全文获取类型
收费全文 | 867篇 |
免费 | 216篇 |
国内免费 | 187篇 |
专业分类
化学 | 226篇 |
晶体学 | 38篇 |
力学 | 374篇 |
综合类 | 24篇 |
数学 | 68篇 |
物理学 | 540篇 |
出版年
2024年 | 7篇 |
2023年 | 33篇 |
2022年 | 29篇 |
2021年 | 31篇 |
2020年 | 25篇 |
2019年 | 37篇 |
2018年 | 19篇 |
2017年 | 25篇 |
2016年 | 30篇 |
2015年 | 40篇 |
2014年 | 79篇 |
2013年 | 55篇 |
2012年 | 56篇 |
2011年 | 46篇 |
2010年 | 50篇 |
2009年 | 55篇 |
2008年 | 90篇 |
2007年 | 53篇 |
2006年 | 59篇 |
2005年 | 44篇 |
2004年 | 63篇 |
2003年 | 58篇 |
2002年 | 32篇 |
2001年 | 35篇 |
2000年 | 35篇 |
1999年 | 27篇 |
1998年 | 21篇 |
1997年 | 26篇 |
1996年 | 21篇 |
1995年 | 14篇 |
1994年 | 20篇 |
1993年 | 9篇 |
1992年 | 13篇 |
1991年 | 4篇 |
1990年 | 10篇 |
1989年 | 5篇 |
1988年 | 5篇 |
1987年 | 5篇 |
1985年 | 1篇 |
1984年 | 1篇 |
1983年 | 2篇 |
排序方式: 共有1270条查询结果,搜索用时 203 毫秒
21.
掺Ti球磨NaH/Al复合物的微结构和储氢特性 总被引:1,自引:0,他引:1
本文采用机械球磨法制备了(NaH/Al)+x(摩尔分数, %)Ti(x=0, 4, 6, 10)复合物, 研究了不同球磨气氛和Ti催化剂含量对其微结构和储氢性能的影响, 使球磨(NaH/Al)体系储氢的容量达到质量分数为4.01%. 相似文献
22.
Yong Zhu Jin-lian Hu Kwok-wing Yeung Hao-jun Fan Ye-qiu 《高分子科学》2006,(2):173-186
SMPU (shape memory polyurethane) non-ionomers and ionomers, synthesized with poly(c-caprolactone) (PCL), 4, 4'-diphenylmethane diisocyanate (MDI), 1,4-butanediol (BDO), dimethylolpropionic acid (DMPA) were measured with cyclic tensile test and strain recovery test. The relations between the structure and shape memory effect of these two series were studied with respect to the ionic group content and the effect of neutralization. The resulting data indicate that, with the introduction of asymmetrical extender, the stress at 100% elongation is decreased for PU non-ionomer and ionomer series, especially lowered sharply for non-ionomer series; the fixation ratio of ionomer series is not affected obviously by the ionic group content; the total recovery ratio of ionomer series is decreased greatly. After sufficient relaxation time for samples stretched beforehand, the switching temperature is raised slightly, whereas the recovery ratio measured with strain recovery test method is lowered with increased DMPA content. The characterization with FT-IR, DSC, DMA elucidated that, the ordered hard domain of the two series is disrupted with the introduction of DMPA which causes more hard segments to dissolve in soft phase; ionic groups on hard segment enhance the cohesion between hard segments especially at high ionic group content and significantly facilitate the phase separation compared with the corresponding non-ionomer at moderate ionic group content. 相似文献
23.
24.
Mg-based hydrogen storage alloys Mg0.9Ti0.1-xZrxNi (x=0.02, 0.04, 0.06) were successfully prepared by means of mechanical alloying (MA). The effects of Zr addition on the discharge capacity and the cycle performance of the Mg-based electrodes were also studied. It was found that the discharge capacities were improved with addition of a small amount of Zr and the cycle performances of the alloy were stabilized with the addition of Ti. The effects of surface modification or coating on the properties of Mg0.9Ti0.06Zr0.04Ni were also studied. The results indicated that coating with graphite improved both the discharge capacity and cycle life of the amorphous Mg0.9Ti0.06Zr0.04Ni electrode. 相似文献
25.
用机械合金化法合成了Mg0.9Ti0.1Ni0.9X0.1(X=Mn,
Zn, Co, Fe)系列合金. X射线衍射(XRD)结构分析表明, 用X部分替代Ni后,
促进了Mg0.9Ti0.1Ni合金的非晶化过程. 用Co和Fe部分替代Ni提高了合金的放电容量,
但却降低了合金的循环稳定性. 用Zn和Mn部分替代Ni提高了合金电极的循环寿命,
尤其是Mg0.9Ti0.1Ni0.9Zn0.1合金电极经10个充放电循环后,
其放电容量仍可达到313.8 mA·h/g. 对添加Co后的合金进行p-c-T测试发现,
Mg0.9Ti0.1Ni0.9Co0.1合金的吸放氢容量明显比Mg0.9Ti0.1Ni合金高,
这与电化学所测到的结果一致. 相似文献
26.
聚乙烯醇硫酸钾水凝胶电机械化学行为研究 总被引:1,自引:0,他引:1
通过将交联聚乙烯醇硫酸酯化的方法制备了一种新型电刺激响应性聚乙烯醇硫酸钾(PVSK)智能水凝胶,并探讨了溶液离子强度和pH对PVSK水凝胶的溶胀吸水率、机械性能以及电机械化学行为的影响.结果表明,制备的PVSK水凝胶的平衡溶胀比随NaCl溶液离子强度的增大而减小,在pH2.39~10.83范围内基本不受溶液pH的影响;经不同离子强度和pH的NaCl溶液充分溶胀的PVSK水凝胶具有良好的机械性能,在非接触的直流电场作用下,该水凝胶向电场负极弯曲,凝胶的弯曲速度和弯曲偏转量随外加电场强度的增加而增大,随NaCl溶液离子强度的增大出现临界最大值,但不随溶液pH(2.08~10.53)的改变而改变;在循环电场作用下,PVSK水凝胶的电机械化学行为具有良好的可逆性. 相似文献
27.
28.
Fatigue damage behavior of a surface-mount electronic package under different cyclic applied loads 下载免费PDF全文
This paper studies and compares the effects of pull-pull and 3-point bending cyclic loadings on the mechanical fa- tigue damage behaviors of a solder joint in a surface-mount electronic package. The comparisons are based on experimental investigations using scanning electron microscopy (SEM) in-situ technology and nonlinear finite element modeling, respec- tively. The compared results indicate that there are different threshold levels of plastic strain for the initial damage of solder joints under two cyclic applied loads; meanwhile, fatigue crack initiation occurs at different locations, and the accumulation of equivalent plastic strain determines the trend and direction of fatigue crack propagation. In addition, simulation results of the fatigue damage process of solder joints considering a constitutive model of damage initiation criteria for ductile materials and damage evolution based on accumulating inelastic hysteresis energy are identical to the experimental results. The actual fatigue life of the solder joint is almost the same and demonstrates that the FE modeling used in this study can provide an accurate prediction of solder joint fatigue failure. 相似文献
29.
超导导体的力学性能是决定导体载流性能的重要影响因素之一,构成超导磁体的超导电缆在运行过程中受电磁力、热应力的作用,会导致其内部超导线产生应变,进而影响其载流性能和交流损耗,因此研究电磁循环载荷对超导电缆的影响有着重要的意义。对国际热核聚变实验堆中极向场线圈中Nb Ti超导导体进行机械压缩实验,并从形变量、弹性模量、弹性功等方面,对其机械强度进行分析。该方法可以在不进行电磁循环测试的情况下快速判断导体机械性能,为导体设计提供初步性能评判依据。结果显示,PF1-6NbTi超导导体相对于测试的其他PF导体在相同工况下,累积形变量与最大形变量更小。通过进一步对导体结构设计进行对比分析,发现低空隙率以及短节距绞线可以有效提高电缆机械性能。 相似文献
30.