基于波长调制技术对强水蒸气干扰下痕量氨气的测量研究

本文采用免标定波长调制光谱技术结合修正算法实现了电厂脱硝过程中高浓度水蒸气干扰下的痕量逃逸氨浓度测量。分析和讨论了背景对实验测量信号的影响,选择信背比较高的四次谐波用于NH_3浓度的反演,并进行了实验验证。对于烟气中高浓度水蒸气的干扰,利用了H_2O强吸收峰位置标定绝对波数及NH_3吸收峰位置,此外本文提出的修正算法结合免标定波长调制算法可以同时实现H_2O和NH3浓度的准确反演,并通过实验验证了算法的正确性。最后将该修正方法应用于电厂逃逸氨浓度测量并获得了较为可靠的结果.     

采用改进PI迟滞模型的压电微夹钳前馈控制

为减小压电微定位平台的迟滞误差, 设计前馈控制器对其进行控制. 首先在使所建平台迟滞模型精度达到要求并使各阈值点精度相同的情况下, 对平台迟滞模型的阈值进行优化, 得到满足模型精度要求的最小算子数, 进而建立了平台的PI(Prandtl-Ishilinskii)迟滞模型通过对所建迟滞模型求逆, 设计出平台的前馈控制器; 最后在所设计的前馈控制作用下, 使平台达到5μm理想阶跃值的响应时间为0.01s稳态误差中线的变化范围为0.40~0.50μm 当期望平台输出最大值为17μm变幅值三角波位移时, 实测位移相对于理想位移的误差中线变动范围为1.15~ -0.05μm. 所设计前馈控制器可有效减小压电微定位平台的迟滞误差.     

超临界压力煤油传热不稳定实验研究

在压力2.5~4 MPa, 质量流量0.7~1.7g/s, 入口温度20~250 ℃的实验条件下, 对煤油在内径1 mm, 长度300 mm竖直上升圆管中的流动及传热不稳定现象进行了实验研究.结果表明, 当热流密度增大到一定程度后, 传热不稳定开始发生.不稳定发生的起始热流密度随压力和流量的增加而增大, 随入口油温的升高而减小, 且当入口油温升高到一定程度后无不稳定现象发生.不稳定发生的初始时刻, 出口油温迅速增加, 管道壁温明显下降, 传热系数增大; 实验段局部流速增大, 进而在管道内部形成压力脉动并产生声音.不稳定结束后, 出口油温几乎保持不变, 壁温会缓慢增加, 直至下一次不稳定发生.      

热屏结构对泡生法蓝宝石单晶炉功率影响研究

蓝宝石晶体因优异的综合性能被广泛用于航空航天等高性能要求领域.泡生法是目前生产大直径蓝宝石单晶的主要方法,热场对生产工艺、产品质量和单晶炉功率具有重要影响;并将影响生产成本.本文对氧化锆及钼金属组合式热屏中氧化锆材料内置、外置及材料不同组合方式对泡生法蓝宝石单晶炉功率的影响进行研究,得到合理的热场结构;并与实际生产结果进行验证.结果表明:相比于传统的15层钼保温结构,加入氧化锆保温层会明显降低单晶炉能耗,其中氧化锆内置的热场结构对单晶炉能耗降低影响更为明显;随着氧化锆层由0增加至15层,单晶炉能耗显著降低,相比传统15层钼保温结构,15层氧化锆保温结构炉体功率降低了38;.     

力平衡法测量大气压强

依据力平衡法原理,重新构思、设计了测量大气压强的实验方案及装置,力学传感器的使用,提高了大气压强测量中的关键物理量的测量精度;采用最小二乘法,实现了大气压强的巧妙测量.     

Synchronization of the fractional-order generalized augmented L u¨system and its circuit implementation

In this paper, the synchronization of the fractional-order generalized augmented Lu¨ system is investigated. Based on the predictor–corrector method, we obtain phase portraits, bifurcation diagrams, Lyapunov exponent spectra, and Poincare′maps of the fractional-order system and find that a four-wing chaotic attractor exists in the system when the system parameters change within certain ranges. Further, by varying the system parameters, rich dynamical behaviors occur in the2.7-order system. According to the stability theory of a fractional-order linear system, and adopting the linearization by feedback method, we have designed a nonlinear feedback controller in our theoretical analysis to implement the synchronization of the drive system with the response system. In addition, the synchronization is also shown by an electronic circuit implementation for the 2.7-order system. The obtained experiment results accord with the theoretical analyses,which further demonstrate the feasibility and effectiveness of the proposed synchronization scheme.     

Finite-time sliding mode synchronization of chaotic systems

A new finite-time sliding mode control approach is presented for synchronizing two different topological structure chaotic systems. With the help of the Lyapunov method, the convergence property of the proposed control strategy is discussed in a rigorous manner. Furthermore, it is mathematically proved that our control strategy has a faster convergence speed than the conventional finite-time sliding mode control scheme. In addition, the proposed control strategy can ensure the finite-time synchronization between the master and the slave chaotic systems under internal uncertainties and external disturbances. Simulation results are provided to show the speediness and robustness of the proposed scheme. It is worth noticing that the proposed control scheme is applicable for secure communications.     

空间用GaN功率器件单粒子烧毁效应激光定量模拟技术研究

利用飞秒脉冲激光对氮化镓(GaN)功率器件进行单粒子烧毁效应定量评估技术研究,针对器件结构建立脉冲激光有效能量传输模型,理论计算了激光有效能量与重离子线性能量传输(LET)的等效关系并开展了试验验证.考虑器件材料反射率与吸收系数对激光的影响,针对介质层界面间的激光多次反射进行参数修正,减小有源区有效能量计算误差.选择一款氮化镓高电子迁移率晶体管(GaN HEMT)与一款肖特基势垒二极管(SBD)功率器件作为典型案例,分别开展飞秒脉冲激光正面与背部辐照试验,计算诱发单粒子烧毁的有效能量,并得到不同入射激光波长的烧毁等效LET阈值,对比了模型理论计算值与实际测量值.同时,研究结果对材料参数未知的GaN功率器件,提供了正面与背部辐照模型的激光试验波长选择参考.该工作将为激光定量评估空间用GaN等宽禁带半导体器件的单粒子烧毁效应机理研究及加固设计与验证提供技术支撑.     

High-sensitivity Bloch surface wave sensor with Fano resonance in grating-coupled multilayer structures

A new type of device consisting of a lithium niobate film coupled with a distributed Bragg reflector (DBR) was theoretically proposed to explore and release Bloch surface waves for applications in sensing and detection. The film and grating made of lithium niobate (LiNbO₃) were placed on both sides of the DBR and a concentrated electromagnetic field was formed at the film layer. By adjusting the spatial incidence angle of the incident light, two detection and analysis modes were obtained, including surface diffraction detection and guided Bloch detection. Surface diffraction detection was used to detect the gas molecule concentrations, while guided Bloch detection was applied for the concentration detection of biomolecule-modulated biological solutions. According to the drift of the Fano curve, the average sensor sensitivities from the analysis of the two modes were 1560 °/RIU and 1161 °/RIU, and the maximum detection sensitivity reached 2320 °/RIU and 2200 °/RIU, respectively. This study revealed the potential application of LiNbO₃ as a tunable material when combined with DBR to construct a new type of biosensor, which offered broad application prospects in Bloch surface wave biosensors.     

自适应模拟退火遗传算法在薄膜厚度及光学常数反演中的应用

准确的测量薄膜的厚度和光学常数,在薄膜的制备、研究和应用中都是十分重要的。借助Cauchy色散模型,通过薄膜透过率测量曲线,用改进的自适应模拟退火遗传算法对透过率曲线进行全光谱拟合,从而反演得到薄膜的厚度和光学常数。对由电子束蒸发制备的TiO2单层膜和SiO2/TiO2双层膜的厚度和光学常数进行了测量计算。实验结果表明,计算得到的光学参数与实测结果相一致,厚度误差小于2nm,在560nm波长处折射率误差小于0.03。