催化热解-冷原子吸收分光光度法测定大米中的汞含量

建立冷原子吸收分光光度法测定大米中汞含量的方法。采用DMA–80直接测汞仪,大米样品经干燥、分解灰化、还原等过程,直接进入冷原子吸收光谱仪进行测量。干燥温度为200℃,热解温度为650℃。该方法的检出限为0.001 ng/g,加标回收率为85.0%～99.2%,测定结果的相对标准偏差为0.25%～3.70%(n=6)。利用标准物质和原子荧光法进行比对试验,测定结果均在误差范围内。该方法测定结果准确,灵敏度高,重现性好,适用于大米中汞含量的测定。     

基于正交试验设计的我国高科技企业技术创新获取途径选择对创新能力的影响研究

技术获取途径的选择对于高科技企业的创新驱动发展具有重要的影响,正确的获取途径选择,可以有效提高企业的竞争力。本文通过广义试验方法,以企业技术研发或改造项目的成功率、企业整体创新能力以及企业整体创新能力孕育潜力为试验指标,进行多指标试验,通过对试验结果进行部分正交多项式回归分析,讨论内部创新技术研发程度、购买新技术程度和合作开发新技术程度对试验指标的影响规律,得出了加强对企业内部技术研发投入以及扩大与科技院所合作来提高企业创新能力的相关建议。     

强耦合腔-QED系统中原子的纳秒脉冲激发光谱研究

本文在多原子强耦合腔-QED系统中,利用脉冲宽度为5 ns的强脉冲光在垂直于腔轴方向直接激发原子,脉冲的峰值功率为40 mW,通过光学腔观测激发原子辐射到腔中的光子获得相应的激发光谱。我们发现当光场频率和原子跃迁失谐±80 MHz时原子激发率达到最大,而在共振时原子激发被抑制。我们建立了脉冲光与三能级原子相互作用的模型,通过缀饰态能够解释此现象。     

光与原子纠缠存储寿命与磁场噪声关系的实验研究

在冷原子系综中,利用自发拉曼散射过程产生光与原子纠缠,测量了恢复效率随存储时间的关系。实验结果显示在没有施加轴向磁场时的存储寿命仅仅只有40μs。而在施加轴向磁场的情况下,存储时间在50μs以后甚至在400μs时都可以测量到明显的恢复信号,存储寿命明显高于100μs,远高于未施加轴向磁场时的情况。对这个实验现象进行分析认为:原子所处的环境中存在磁场噪声的影响,当没有轴向磁场时,噪声会扰乱自旋波信号的相位;当有轴向磁场时,磁场噪声对自旋波相位的影响便被抑制了。     

不同退火条件对PEALD制备的Ga2O3薄膜特性的影响

利用等离子增强原子层沉积技术(PEALD)在c面蓝宝石衬底上制备了氧化镓(Ga₂O₃)薄膜,研究了退火气氛(v(N₂)∶v(O₂)=1∶1(体积比)、空气和N₂)及退火时间对Ga₂O₃薄膜晶体结构、表面形貌和光学性质的影响。研究结果表明,退火前的氧化镓处于亚稳态,不同退火气氛下退火后晶体结构发生明显改变,而且退火气氛中N₂比例增加有利于Ga₂O₃重结晶。在N₂气氛下退火达到30 min,薄膜结构已由亚稳态转变成择优取向的β-Ga₂O₃。而且表面形貌分析表明,退火30 min后表面形貌开始趋于稳定,表面晶粒密度不再增加。另外实验样品在 400~800 nm的平均透射率几乎是100%,且光吸收边陡峭。采用N₂气氛退火,对于富氧环境下沉积的Ga₂O₃更利于薄膜表面原子迁移,以及择优取向Ga₂O₃重结晶。     

石墨烯负载的氧配位钴单原子稳定金属锂负极

Lithium (Li)-based batteries are the dominant energy source for consumer electronics, grid storage, and electrified transportation. However, the development of batteries based on graphite anodes is hindered by their limited energy density. With its ultrahigh theoretical capacity (3860 mAh∙g⁻¹), low redox potential (−3.04 V), and satisfactorily low density (0.54 g∙cm⁻³), Li metal is the most promising anode for next-generation high-energy-density batteries. Unfortunately, the limited cycling life and safety issues raised by dendrite growth, unstable solid electrolyte interphase, and "dead Li" have inhibited their practical use. An effective strategy is to develop a suitable lithiophilic matrix for regulating initial Li nucleation behavior and controlling subsequent Li growth. Herein, single-atom cobalt coordinated to oxygen sites on graphene (Co-O-G SA) is demonstrated as a Li plating substrate to efficiently regulate Li metal nucleation and growth. Owing to its dense and more uniform lithiophilic sites than single-atom cobalt coordinated to nitrogen sites on graphene (Co-N-G SA), high electronic conductivity, and high specific surface area (519 m²∙g⁻¹), Co-O-G SA could significantly reduce the local current density and promote the reversibility of Li plating and stripping. As a result, the Co-O-G SA based Li anodes exhibited a high Coulombic efficiency of 99.9% at a current density of 1 mA∙cm⁻² with a capacity of 1 mAh∙cm⁻², and excellent rate capability (high current density of 8 mA∙cm⁻²). Even at a high plating capacity of 6 mAh∙cm⁻², the Co-O-G SA electrode could stably cycle for an ultralong lifespan of 1300 h. In the symmetric battery, the Co-O-G SA based Li anode (Co-O-G SA/Li) possessed a stable voltage profile of 18 mV for 780 h at 1 mA∙cm⁻², and even at a high current density of 3 mA∙cm⁻², its overpotential maintained a small hysteresis of approximately 24 mV for > 550 h. Density functional theory calculations showed that the surface of Co-O-G SA had a stronger interaction with Li atoms with a larger binding energy, −3.1 eV, than that of Co-N-G SA (−2.5 eV), leading to a uniform distribution of metallic Li on the Co-O-G SA surface. More importantly, when matched with a sulfur cathode, the resulting Co-O-G SA/lithium sulfur full batteries exhibited a high capacity of 1002 mAh∙g⁻¹, improved kinetics with a small polarization of 191 mV, and an ultralow capacity decay rate of 0.036% per cycle for 1000 cycles at 0.5C (1C = 1675 mA∙g⁻¹) with a steady Coulombic efficiency of nearly 100%. Therefore, this work provides novel insights into the coordination environment of single atoms for the chemistry of Li metal anodes for high-energy-density batteries.     

石墨炉原子吸收光谱法测定明胶空心胶囊中铬的残留量

明胶空心胶囊样品经硝酸微波消解,采用石墨炉原子吸收光谱法测定其中铬的残留量。采用灰化温度为900℃,原子化温度为2 500℃。铬的质量浓度在2~30μg·L-1范围内与其吸光度呈线性关系,检出限(3s/k)为0.103mg·kg-1。应用此方法分析了明胶空心胶囊样品。用标准加入法进行回收试验,所得回收率在95.9%~102%之间,测定值的相对标准偏差(n=9)均小于2.0%。     

活性炭吸附-火焰原子吸收光谱法测定粗硒中的金

建立了活性炭吸附-火焰原子吸收光谱法测定粗硒中金量的分析方法。讨论了称样量、溶样条件和活性炭的灰化程度对金量测定的影响,并且对火焰原子吸收光谱法与火试金法测定粗硒中的金量做了比较。火焰原子吸收光谱法和火试金法测定的相对标准偏差分别为1.3%~5.9%和0.91%~7.8%;加标回收率分别为93.1%~100.7%和94.8%~102.2%。结果表明,方法有较好的精密度和准确度,并且具有较强的实用性。     

火试金-原子吸收光谱法测定锡阳极泥中金、银含量

锡阳极泥是锡冶炼过程中的一种中间产物,其中含有大量的金、银等贵金属。准确测定锡阳极泥中金、银含量有很重要的现实意义。采用火试金法能实现锡阳极泥中金、银含量的连续测定,方法准确度高,精密度好,金、银回收率在97.46%~101.66%,能很好地满足锡阳极泥中高品位金、银的测定。     

结合可见光促进氧化还原和镍催化的碳碳键合成进展

结合可见光促进氧化还原和镍催化的碳碳键合成研究,是对过渡金属催化的交叉偶联反应的重要补充,具有广阔的发展空间和应用前景,是近年来有机光化学合成的前沿热点领域之一。本文依据反应设计的模式划分,小结目前该领域的研究进展。