阐述,详细介绍了体相掺杂、表面包覆、缺陷设计、离子交换和微结构调控等一系列改性策略的现状以及发展趋势,最终提出了高容量和长循环层状富锂材料和高比能锂离子电池的设计思路。     

硼、磷共掺杂铁钴双金属材料的制备及其电催化析氧性能

采用一步水热法合成了硼、磷共掺杂铁钴材料(Fe-Co-B-P)。借助扫描电子显微镜(SEM)、X射线衍射(XRD)、X射线光电子能谱(XPS)、傅里叶变换红外光谱(FT-IR)等技术对所合成材料的形貌、结构和组成进行表征。利用线性扫描伏安(LSV)、循环伏安(CV)、电化学阻抗谱(EIS)等技术研究材料电化学析氧反应(OER)性能。结果表明,Fe-Co-B-P表面疏松且粗糙,颗粒间有许多空隙。在电流密度为10和100 mA·cm^-2时,其过电势分别为278和309 mV,Tafel斜率为24 mV·dec^-1,说明该材料具有较优的电催化析氧性能。其在连续进行10 h的计时电位测试过程中,电势基本保持在1.55 V(vs RHE),表明该催化剂具有较好的电化学稳定性。这是由于铁钴双金属与硼、磷非金属之间的协同作用促进了电子的传递。     

硼、氮共掺杂多孔碳的制备及其超电容性能

分别以含氮菲咯啉、四硼酸钾和醋酸锌为碳源、活化剂和模板,制备了B、N共掺杂多孔碳(BN-PC),并探究模板质量对BN-PC结构和储电性能的影响。当醋酸锌质量为5 g时,所得BN-PC₅中B、N杂原子含量分别为20.21%、18.29%。电化学测试结果表明,以6 mol·L^-1KOH为电解液,BN-PC₅电极展现出高的比电容(在0.05 A·g^-1电流密度下为255 F·g^-1)、优异的倍率性能(在20 A·g^-1电流密度下为188 F·g^-1)和卓越的循环稳定性(在5 A·g^-1的电流密度下循环10 000次比电容保持率为97%)。以3mol·L^-1ZnSO₄为电解液,在平均功率密度为56 W·kg^-1时,BN-PC₅电容器的能量密度可达27 Wh·kg^-1。     

Pd和Hg共掺杂的金属纳米团簇HgPdAu23(PET)18

异金属原子引入原子精确的金属纳米团簇是调控团簇物理化学性质的有效手段,目前报道的异金属原子掺杂团簇大多数是单个金属原子掺入金属团簇中形成的二元金属纳米团簇,而两个异金属原子同时掺入同一个金属团簇中形成三元金属纳米团簇的报道较少.本工作中,我们报道了Pd和Hg双原子同时掺入Au₂₅(PET)₁₈(PET=苯乙硫醇)团簇中形成HgPdAu₂₃(PET)₁₈新团簇,推测了Pd和Hg在三元金属团簇中最可能的位置,即Pd位于三元金属团簇的内核中心,而Hg原子位于三元金属团簇内核的表面.不同金属种类以及不同的掺杂位置导致了三元金属团簇HgPdAu₂₃(PET)₁₈具有不同于原始团簇Au₂₅(PET)₁₈和二元金属团簇PdAu₂₄(PET)₁₈和HgAu₂₄(PET)₁₈的电子构型.本研究为双金属异原子掺入金属纳米团簇的精准制备提供了新的思...     

CoMn@NC催化5-羟甲基糠醛常压氧化为2, 5-呋喃二甲酸二甲酯

Dimethyl furan-2, 5-dicarboxylate (DMFDCA) is a valuable biomass-derived chemical that is an ideal alternative to fossil-derived terephthalic acid as a monomer for polymers. The one-step oxidation of 5-hydroxymethylfurfural (HMF) to DMFDCA is of practical significance. It not only shortens the reaction pathway but also avoids the separation process of intermediates; thus, reducing cost. In this work, non-noble bimetallic catalysts supported on N-doped porous carbon (CoMn@NC) were synthesized via a one-step co-pyrolysis procedure using different pyrolysis temperatures and proportions of metal precursors and additives. We employed the prepared CoMn@NC catalysts in the aerobic oxidation of HMF under mild reaction conditions to obtain DMFDCA. High-yield DMFDCA was obtained by screening the prepared catalysts and optimizing the reaction conditions, including the strength and amount of the base, as well as the reaction temperature. The optimized yield of DMFDCA was 85% over the Co₃Mn₂@NC-800 catalyst after 12 h at 50 ℃ using ambient-pressure oxygen. The physicochemical properties of the catalysts were determined using a variety of characterization techniques, the factors affecting the performance of each catalyst were investigated, and the relationship between the physicochemical properties and performance of the prepared catalysts was elucidated. A porous structure with a high surface area had a positive effect on mass transfer efficiency. Cobalt nanoparticles (NPs) and atomically dispersed Mn were coordinated to N-doped carbon to form M―N_x (where M = Co or Mn). Based on the Mott-Schottky effect, there was significant electron transfer between each metal and the N-doped carbon, additionally, the metal NPs supplied electrons to the carbon atoms. The electron-deficient metal site in the pyridinic N-rich carbon was beneficial for the activation of HMF and oxygen. The activation of oxygen produced reactive oxygen species (such as superoxide radical anions) to ensure high selectivity to DMFDCA through dehydrogenative oxidation of the hemiacetal intermediate and hydroxymethyl group of 5-hydroxymethyl-2-methyl-furoate. The existence of disordered and defective carbons increased the number of active sites. Subsequently, we performed a series of control experiments. Based on our current experimental results and previous studies, we propose a simple mechanism for the aerobic oxidation of HMF to DMFDCA. The catalyst was stable, its performance decreased slightly after two cycles, and it was tolerant to SCN⁻ ions and resistant against N or S poisoning. Furthermore, the use of this catalytic system can be expanded to various substituted aromatic alcohols, such as benzyl alcohols with different substituents, furfuryl alcohol, and heterocyclic alcohols. Simultaneously, the product type was further extended from methyl esters to ethyl esters with a high yield when the substrate reacted with ethanol. In conclusion, this catalytic system can be applied in the production of carboxylic esters for polymers.     

Fe掺杂NiSe@NiS复合材料电子调制和界面协同促进析氧性能研究

本研究采用溶剂热法,在泡沫镍(NF)基底上原位合成出Fe掺杂的硒化镍和硫化镍复合材料(Fe-NiSe@NiS/NF)。得益于Fe掺杂优化的电子结构、NiSe和NiS间的协同效应以及高效的电荷转移速率,Fe-NiSe@NiS/NF在1 mol/L KOH溶液中表现出优异的OER性能。在过电位为330 mV时可实现电流密度150 mA/cm²,且电压在稳定40 h后没有发生显著改变。     

氮氧共掺杂多孔炭的制备及其锌离子混合超级电容器性能研究

本研究以价格低廉、来源广泛的煤沥青作为炭前驱体、尿素作为氮源和模板、氢氧化钠作为活化剂,通过结合模板法与化学活化法成功制备了具有纳米片状结构的氮氧共掺杂的多孔炭材料。多孔炭电极在0.05 A/g时最大比容量高达255.5 m A·h/g,在电流密度为1 A/g时,放电比容量达到78 m A·h/g。经过12000次循环,容量保持率仍有72.4%,并且能量密度最高达到99.6 W·h/kg,展现出作为正极材料的巨大潜力。以煤沥青为原料制备的氮氧共掺杂多孔炭材料作为锌离子混合超级电容器的正极材料表现出了优异的电化学性能。     

空心氮掺杂碳球锚定单原子铁位点用于高效电催化氧还原反应（英文）

本研究将单原子分散的Fe-N₄位点锚定在氮掺杂空心多孔碳球上用于电催化氧还原反应,研究表明,所制备的FeSAs/HNCSs-800催化剂表现出优异的电催化氧还原性能,其起始电位为0.925 V,半波电位为0.867 V。球差电镜和同步辐射X射线吸收光谱证实了催化剂中存在高度分散的Fe-N₄单原子位点。通过密度泛函理论计算证明单原子Fe-N₄位点是氧还原反应有效的活性位点,其相邻的C缺陷可以有效调控单原子Fe的电子结构,进而提高电催化氧还原性能。