Dispersion Compensation in Externally Modulated Transmission System Using Chirped Fiber Grating

We present an externally modulated NTSC AM-VSB erbium-doped fiber amplifier (EDFA)-repeated system in the 1550 nm region which uses a chirped fiber grating (CFG) as a dispersion compensation device. In contrast to the conventional externally modulated fiber optical CATV systems, either with or without dispersion compensation fiber (DCF), good performances of carrier-to-noise ratio (CNR) ≥50 dB, composite second order (CSO) ≥74 dB, and composite triple beat (CTB) ≥65 dB were achieved for the full channel band after a 100-km single-mode fiber (SMF) transmission.     

宽带放大器用碲基掺铒光纤结构参量的设计考虑

利用光波导理论及均匀展宽四能级模型，研究了宽带放大器用阶跃型折射率分布碲基掺铒光纤的结构参量—纤芯半径和相对折射率差的设计考虑.理论研究表明，在单模传输条件下，为获取最大信号增益，宜选择相对折射率差大的碲基掺铒光纤来构建光纤放大器.相对折射率差一定的情况下，在高泵浦功率、小信号输入或光纤长度短于各信道最佳增益长度时，选择纤芯半径大的碲基掺铒光纤可以得到大的信号增益；反之，宜选择纤芯半径小的碲基掺铒光纤.     

光纤复合型油气井下压力温度测量系统

针对目前广泛使用的电子式油气井下压力温度测量系统可靠性低、高温环境漂移大的不足,设计了一种基于非本征型F-P干涉仪(EFPI)和光纤布喇格光栅(FBG)的复合型油气井下压力、温度测量系统,详细说明了其工作原理、传感器组成和信号解调方法,初步试验结果表明,该测量系统不仅克服了电子测量方式的不足,而且具有复用性好、测量精度高等优点.     

Bending loss measurement using a fiber cavity ringdown scheme

A novel sensitive technique for the determination of losses in fiber cavities is presented. The method is based on the cavity ringdown scheme implemented in silica-based single-mode fibers. Bending losses of fiber cavities of different lengths have been measured showing all an oscillating behavior with respect to the curvature radius of the fiber as predicted by a theoretical model. The best minimum detectable absorbance per cavity pass achieved by this new method is 1.72×10⁻³ dB within a 10 m-long cavity. This limit suffices well for an accurate determination of optical bending losses even in bend-insensitive fibers. Furthermore, the comparison of the measured bending losses with a theoretical model allows the extraction of different fiber parameters. Good agreement has been found between the experimentally derived parameters and literature data.     

Differential FBG sensor for temperature-compensated high-pressure (or displacement) measurement

A differential fiber Bragg grating (FBG) sensor with a free active element bulk-modulus for high-pressure (or displacement) measurement is presented. Based on the differential measurement method and an isosceles triangle cantilever structure, problems of cross-sensitivity and chirped signal in FBG sensor are improved both theoretically and experimentally. Preliminary experiments indicate that temperature-compensated measurement results agree well with the theoretical analysis. Displacement measurement sensitivity is 1.75 pm/μm, and the estimated pressure measurement resolution can reach 0.27 MPa in case the wavelength shift measurement resolution is 0.01 nm.     

Relative intensity noise of mode-locked fiber grating external cavity semiconductor lasers

The noise of hybrid soliton pulse source (HSPS) with linearly chirped Gaussian apodized fiber Bragg grating is analyzed by couple-mode equations including spontaneous emission noise when the HSPS is mode-locked. Relative intensity noise is calculated using numerical solutions of these equations. It is shown that transform limited pulses are generated over a wide tuning range around the fundamental mode-locking frequency with low spontaneous noise. However, a high noise level affects the operation of device, and therefore transform-limited pulses are not obtainable over a wide tuning range. It is also shown that noise is extremely sensitive to the RF and DC currents, linewidth enhancement factor, gain saturation parameter and spontaneous coupling factor.     

Analysis of a demodulation system for Fiber Bragg Grating sensors using two fixed filters

The analysis of a demodulation system for Fiber Bragg Grating sensors based on two fixed spectral filters has been carried out both theoretically and experimentally. Different system configurations were analyzed by modifying the spectral position of the filters as well as the optical power-level of the signal reaching the two photo-detectors. Measurements with integration times that varied from 0.01 to 1 s have been compared with the low-frequency limit predicted for long-term operation. Comparisons between simulated and experimental results show good agreement, and extrapolations indicate that it should be possible to achieve an operating spectrum range of the order of 7 nm, with uncertainties equivalent to less than 2 pm in measurements of the sensor peak position.     

光纤加速度传感器研究进展

光纤加速度传感器与传统加速度传感器相比，不但能抗电磁干扰，而且体小、质轻、动态范围宽、精度高、能在恶劣环境下工作，因此受到各先进国家军事与商业领域的极大重视，各种实用的光纤加速度传感器不断涌现。主要有光强调制型和相位调制型两大类。光强调制式有反射式、透射式和偏振式等等。相位调制式有Ｍａｃｈ－Ｚｅｎｄｅｒ干涉仪、Ｍｉｃｈｅｌｓｏｎ干涉仪和Ｆａｂｒｙ－Ｐｅｒｏｔ干涉仪。有一维的，也有二维的；有与水听器组合在一起的，也有与光纤陀螺仪组合的光纤加速度传感器。最小的已经做到２．５ｃｍ长，直径仅０．２５ｍｍ；测量精度已能达到１μｇ；共振频率可达到１０ｋＨｚ。为了克服温度不稳定性对测量精度的影响，人们采用了３×３耦合器解调法，双光路法，由单臂式改成推挽式等。一旦关键技术得以克服，光纤加速度传感器将会在惯性导航和其它领域发挥更重要的作用。本文将分别介绍目前各种类型光纤加速度传感器的结构、特点、走向实用化存在的问题。     

用超磁致伸缩调谐光纤光栅的光分/插复用器

提出并研究了一种新型多信道切换的全光分/插复用器,它主要由光纤Bragg光栅(FBG)和一对光环行器组成.采用了一种高效的超磁致伸缩材料(GMM)使FBG产生有效的Bragg波长偏移.用控制电流来调控FBG的应变和Bragg波长偏移.用4只相同的FBG与波长叠加技术相结合,可建立能提供15种不同下路信道方式的OADM.