Control of self‐organized low‐dimensional morphology in poly(styrene‐b‐4vinylpyridine)/polystyrene blend thin films

The surface morphologies of poly(styrene‐b‐4vinylpyridine) (PS‐b‐P4VP) diblock copolymer and homopolystyrene (hPS) binary blend thin films were investigated by atomic force microscopy as a function of total volume fraction of PS (?_PS) in the mixture. It was found that when hPS was added into symmetric PS‐b‐P4VP diblock copolymers, the surface morphology of this diblock copolymer was changed to a certain degree. With ?_PS increasing at first, hPS was solubilized into the corresponding domains of block copolymer and formed cylinders. Moreover, the more solubilized the hPS, the more cylinders exist. However, when the limit was reached, excessive hPS tended to separate from the domains independently instead of solubilizing into the corresponding domains any longer, that is, a macrophase separation occurred. A model describing transitions of these morphologies with an increase in ?_PS is proposed. The effect of composition on the phase morphology of blend films when graphite is used as a substrate is also investigated. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 3496–3504, 2004     

密封容器中后处理制备Tl2Ba2CaCu2Oy高温超导薄膜及其性能研究

以铝酸镧（001）单晶为基片，采用两步法制备Tl2Ba2CaCu2Oy（Tl 2212）高 温超导薄膜.首先，利用脉冲激光沉积（PLD）工艺沉积Ba2CaCu2Ox非晶前驱体薄膜；然后，前驱体薄膜在高温（720—850℃）下密封钢容器里铊化结晶形成Tl 2212薄膜.XRD结果表明Tl2212 薄膜是沿c轴方向生长的，其相组成为Tl 2212，摇摆曲线（0012）的半高宽为0.72° ，SEM图像显示其表面光滑平整，其零电阻温度为106.2K. 关键词： Tl 2212超导薄膜 脉冲激光沉积     

薄膜外延生长的计算机模拟

以Cu膜为例，用Monte-Carlo算法模拟了薄膜生长的随机过程，并提出了更加完善的模型.在合理选择原子间相互作用计算方法的基础上，考虑了原子的吸附、在生长表面的迁移及迁移所引起的近邻原子连带效应、从生长表面的脱附等过程.模拟计算了薄膜的早期成核情况以及表面粗糙度和相对密度.结果表明，随着衬底温度的升高或入射率的降低，沉积在衬底上的原子逐步由离散型分布向聚集状态过渡形成一些岛核，并且逐步由二维岛核向三维岛核过渡.在一定的原子入射率下，存在三个优化温度，成核率最高时的最大成核温度Tn、薄膜的表面粗糙度最低 关键词： Monte-Carlo算法 计算机模拟 薄膜生长     

ΓD‐convergence for a class of quasilinear elliptic equations in thin structures

We study the asymptotic behaviour of the solution of a stationary quasilinear elliptic problem posed in a domain Ω^(ε) of asymptotically degenerating measure, i.e. meas Ω^(ε) → 0 as ε → 0, where ε is the parameter that characterizes the scale of the microstructure. We obtain the convergence of the solution and the homogenized model of the problem is constructed using the notion of convergence in domains of degenerating measure. Proofs are given using the method of local characteristics of the medium Ω^(ε) associated with our problem in a variational form. Copyright © 2005 John Wiley & Sons, Ltd.     

Influence of radiation on thin ZnS-Tb films

Changes in thin zinc-sulfide films under the action of the γ-radiation of Co⁶⁰ are studied by investigating electroluminescence spectra of terbium embedded in these films as a luminescent probe. It is shown that changes in the relation of the intensities of bands, a decrease in their halfwidth and the background component, and simplification of the spectrum are observed in a short-wave region of the Tb radiation spectrum that corresponds to⁵D₃→⁷F_j transitions. The same modification of the radiation spectrum is characteristic of ZnS films whose crystalline structure is ordered in the course of thermal annealing at a temperature of 350°C. Based on the analysis of the data obtained it is inferred that irradiating the ZnS films with small radiation doses of 10⁴–10⁵ rad leads to the ordering of their crystalline structure due to the elimination of one of the types of structural defects. Institute of Physics of Semiconductors, National Academy of Sciences of Ukraine, 45, Nauka Ave., Kiev-28, 252650. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 3, pp. 338–341, May–June, 1997.     

Outflow refreshment angiography: A bright blood, bright static tissue technique

A new “bright blood” strategy, outflow refreshment imaging, is introduced in which a number of overlapping slices are excited in rapid succession. Flowing spins that refresh each overlapped slice portion contribute a bright signal. Additionally, static tissue in each non-overlapped slice portion also yields a bright signal. However, the flow/static contrast is comparable to that produced in inflow refreshment images, and angiograms can be generated by conventional maximum intensity projection processing. The dual ability to visualize angiograms and static tissue images is a major benefit of the strategy. Computer simulations of flow sensitivities and in vivo results are presented which compare the outflow and inflow refreshment imaging strategies.     

Dynamic response of permalloy/Cu/Co magnetoresistive sandwiches

The dynamic response of trilayer magnetoresistive permalloy/Cu/Co films was studied by high-frequency permeability spectra measurements. The resonance frequency is shown to depend on the interlayer copper thickness. This dependence is related to exchange coupling between permalloy and cobalt and the interaction field is estimated using the Landau–Lifschitz–Gilbert model.     

过氧聚钨酸薄膜上光栅的制备

用过氧聚钨酸（PPTA）水溶液，通过离心涂膜法在显微镜载玻片上制备了具有光滑表面且厚度为100nm的PPTA薄膜，利用PPTA薄膜在紫外光照下可研制光栅以及其它光学元件的薄膜材料，具有很高的利用价值。     

A microprocessor based autoscanner for electromigration studies in thin films

Mass transport due to electromigration can be estimated if the diffusion coefficientD and the electromigration effective charge numberZ* are known. Neutron activated tracer scanning method determine the radioactivity at different positions. An automatic scanning system for determining the radioactive concentration profiles developed using a microprocessor is described in this paper. Using the radioactive concentration profiles the electromigration shift is determined. From this shift the electromigration effective charge numberZ* is calculated. The system developed was tested for tin thin films.