基于近红外光电技术的脑水肿无创监测方法

提出了基于近红外光电技术的脑水肿无创监测方法,对大鼠脑水肿的程度进行无创监测.阐述了监测设备的测量原理和系统组成,并对大鼠实验数据结果进行了分析.监测系统光源选用760 nm和程序850 nm的双波长发光二极管,通过恒流源电路驱动进行驱动.选用OPT101作为检测器,用锁相放大电路和滤波电路对所测信号进行处理.在LabVIEW环境下通过数据采集卡进行数据采集,并进行后期处理,该系统能够实时测量大鼠脑组织的血氧变化.利用该系统测量脑水肿模型的大鼠,分析了光强、血氧参量的变化与脑水肿变化的关系.研究结果表明近红外光电技术可应用于对大鼠脑水肿程度进行无损监测.     

阻燃剂9,10-二氢-9-氧杂-10-膦杂菲-10-氧化物合成中酯化反应和酰基化反应的优化

有机磷杂环化合物9,10-二氢-9-氧杂-10-膦杂菲-10-氧化物(DOPO)因性能优异而作为无卤阻燃剂得到广泛应用。为了提升和改进DOPO的合成,不少文献对合成中的4个反应,即酯化反应、酰基化反应、水解反应和关环反应进行了大量研究,但是由于缺少合适的分析方法和仪器,对酯化反应和酰基化反应仍没有得出明确的结论。本文则采用了核磁共振磷谱以及测量反应产物HCl吸收碱液的温度变化两种方法,精确地得到了酯化反应和酰基化反应的优化条件。首先采用核磁共振磷谱,讨论了酯化反应温度、原料配比和加料方式对酯化反应产物组成的影响,得出了邻苯基苯氧基二氯化磷(CC)含量高的工艺条件:反应温度80℃,PCl3过量25%~50%,采用邻苯基苯酚(OPP)加入PCl3的反滴法;并得出酯化反应产物的组成直接决定了6-氯-(6氢)-二苯并-(c,e)-氧磷杂己环(CDOP)在酰基化反应产物中的含量。另通过测量HCl吸收碱液的温度变化,间接表征酰基化反应的反应速度,由此得出合适的酰基化反应温度和催化剂用量。结果为:当催化剂固定为0.2 g时,酰基化反应在150℃几乎不反应,随温度升高,反应变快,180℃下4 h完全,190℃下1.5 h即可完成;温度180℃下,1~1.5 g/1 mol OPP的催化剂较为合适,酰基化反应在3~4 h结束。     

房地产投资对绿色全要素生产率的影响——基于空间杜宾模型的实证研究

基于超效率SBM-GML指数模型测算中国绿色全要素生产率的地级市数据，运用空间杜宾模型分别从全国及东、中和西部实证分析房地产投资对城市绿色全要素生产率的空间效应。研究结果显示：(1)城市绿色全要素生产率存在空间溢出效应且表现显著，本地区绿色全要素生产率的提升会促进周边地区绿色全要素生产率；(2)在全国层面，房地产投资不仅对城市绿色全要素生产率的直接效应和间接效应都显著为负，而且对绿色全要素生产率分解出的绿色技术效率与绿色技术进步也存在反向抑制；(3)区域角度，房地产投资对绿色全要素生产率的抑制程度存在区域异质性，对东部地区的直接作用最大，西部最小，对中部地区的间接作用最大，西部最小。     

一种使用线阵型CCD实现高精度二维位置测量的方法

介绍了一种使用ＣＣＤ测量位置的方法。与其它ＣＣＤ位置测量系统不同，通过设计一个特殊的光学系统，实现了使用两个线阵型ＣＣＤ进行高精度二维位置坐标测量。文中对该光学系统进行了误差分析，证实该方法具有很高的测量精度。该二维位置测量方法具有一些突出的优点：系统响应速度快，可以对动态目标进行测量；测量精度高；制造成本低。上述特点使它在工业制造领域内有着广阔的应用前景。     

Growth of a Novel Periodic Structure of SiC/AIN Multilayers by Low Pressure Chemical Vapour Deposition

A novel lO-period SiC/A1N multilayered structure with a SiC cap layer is prepared by low pressure chemical vapour deposition （LPCVD）. The structure with total film thickness of about 1.45~m is deposited on a Si （111） substrate and shows good surface morphology with a smaller rms surface roughness of f.3 nm. According to the secondary ion mass spectroscopy results, good interface of the 10 period SiC/A1N structure and periodic changes of depth profiles of C, Si, A1, N components are obtained by controlling the growth procedure. The structure exhibits the peak reflectivity close to 30% near the wavelength of 322 nm. To the best of our knowledge, this is the first report of growth of the SiC/AIN periodic structure using the home-made LPCVD system.     

Photoluminescence of ZnO and Mn-Doped ZnO Polycrystalline Films Prepared by Plasma Enhanced Chemical Vapour Deposition

ZnO and Mn-doped ZnO polycrystalline films are prepared by plasma enhanced chemical vapour deposition at low temperature （220℃）, and room-temperature photoluminescence of the films is systematically investigated. Analysis from x-ray diffraction reveals that a11 the prepared films exhibit the wurtzite structure of ZnO, and Mndoping does not induce the second phase in the films. X-ray photoelectron spectroscopy confirms the existence of Mn^2＋ ions in the films rather than metalic Mn or Mn^4＋ ions. The emission efficiency of the ZnO film is found to be dependent strongly on the post-treatment and to degrade with increasing temperature either in air or in nitrogen ambient. However, the enhancement of near band edge （NBE） emission is observed after hydrogenation in ammonia plasma, companied with more defect-related emission. Furthermore, the position of NBE shifts towards to high-energy legion with increasing Mn-doped concentration due to Mn incorporation into ZnO lattice.     

CCD扫描法检测模具表面缺陷的研究

介绍了用由面阵 CCD组成的单列阵扫描法测量大型显像管玻壳模具的表面裂纹和砂眼等缺陷。同时还介绍了用软件对图像进行拼接的方法 ,以及采用分维数理论对灰度值进行分割等数据处理技术 ,并获得了较好的实验结果。由实验结果表明 ,该方法的分辨率达到了 0 .0 5 mm。     

Active control scheme for improving mass resolution of film bulk acoustic resonators

High mass resolution of sensors based on film bulk acoustic resonators (FBARs) is required for the detection of small molecules with the low concentration.An active control scheme is presented to improve the mass resolution of the FBAR sensors by adding a feedback voltage onto the driving voltage between two electrodes of the FBAR sensors. The feedback voltage is obtained by giving a constant gain and a constant phase shift to the current on the electrodes of the FBAR sensors. The acoustic energy produced by the feedback voltage partly compensates the acoustic energy loss due to the material damping and the acoustic scattering, and thus improves the quality factor and the mass resolution of the FBAR sensors. An explicit expression relating to the impedance and the frequency for an FBAR sensor with the active control is derived based on the continuum theory by neglecting the influence of the electrodes. Numerical simulations show that the impedance of the FBAR sensor strongly depends on the gain and the phase shift of the feedback voltage, and the mass resolution of the FBAR sensor can greatly be improved when the appropriate gain and the phase shift of the feedback voltage are used. The active control scheme also provides an effective solution to improve the resolution of the quartz crystal microbalance (QCM).     

玉米醇溶蛋白/十二烷基硫酸钠复合物对碳钢的缓蚀效应

通过失重法、扫描电镜和极化曲线法研究了玉米醇溶蛋白/十二烷基硫酸钠(zein/SDS)复合物对碳钢的缓蚀效应。在1mol/L盐酸溶液中,加入0.05‰zein对碳钢的缓蚀率为65.5%,而加入zein/SDS复合物(0.05‰zein+0～8mmol/L SDS)能够使碳钢的缓蚀率逐渐增高至90.1%。随着zein/SDS复合物中SDS浓度的增大,碳钢表面逐渐由深坑面腐蚀变为局部点腐蚀,最终趋于平整。极化曲线测试表明,zein/SDS复合物能够有效抑制碳钢表面电极反应的发生。纯zein与碳钢表面吸附的ΔG_(ads)值表明,zein在碳钢表面主要发生静电吸附作用,而zein/SDS复合物对碳钢的缓蚀效应主要来源于zein同碳钢表面之间的配位吸附作用,这是由于SDS类胶束之间的静电斥力引起zein空间构象的改变。     

Scx:Fey:Cuz:LN晶体的生长及非挥发性全息存储的研究

本文首次采用Czochralski法生长优质的Scx:Fey:Cuz:LN (x=0,1;, 2;, 3;, 3.5;, y=0.1;, z=0.06;)晶体.测试了晶体抗光致散射能力,以二波耦合光路测试晶体的衍射效率、写入时间和擦除时间,计算光折变灵敏度和动态范围.结果表明:Sc(2mol;):Fe:Cu:LN和Sc(3mol;):Fe:Cu:LN晶体抗光致散射能力比Fe:Cu:LN晶体高两个数量级以上,Scx:Fey:Cuz:LN晶体的写入速度、光折变灵敏度和动态范围等全息存储性能优于Fe:LN晶体.首次采用氪离子激光(482.0 nm,蓝光)作开关光,氦氖激光(632.8 nm,红光)做记录光,以Sc:Fe:Cu:LN晶体作为双光子全息存储记录介质,实现了双光子全息存储固定(非挥发性全息存储).